Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 12 of 12 for “"conical tip"”.
-
Ensaios contínuos de penetração de cone na argila cinza mole do Rio de Janeiro
… the Cone Penetration Test, the various types of conical tips used around the world, the applications of the test and the way its results can be analysed, providing geotechnical parameters of cohesive soils for design criteria. Following chapters deal with the test equipment used in the cone …
-
Polydimethylsiloxane Mechanical Properties Measured by Macroscopic Compression and Nanoindentation Techniques
… force tests with different nanoindentation tips, which are Berkovich tip, conical tip and cube corner tip, show that PDMS's adhesion force is related to the sample's base/agent ratio, the nanoindentating depth and the tip's geometrical shape.
-
Novel Nanoindentation-Based Techniques for MEMS and Microfluidics Applications
… become important at the device level, and the conical tip always makes a crack at the edge of the sliders, thus the slider design needs to be optimized to account for the probe geometry. In chapter 4, the measurement of electrowetting has been outlined. The "airscratch" mode was used to capture …
-
Design and Calibration of Seven Hole Probes for Flow Measurement
… and use of these probes. The influence of tip shape, Reynolds number, calibration grid density, and curve fit were studied and reported. Calibration was done using the well established polynomial curve fit method of Gallington. An improvement to this method was proposed that improved the …
-
Factors affecting the interpretation and analysis of full-displacement pressuremeter tests in sands
… is installed in the soil by pushing it behind a conical tip. Earlier work had indicated that the unload-reload modulus measured with the FDPM was very similar to that obtained from self-boring pressuremeter (SBPM) testing. It had also been suggested that if the pressuremeter was capable of …
-
A quantitative analysis of multi-scale response of CMP pad: quasi-static and dynamic characterization of dry and wet pad
… length scales using a nano-indenter with a conical tip of 1[mu]m radius and a flat-punch of 30[mu]m radius. The wet pad measurements showed degradation of the pad stiffness, which is attributed to water absorption within a micron of pad cell membrane. This reduction of stiffness is not …
-
Comprehensive Modeling and Numerical Investigation of Entrained-Flow Coal Gasifiers
… heat transfer on fuel injectors shows that blunt tip fuel injector is less likely to fail compared to conical tip fuel injector because the maximum high temperature on the injector is scattered. Two concentric fuel/oxidant injections provide better fuel-oxidant mixing and higher syngas heating …
-
Quantitative evaluation of thin film adhesion using the probe test
… method, an inclined needle-like probe with a conical tip is advanced underneath the free edge of a thin polymeric coating bonded to a substrate, causing the edge to lift-up from the surface of the substrate. A debond is thus initiated at the loading point and propagates as a semi-circular …
-
Microscopic wear of polymers : microscratching simulations of asperity-surface interactions and debris generation
… with both, silicon cubic corner and sapphire conical microscratching tips. In addition, in order to represent the varied motion of such a asperity over a polymer surface, different microscratching patterns are designed. In particular, the effects of the tip geometry and its directional change …
-
Fundamental aspects of the ionization mechanisms in fast atom bombardment : liquid secondary ion, electrospray, and electrohydrodynamic mass spectrometry
… fused.silica capillary with mechanically shaped conical tip. The tip chemically treated with a mercaptan reagent to improve the adhesion of a vapor deposited gold layer. These capillaries were shown to withstand over 100 hours of operation, spray a variety of highly conductive aqueous and non …
-
Microaspiration: Development & Applications - A Tool to Study the Mechanical Properties of Soft Particles
… draw a soft microparticle into and through the conical tip of a micropipette, a process known as aspiration. Optical microscopy images are captured during microaspiration, as in the previously established micropipette aspiration (MA) technique. However, unlike MA, when using microaspiration an …
-
Effects of Thickness and Indenter Tip Geometry in Nanoindentation of Nickel Films
… different indenters (Berkovich, cubecorner, and conical). X-ray diffraction (XRD), transmission electron microscope (TEM), scanning electron microscopy (SEM), and atomic force microscopy (AFM) analysis were performed on these materials to determine the crystal orientation, grain size of the …