Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 37 for “"corrosion study"”.
-
Corrosion Study of Silver Nanowires
… material’s viability as a method of passivating corrosion in the silver nanowire electrodes. It was observed that the organic passivation material was ineffective as a method of preventing corrosion in silver nanowires. In fact, the use of this organic material appears to have caused corrosion to …
-
CORROSION STUDY IN CRUDE OIL PIPELINES
… gas industry has a severe problem with chemical corrosion and microbial contamination of pipelines and infrastructure. The main source of the chemical corrosion is the water that used in digging the crude oil from the ground. It is estimated that the water content in the extracted oil can reach …
-
A corrosion study in a cement production plant
… more than 80 years. Thus the main aims of the study were:1. To determine the corrosive agents and mechanism of corrosion involved in the plant.2. To determine why the B side had suffered more severe corrosion than the A side.3. To find process measures, different materials and coatings that …
-
A corrosion study in a cement production plant /
… more than 80 years. Thus the main aims of the study were:1. To determine the corrosive agents and mechanism of corrosion involved in the plant.2. To determine why the B side had suffered more severe corrosion than the A side.3. To find process measures, different materials and coatings that …
-
Corrosion study of iron using piperazine derivatives as inhibitors
The corrosion of iron by HC1 using cyclic polyethyleneimines as inhibitors has been done many times. Piperidine, a cyclic six membered ring CH.NH has attracted the most attention as an inhibitor because of the high basicity and lack of strain on the bonds in the ring. Piperazine, a cyclic six …
-
CORROSION STUDY OF SOLID AND POROUS TITANIUM FOR SURGICAL IMPLANT APPLICATIONS
… are inherent defects that will decrease the corrosion resistance. This thesis focuses on the comprehensive in-vitro study of solid and porous titanium using open-circuit potential (OCP) measurements, potentiodynamic measurements, electrochemical impedance spectroscopy (EIS) and capacitance …
-
An In Vitro Electrochemical Corrosion Study of Coupled Surgical Implant Materials.
The use of surgical implants in the human body is common and increasing in frequency. The materials used in biological applications vary widely according to the specific conditions of use. In cases requiring high strength, resistance to fatigue and wear, the chosen material is often a metallic …
-
A Corrosion Study of the Dealuminification of Copper Aluminium Iron Alloys
… which, often with no serious diminution of corrosion resistance, add to its properties a strength comparable with some steels. This is particularly true of the aluminum bronzes which are perhaps the strongest of the bronzes with tensile strengths and ductility comparable to mild steels. The …
-
High-temperature corrosion study of alloys in molten MgCl₂-KCl eutectic salt
… properties. This research investigates the corrosion behavior and protection strategies of Haynes 230 (H230), Incoloy 800H (800H), and Stainless Steel 316 (SS316) in MgCl₂-KCl molten salt at high temperature. First of all, the corrosion rates of different alloys are determined by performing …
-
Electrodeposition and corrosion study of nanocrystalline cobalt and cobalt-iron alloy coatings
… counterparts. However, investigation on the corrosion resistance of these materials is still lacking. In order to further expand their future applications, their corrosion behaviour is of great importance. Hence, in this study, nanocrystalline Co and CoFe alloy coatings were prepared through …
-
Corrosion study of electrodeposited W and Mo alloys with iron group metals /
This work is focused on the determining of corrosion and tribocorrosion properties of W and Mo alloys with Fe, Ni and Co. Also, the peculiarities of corrosion behavior of pure iron group metals are discussed. The electrodes made of corresponding metals wires served as substrate for …
-
A vibration analysis of a bearing/cartridge interface for a fretting corrosion study
… the important parameters influencing fretting corrosion in rolling element bearings. The bearing examined was a 320 size, deep grooved, ABEC 7 ball bearing used in a Navy ship service motor-generator unit. Three axes of acceleration signatures were simultaneously recorded from the outer race …
-
Steam Condensate Corrosion Study of Return Line Deterioration at South Dakota State College Power Plant
… and analyze the type, rate, and causes of corrosion in the South Dakota State college steam power plant condensate lines. Since corrosion at this power plant requires an excessive amount of money for labor and pipe replacement, an investigation leading to reduction in corrosion would …
-
Kinetic Property and SS 316/Alloy 617 Corrosion Study in Molten Chloride and Fluoride Salts
This study focused on the kinetic data measurements, such as diffusion coefficient D and exchange current density i_0 of the electrochemical reactions of corrosion products (Fe, Cr and Ni ions) and corrosive species (OH-), and corrosion studies of structural materials (SS 316H and Alloy 617), …
-
A Corrosion Study on a Novel FeCrAl Alloy for Water Wall Applications in Waste-Fired Boilers
… originating from the waste. This accelerates the corrosion rate of the water wall materials. The material is usually of low-alloyed steel and a method for increasing the corrosion resistance is to put a layer of Ni-based alloy on top of the material, a so called coating. However, because of the …
-
Effects of hydrodynamic variables on corrosion : study of 90/10 Cu-Ni in a circling foil with synthetic seawater
… hydrodynamic variables and fluid properties on corrosion of 90/10 Cu-Ni (CDA 706) in single metal exposures and in galvanic couples with platinum were studied in synthetic seawater. An apparatus utilizing circling foil as the specimen holder was redesigned as an experimental apparatus for this …
-
Effects of hydrodynamic variables on corrosion: study of 90/10 cu-ni in a flow channel with natural sea water.
The effects of hydrodynamic variables on the corrosion rate of 90/10 Cu-Ni were studied in sea water pumped from Monterey Bay. A one centimeter square flow channel was built providing a maximum flow velocity of 7.8 m/sec. The flow field was examined using hot film anemometry in an attempt to …
-
Hydrogen cracking and stress corrosion of pressure vessel steel ASTM A543
… pressure vessel. The results of this research study will be used to identify safe welding procedure and design more weldable material. A standardized weldability test known as implant test was constructed and used to study the susceptibility of the Q&T HSLA steel to hydrogen cracking. The …
-
A study of corrosion-related defects in aluminum, iron and nickel using positron annihilation spectroscopy
… annihilation spectroscopy is currently used in studying open volume defects, very little work has been done using positron annihilation experiments in the study of corrosion processes. Only one prior corrosion study using positrons has been done, in which open-volume defects were detected in an …
-
The role of applied potentials on cracking of Zircaloy-2
… when tested under an anodic Econt. The localized corrosion study using cyclic polarization indicates that the critical potentials became more active with increasing temperature. Secondary cracks were noted in a specimen tested under an anodic Econt, as determined by optical microscopy. The primary …
Page 1 of 2