Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 117 for “"detectivity"”.

  1. Detectivity vs. Sensitivity: Non-Hermitian Metasurface Sensor

    Detectivity is the most important performance metric of any sensor. Detectivity is limited by the sensitivity of a sensor when the probe significantly overwhelms the detector noise. But, when the probe is limited in its power budget, as in sensors on mobile platforms, high sensitivity does not …

    rice Repository record for Detectivity vs. Sensitivity: Non-Hermitian Metasurface Sensor (opens in a new tab)

  2. Low Noise, High Detectivity Photodetectors based on Organic Materials

    … cross-linked TPD (C-TPD) buffer layer. The high detectivity of 3.6 × 1011 cm Hz½ W−1 (Jones) at 370 nm and the wide Linear dynamic range (LDR) of 90 dB, along with a response speed faster than 20 kHz, suggests that the fullerene-based organic photodetectors proposed here can open the way for many …

    nebraska Repository record for Low Noise, High Detectivity Photodetectors based on Organic Materials (opens in a new tab)

  3. Spectrally selective high detectivity uncooled detectors for the long wave infrared

    Long wave infrared is an important region of the electromagnetic spectrum due to strong thermal emission in this region by room temperature blackbodies and good atmospheric transparency which enables transmission of electromagnetic energy over large distances. Detectors for this spectral region, …

    umn Repository record for Spectrally selective high detectivity uncooled detectors for the long wave infrared (opens in a new tab)

  4. Increased Detectivity and Low Temperature Performance Analysis of Sub-20μm Micropixel Array A1GaN UV Photodiodes

    … two sections. At first, we demonstrate ~1.5x detectivity increase in AlGaN photodiodes on sapphire using distributed micropixel arrays with 5-15 µm pixel diameter. This is due to the ~10x larger chip footprint of the 5um diameter micropixel arrays compared to planar control structures with …

    south-carolina Repository record for Increased Detectivity and Low Temperature Performance Analysis of Sub-20μm Micropixel Array A1GaN UV Photodiodes (opens in a new tab)

  5. Theoretical Modeling for Detectivity and Resolution Comparison of Single Aperture and Multiple Aperture Optical Imaging Systems

    The detectivity and resolution of single aperture and multiple aperture optical imaging systems are compared for single point sources in optically background limited environments. The single aperture system assumes a single large diameter lens with a detector array at the focal plane. The multiple …

    ucf Repository record for Theoretical Modeling for Detectivity and Resolution Comparison of Single Aperture and Multiple Aperture Optical Imaging Systems (opens in a new tab)

  6. Non-Hermitian Plasmonic-Photonic Hybrids: Advancing Sensing and Photocatalysis for Real-World Applications

    … however, they frequently exhibit poor detectivity owing to their acute susceptibility to perturbations including noise. In scenarios where the optical budget is constrained, such as mobile platform applications, high detectivity can be as critical as high sensitivity. In such instances, …

    rice Repository record for Non-Hermitian Plasmonic-Photonic Hybrids: Advancing Sensing and Photocatalysis for Real-World Applications (opens in a new tab)

  7. Indium Phosphide Based Indium Arsenide Quantum Dot Infrared Photodetectors

    … shows a peak responsivity of 113 mA/W and a detectivity of 1.8 x 10 9 cmHz1/2/W at 10 K for a 10-period QD heterostructure. The device based on bound-to-continuum transitions demonstrates an improved dark current characteristics and a better detectivity of 2.1 x 10 9 cmHz1/2/W.

    uiuc Repository record for Indium Phosphide Based Indium Arsenide Quantum Dot Infrared Photodetectors (opens in a new tab)

  8. Noise characteristics of an avalanche photodiode

    … responsivity, noise equivalent power, specific detectivity, shot noise and multiplication noise of a RCA C30872 silicon reach-through avalanche photodiode were studied at 4 wavelengths 563.8 nm, 569.9 nm, 699.6 nm, and 826.2 nm. The detector noise was resolved into amplifier, shot and a …

    nps Repository record for Noise characteristics of an avalanche photodiode (opens in a new tab)

  9. NANOSCALE MAGNETIC FIELD SENSING WITH SPIN-HALL NANO-OSCILLATOR DEVICES

    … However, the quantification of the sensor detectivity in such devices is still lacking. In this dissertation, we develop nanoscale magnetic field sensors based on a similar kind of magnetic nano-oscillators, spin-Hall nano-oscillator (SHNO) devices. We fabricate nanoconstriction-based SHNO …

    cornell Repository record for NANOSCALE MAGNETIC FIELD SENSING WITH SPIN-HALL NANO-OSCILLATOR DEVICES (opens in a new tab)

  10. Low Energy Photon Detection

    … such as MCT detectors, excel in terms of high detectivity and fast response times. However, their reliance on cryogenic cooling significantly escalates their cost and restricts their practical applications. In contrast, uncooled detectors, exemplified by microbolometers, are capable of …

    ucf Repository record for Low Energy Photon Detection (opens in a new tab)

  11. Study for the performance parameters of a FLIR system

    The performance parameters of Detectivity and Noise Equivalent Temperature Difference for a Forward Looking Infra-Red (FLIR) system were measured after optimization of the system. The achieved performance approached the theoretically evaluated limiting values.

    nps Repository record for Study for the performance parameters of a FLIR system (opens in a new tab)

  12. Near infra-red photon emission microscopy and spectroscopy

    … A measurement technique to measure the spectral detectivity of Photon Emission Microscope (PEM) is developed. It is used to measure and compare the spectral detectivity of different PEMs against an absolute scale.

    nus Repository record for Near infra-red photon emission microscopy and spectroscopy (opens in a new tab) Download file for Near infra-red photon emission microscopy and spectroscopy (opens in a new tab)

  13. Indium-Gallium-Arsenide Quantum Wire Infrared Photodetectors

    … a detection wavelength of 8.4 mum and a peak detectivity of 8.97 x 109 cmHz1/2/W at 10 K under a normal-incident scheme. This device displayed characteristics of low dark current and a correspondingly low responsivity. Another QRIP device with 10 SPS pairs demonstrated three photocarrier …

    uiuc Repository record for Indium-Gallium-Arsenide Quantum Wire Infrared Photodetectors (opens in a new tab)

  14. Design and fabrication of state of the art uncooled thermopile infrared detectors with cavity coupled absorption

    … thermal time constant of 58 ms, and specific detectivity of at least 3.0x10<super>9<\super> cmHz<super>1/2</super>/W. Also presented are a theoretical proposal for a midwave infrared detector using semiconductor selective absorption to enhance detectivity beyond the blackbody radiation limit …

    umn Repository record for Design and fabrication of state of the art uncooled thermopile infrared detectors with cavity coupled absorption (opens in a new tab)

  15. High-Performance Ultraviolet Photodetectors Based on Transition Metal Boride and Carbide Heterostructures on Silicon Carbide Substrates

    … significantly improved photoresponse, with detectivity values on the order of 108 Jones and responsivity values ranging from the µA/W regime to above 3 A/W under 405 nm illumination. The developed devices also demonstrated temporal responses spanning nanosecond to microsecond timescale …

    unsw Repository record for High-Performance Ultraviolet Photodetectors Based on Transition Metal Boride and Carbide Heterostructures on Silicon Carbide Substrates (opens in a new tab)

  16. Antimony-based type-II superlattice infrared detectors

    … spectrum and response, as well as the overall detectivity in combination with electrical characterization. Temperature dependent electrical characterization was used to extract information about the limiting dark current processes. This work resulted in the first demonstration of an InAs/GaSb …

    uiuc Repository record for Antimony-based type-II superlattice infrared detectors (opens in a new tab)

  17. Characterization and applications of wide bandgap semiconductor materials

    … yield lower Ion/Ioff ratio, responsivity and detectivity. In this work, a device with improved photocurrent to dark current contrast ratio, photoresponsivity and detectivity has been developed. The second project comprises of GaN wafers which were doped in a high-quality manner by a neutron …

    missouri Repository record for Characterization and applications of wide bandgap semiconductor materials (opens in a new tab)

  18. MULTIPLE-STAGE INTERBAND CASCADE PHOTOVOLTAIC DEVICES USING 6.1 Å SEMICONDUCTOR MATERIALS

    … offers the potential for significant detectivity improvement when αLn ≤ 0.2. We also explore the potential of multiple-stage detectors with photocurrent-matched absorbers. In this architecture, the absorbers are designed to absorb and collect an equal number of carriers in each stage. …

    oklahoma-thes Repository record for MULTIPLE-STAGE INTERBAND CASCADE PHOTOVOLTAIC DEVICES USING 6.1 Å SEMICONDUCTOR MATERIALS (opens in a new tab)

  19. Fabrication and Characterization of Photodetector Devices Based on Nanostructured Materials: Graphene and Colloidal Nanocrystals

    … operated and achieved high responsivity and detectivity on the order of 2.7 × 104 A/W and 5 × 1012 cm·Hz0.5/W, respectively. A ratio of 29 between the photocurrent and the dark current was obtained. The device showed an excellent tunable photo response as a function of the applied back-gate …

    arkansas Repository record for Fabrication and Characterization of Photodetector Devices Based on Nanostructured Materials: Graphene and Colloidal Nanocrystals (opens in a new tab)

  20. Dielectric Grating Integrated Hg1-xCdxTe (Mercury Cadmium Telluride) Infrared Photodetectors for High Operating Temperature

    … from ~1.4 A/W to ~3.8–5 A/W (λ 10–12 µm) and detectivity from ~8.4×10⁸ to ~4.2×10⁹ cm√Hz/W at 10.9 µm, transforming the spectral roll-off into a steeper decline. A fabrication process for gratings on thin Hg0.7Cd0.3Te is developed that limits thermal and structural degradation, and FTIR …

    vcu Repository record for Dielectric Grating Integrated Hg1-xCdxTe (Mercury Cadmium Telluride) Infrared Photodetectors for High Operating Temperature (opens in a new tab)

Page 1 of 6