Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 22 for “"dilation angle"”.

  1. Improving Continuum Models for Excavations in Rockmasses Under High Stress Through an Enhanced Understanding of Post-Yield Dilatancy

    … deformation is dominated by crack extension and dilation, the post-yield evolution of dilatancy in parallel with strength parameters can have a very significant impact on progressive failure processes. By improving our understanding of this evolution, continuum models for brittle rock can be …

    queens Repository record for Improving Continuum Models for Excavations in Rockmasses Under High Stress Through an Enhanced Understanding of Post-Yield Dilatancy (opens in a new tab)

  2. A Study of Passive Earth Pressure in Anisotropic Sand with Various Wall Movement Modes

    … each other except for some combinations of zero dilation, low wall friction, and high angle of internal friction ϕ. Dilation angle has less effect on Kp than the effect of ϕ. Dilation angle of a half of ϕ could be used without significant effects on Kp. When comparing simulations with anisotropic …

    odu Repository record for A Study of Passive Earth Pressure in Anisotropic Sand with Various Wall Movement Modes (opens in a new tab)

  3. Pull-out behaviour of steel grid soil reinforcement in silty sand

    … factor is only the function of soil friction angle but, it is not clarified whether the value of the friction angle should be taken as the peak value or the value at the critical state. Some of the published literature suggests that bearing resistance factor deduced from test results depends …

    unsw Repository record for Pull-out behaviour of steel grid soil reinforcement in silty sand (opens in a new tab)

  4. Identification of productive zones in unconventional reservoirs

    … techniques. We used the concept of shear dilation angle to describe increase in conductivity in response to sliding. The dilation angle can be correlated to the joint compressive strength of the rock which is equal to the unconfined compressive strength for an unaltered rock. Unconfined …

    texas Repository record for Identification of productive zones in unconventional reservoirs (opens in a new tab)

  5. Rockfall modeling in jointed rock for underground openings with consideration of seismic and thermal effect

    … has minimal impact on rockfall except the joint dilation angle. The sensitivity analyses show that only half of the rockfall volume is predicted with dilation angle increased to 11° comparing with the base case assuming no dilation. The impact on drift stability due to the effect of rock joint …

    unlv Repository record for Rockfall modeling in jointed rock for underground openings with consideration of seismic and thermal effect (opens in a new tab) Download PDF for Rockfall modeling in jointed rock for underground openings with consideration of seismic and thermal effect (opens in a new tab)

  6. A non-linear dynamic macroelement for soil structure interaction analyses of piles in liquefiable sites

    … conductivity, loading rate of dynamic loading, dilation angle and liquefaction potential are then expressed in dimensionless form. Next, the macroelement parameters are calibrated as a function of the soil properties and the effective stress. A semi-empirical approach that accounts for the …

    gatech Repository record for A non-linear dynamic macroelement for soil structure interaction analyses of piles in liquefiable sites (opens in a new tab)

  7. Capacity of Reinforced Concrete Beams with Insufficient Shear Detailing

    … parametric studies allow the selection of the dilation angle and the viscosity parameter. A comparison of the finite element model results with test results indicates that the models can successfully capture the load-vs.-displacement curves, as well as the failure patterns. The model is then …

    buffalo Repository record for Capacity of Reinforced Concrete Beams with Insufficient Shear Detailing (opens in a new tab)

  8. Experimentally based mechanical model of sandwich pipes with a strain-hardening cementitious composite core

    … tests. For the plastic flow rule, the dilation angle is deduced from the results of triaxial compressive tests combined with the Drucker-Prager type plastic flow rule. Then, the thesis investigates the actual interlayers behavior through push-out and self-stress tests, and a bond-slip …

    brazil-uerj Repository record for Experimentally based mechanical model of sandwich pipes with a strain-hardening cementitious composite core (opens in a new tab)

  9. Pressuremeter tests in sand : effects of dilation

    … with the same initial modulus and strength. Dilation stiffens a material's response, but even a highly dilatant material is less stiff than an elastic-plastic material. The method of determining the friction angle and dilation angle of frictional materials from pressuremeter data proposed by …

    ubc Repository record for Pressuremeter tests in sand : effects of dilation (opens in a new tab) Download PDF for Pressuremeter tests in sand : effects of dilation (opens in a new tab)

  10. Ultimate Load Capacity of Caisson Foundations and Anchors in Sand

    … of load attachment depth (Li), Load inclination angle (θ), aspect ratio and soil relative density (Dr). Mohr-coulomb constitutive model has been the primary model that is used to model the soil in this study and two of its parameters friction angle (ф) and dilation angle(ψ) have been assessed to …

    tamu Repository record for Ultimate Load Capacity of Caisson Foundations and Anchors in Sand (opens in a new tab)

  11. Development of FEA Models to Investigate the Shear Behavior of Reinforced Concrete Beams

    … from the sensitivity analysis conducted were the dilation angle, mesh size, and lastly concrete strength and model. As for the numerical strengthen models, the models obtain 22% to a 35% error range to Tann (2011) work. The numerical strengthened models poor behavior is attributed to further …

    ttu Repository record for Development of FEA Models to Investigate the Shear Behavior of Reinforced Concrete Beams (opens in a new tab)

  12. Laboratory Investigation of Shear Behaviour in Rock Joints Under Varying Boundary Conditions

    … properties (e.g. stiffness, strength, and dilation) of rockmass discontinuities, which are used as inputs for numerical geotechnical design, is through laboratory direct shear testing. Direct shear testing is typically conducted using two different boundary conditions: constant normal …

    queens Repository record for Laboratory Investigation of Shear Behaviour in Rock Joints Under Varying Boundary Conditions (opens in a new tab)

  13. Assessment of Energy Conversion Associated with Brittle Rock Failure

    … energy. In addition, an increased residual dilation angle, which affects brittle rock post-peak behaviour, elevates energy demands for support system design. This thesis developed new knowledge in understanding the mechanisms of brittle rock failure and associated energy conversion across …

    unsw Repository record for Assessment of Energy Conversion Associated with Brittle Rock Failure (opens in a new tab)

  14. Finite Element Modelling of GFRP Reinforced Concrete Beams

    … the stirrups had on the concrete, an increased dilation angle of 50 degrees was used in combination with an increased maximum concrete compressive strain. Truss reinforcement was again used for the longitudinal reinforcement, whereas membrane sections are recommended for the stirrups. A …

    waterloo Repository record for Finite Element Modelling of GFRP Reinforced Concrete Beams (opens in a new tab)

  15. Mechanical Properties of St. Peter Sandstone A Comparison of Field and Laboratory Results

    … a lack of interstitial cement, and high dilation rates at failure. When confined it is capable of supporting large loads with small deformations, even under saturated conditions, yet when confinement is removed it disintegrates and readily flows. Dry intact samples have a uniaxial …

    umn Repository record for Mechanical Properties of St. Peter Sandstone A Comparison of Field and Laboratory Results (opens in a new tab)

  16. Behaviour of single batter piles and pile groups under lateral soil movement in sand

    … to be dependent on, among other factors, batter angle, pile embedded length, distance between the batter piles location and soil movement source, pile diameter, profile of soil movement, sand density and the pile head fixity condition. Regardless of the value of batter angle, the bending moment …

    salford Download PDF for Behaviour of single batter piles and pile groups under lateral soil movement in sand (opens in a new tab)

  17. Shear behaviour of rock discontinuities and soil-rock interfaces

    … parameter of peak shear strength is the dilation angle, which for a particular joint type, reduces logarithmically with normal stress over four orders of magnitude and becomes zero at a normal stress which in most cases is about one order of magnitude lower than the unconfined compressive …

    whiterose Download PDF for Shear behaviour of rock discontinuities and soil-rock interfaces (opens in a new tab)

  18. Determination of soil properties for sandy soils and road base at Riverside Campus using laboratory testing and numerical simulation

    … to estimate the frictional resistance and angle of dilation of the clean sand and the silty sand. Numerical simulations of the Direct Shear Test (DST) were conducted on the clean sand using Finite Element Model in the computer program LS-DYNA. The simulations were intended to reproduce the …

    tamu Repository record for Determination of soil properties for sandy soils and road base at Riverside Campus using laboratory testing and numerical simulation (opens in a new tab)

  19. Evaluating Performance of Hybrid Geosynthetic-Reinforced Retaining Walls

    … the backfill soil friction, the backfill soil dilation, the backfill soil modulus, the compaction stress, and the foundation compressibility. The parametric study shows that the maximum wall facing deflection decreased with an increase in the primary reinforcement length, the secondary …

    ku Repository record for Evaluating Performance of Hybrid Geosynthetic-Reinforced Retaining Walls (opens in a new tab)

Page 1 of 2