Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 19 of 19 for “"diode bridge rectifier"”.

  1. Comparison between three- and five-phase permanent magnet generators connected to a diode bridge rectifier

    … of 5- and 3-phase PM generators connected to a diode bridge rectifier under normal and open-circuit failure conditions. Also it describes the design of 5- and 3-phase prototype PM generators with the same volume and rated speed. The permanent magnet generator has advantages such as: simple …

    strathclyde Repository record for Comparison between three- and five-phase permanent magnet generators connected to a diode bridge rectifier (opens in a new tab)

  2. Passive Full-Wave MOSFET Rectifiers for Electromagnetic Harvesting

    … to get DC power out of AC. Traditional full-wave bridge rectifiers and center-tapped transformer rectifiers are not feasible in micro-watt-level harvesters. Low output power undermines the power efficiency of those traditional rectifiers. Thus, novel, low power, high efficiency conversion circuits …

    waterloo Repository record for Passive Full-Wave MOSFET Rectifiers for Electromagnetic Harvesting (opens in a new tab)

  3. Single phase trapezoidal AC power supplies for hybrid fiber/coax networks

    … Conventional power supplies having a front-end diode bridge rectifier and a large dc bus capacitor are an unacceptable approach for this application as they draw a highly distorted current waveform resulting in a poor power factor. An intermediate boost stage is used to waveshape the input …

    concordia Download PDF for Single phase trapezoidal AC power supplies for hybrid fiber/coax networks (opens in a new tab)

  4. Optimization of rectifiers for aviation regarding power density and reliability

    … system with active B6 and passive B12 rectifiers. A possible alternative is the B6 diode bridge in combination with an active power filter (APF). Due to the parallel arrangement, the APF offers a higher power density and is able to compensate for harmonics from several devices. The use …

    qucosa-diss

  5. A Line-Commutated Thyristor-Bridge Emulated Rotating Power Electronic Converter for Brushless Exciter Applications

    … the wound-field synchronous machines through a diode bridge rectifier. Though these diode bridge based exciters are more reliable than the static exciters, which use brushes and slip rings, they can not produce a negative voltage across the field winding, making the rate of decay of the field …

    umn Repository record for A Line-Commutated Thyristor-Bridge Emulated Rotating Power Electronic Converter for Brushless Exciter Applications (opens in a new tab)

  6. A Novel Power Conversion Approach for Single Phase Systems

    … and control scheme is proposed. The new rectifier consists of switched capacitor branch in parallel with the diode bridge rectifier. The switched capacitor branch includes a capacitor and a bidirectional switch arranged in series so the switch can control the charging and discharging of …

    plymouth Repository record for A Novel Power Conversion Approach for Single Phase Systems (opens in a new tab)

  7. Piezoelectric energy harvesting: modeling, optimization, and experimental study of transient charging behavior

    … effects of an standard interfacing circuit with diode bridge rectifier and a non-linear synchronous switching circuit on the transient charging dynamics are modeled and comprehensively studied. Additionally, an experimental test setup is developed to validate the efficacy of the developed model …

    manitoba Repository record for Piezoelectric energy harvesting: modeling, optimization, and experimental study of transient charging behavior (opens in a new tab)

  8. A Highly Modular Grid Interface For Utility Scale Renewables: Mmc With Isolated High Frequency Link Sub-Modules

    … is composed of a high-frequency transformer, a diode bridge rectifier, a capacitor, and a half-bridge cell. The sub-modules are arrange in a three phase MMC configuration where the output of each sub-module is the half-bridge cell. The input of all sub-modules are connected to the primary …

    umn Repository record for A Highly Modular Grid Interface For Utility Scale Renewables: Mmc With Isolated High Frequency Link Sub-Modules (opens in a new tab)

  9. Investigation into power distribution _grid interfacing for subsea tidal generation - Rectification to a common DC-bus

    … are connected to a common DC bus via passive diode rectifiers. The proposed tidal stream topology shows that variable pitched blades, variable speed gearboxes and frequency converters in the nacelle can be replaced by a much simpler system that uses fixed pitch blades, a fixed ratio gearbox, …

    whiterose Download PDF for Investigation into power distribution _grid interfacing for subsea tidal generation - Rectification to a common DC-bus (opens in a new tab)

  10. Multi-level Matrix Converters

    … The front end can be implemented by means of diode bridge rectifier, thyristor based 6 pulse converter or an active VSI with the latter having the best performance in terms of input current harmonics and filter requirement. The DC link voltage of these converters are usually maintained by …

    umn Repository record for Multi-level Matrix Converters (opens in a new tab)

  11. Single-Sensor DCM PFC Based Onboard Chargers for Low Voltage Electric Vehicles

    … turn-on of the switches, and inherent zero diode reverse recovery losses. Proposed converters can operate for the wide input voltage range and the output voltage is controlled by a single sensor-based single voltage control loop making the control simple and easy to implement, and improves …

    concordia Download PDF for Single-Sensor DCM PFC Based Onboard Chargers for Low Voltage Electric Vehicles (opens in a new tab)

  12. D-q impedance identification in three phase systems using multi-tone perturbation

    … problem. The algorithm is tested with 12-pulse diode rectifier simulation model, and 6-pulse diode rectifier simulation model and experimental test bed. Both simulation and experiment results verifies the concept.

    vt Repository record for D-q impedance identification in three phase systems using multi-tone perturbation (opens in a new tab)

  13. A Small-Scale Standalone Wind Energy Conversion System Featuring SCIG, CSI and a Novel Storage Integration Scheme

    … Among all, the topology composed of three-phase diode bridge rectifier, DC/DC buck converter, and pulse-width-modulated current-source inverter (PWM-CSI) is identified as a simple and low-cost configuration, offering satisfactory performance for a low-power off-grid WECS. A small-scale standalone …

    waterloo Repository record for A Small-Scale Standalone Wind Energy Conversion System Featuring SCIG, CSI and a Novel Storage Integration Scheme (opens in a new tab)

  14. Analysis and Design of a DCM SEPIC PFC with Adjustable Output Voltage

    Power Factor Correction rectifiers are widely adopted as the first stage in most grid-tied power conversion systems. Among all PFC converts for single phase system, Boost PFC is the most popular one due to simplicity of structure and high performance. Although the efficiency of Boost PFC keeps …

    vt Repository record for Analysis and Design of a DCM SEPIC PFC with Adjustable Output Voltage (opens in a new tab)

  15. GaN-based High-Frequency Isolated Single-Stage AC-DC Converters for More Electric Aircrafts

    … generators has been performed using passive diode-bridge rectifier systems, known as transformer rectifier units (TRU). Compared to active power electronic interfaces, TRUs have higher weight, lower efficiency, and inferior voltage regulation. This work proposes an active power electronic …

    maryland Repository record for GaN-based High-Frequency Isolated Single-Stage AC-DC Converters for More Electric Aircrafts (opens in a new tab)

  16. Διερεύνηση της ασύρματης μεταφοράς ισχύος σε εφαρμογές μικροδικτύων συνεχούς ρεύματος

    … In addition, the analysis and modeling of the diode bridge rectifier, as well as the WPT system behavior when injects power to the DC bus are of major research interest.Regarding the EV wireless charging scheme, relevant literature although rich, as an enormous volume of scientific papers has …

    greece Repository record for Διερεύνηση της ασύρματης μεταφοράς ισχύος σε εφαρμογές μικροδικτύων συνεχούς ρεύματος (opens in a new tab)

  17. Electromechanical design of locally manufactured small wind turbines

    … noise to current harmonics introduced by the diode bridge rectifier. The acoustic noise emissions of LMSWTs are measured in the field for the first time, while novel passive filter configurations are proposed for acoustic noise mitigation and their performance is evaluated in field tests. …

    greece Repository record for Electromechanical design of locally manufactured small wind turbines (opens in a new tab)

  18. Modeling and Control of Single-Phase Power Electronic Converters and Islanded Microgrids using the Dynamic Phasor Method

    … grid-following and grid-forming inverters, H-bridge active rectifiers, droop-controlled microgrids, diode-bridge rectifiers, and non-isolated DC-DC converters. Additionally, this thesis proposes the DP model of a synchronization unit suitable for (re)connecting a grid-forming inverter to a …

    calgary Repository record for Modeling and Control of Single-Phase Power Electronic Converters and Islanded Microgrids using the Dynamic Phasor Method (opens in a new tab)

  19. Analyse und Vergleich von Generator-Umrichter-Konzepten für den Einsatz in Kleinwindenergieanlagen

    … Synchrongenerators (PMSG) jeweils mit einem Diodengleichrichter und Hochsetzsteller (DR-HSS), einem Halbbrückengleichrichter (HBG) und einem Zwei-Level-Wechselrichter (ZLW). Hierbei stellt der PMSG mit DR-HSS die Vergleichsbasis dar. Die Kosten eines GUK setzen sich aus denen des PMSG und des …

    cau-kiel Repository record for Analyse und Vergleich von Generator-Umrichter-Konzepten für den Einsatz in Kleinwindenergieanlagen (opens in a new tab)