Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 10 of 10 for “"direct reading instruments"”.

  1. Hazard mapping with direct reading instruments from facilities with high and low temporal variability

    … techniques employing relatively lower-cost direct-reading instruments (DRIs, instruments that report hazard intensity at near real-time resolution) for hazard mapping. Normally, personal sampling equipment worn by workers is used to determine personal exposure (time-weighted average) to a …

    colostate Repository record for Hazard mapping with direct reading instruments from facilities with high and low temporal variability (opens in a new tab)

  2. An Investigation of Intermaxillary Tooth Mass Discrepancy: A New Approach

    … produced from the impression and measured with direct reading instruments. A model of occlusion was adopted as a reference for evaluating tooth mass problems. Each case demonstrated some tooth mass discrepancy. The discrepancies in the posterior segments were generally very minor and of limited …

    iupui Repository record for An Investigation of Intermaxillary Tooth Mass Discrepancy: A New Approach (opens in a new tab)

  3. Characterization of Scanning Mobility Particle Sizers For Use With Nanoaerosols

    … were obtained within the chamber. Real-time, direct-reading particle measurement instruments including a condensation particle counter (CPC) (TSI, Model 3007), and three scanning mobility particle sizer (SMPS) instruments (Particle Measuring Systems, Nano-ID NPS500; TSI, NanoScan SMPS …

    usf Repository record for Characterization of Scanning Mobility Particle Sizers For Use With Nanoaerosols (opens in a new tab)

  4. Remember the small giants - Occupational exposure and characterization of aerosol particles

    … were characterized by filter sampling and by direct reading instruments. A laser vaporization aerosol mass spectrometer (LV-AMS) was used for both selective sampling of emitted particles based on their composition, and for in-situ analysis of ENPs inside the production line. RESULTS: 1) If …

    lund Repository record for Remember the small giants - Occupational exposure and characterization of aerosol particles (opens in a new tab) Download PDF for Remember the small giants - Occupational exposure and characterization of aerosol particles (opens in a new tab)

  5. Particle emissions and exposure to hazardous chemical agents during binder jetting utilising a silica sand

    … was used to determine chemical composition. Direct-reading instruments including, a Grimm-Portable Laser Aerosol Spectrometer model 11-A and a Nanozen DustCount® 9000 Z1 optical particle counter, were used to quantify particle number concentrations and emission rates of particles released …

    nwu-za Repository record for Particle emissions and exposure to hazardous chemical agents during binder jetting utilising a silica sand (opens in a new tab)

  6. Estimating Occupational Exposures with a Multi-Hazard Sensor Network

    … personal measurements with field reference instruments, and compared the network-derived personal exposure estimates to the personal measurements. Results: In our first study, we observed measurement error for ozone was two to three times higher than for nitrogen dioxide and that ozone was …

    jhu Repository record for Estimating Occupational Exposures with a Multi-Hazard Sensor Network (opens in a new tab)

  7. Filling Research Gaps in Occupational Health in Thermal Spray Coatings: A Scoping Review, Lab Characterization, and Lung Deposition of Cold Sprayed Emissions

    … CS under various operating conditions using direct-reading instruments and offline samplers. Additionally, a mixed-effect model analysis was conducted to determine which factors (powder type, powder shape, substrate type, transverse gun speed, and carrier gas heat) significantly influence …

    wvu Repository record for Filling Research Gaps in Occupational Health in Thermal Spray Coatings: A Scoping Review, Lab Characterization, and Lung Deposition of Cold Sprayed Emissions (opens in a new tab)

  8. Performance comparison of the Nanozen Dustcount personal real-time monitor with a conventional respirable dust exposure sampling method

    … in technology and the development of direct-reading instruments, such as the Nanozen DustCount® 9000-Z1 personal real-time monitor (Nanozen Industries Inc., Vancouver, Canada), provide faster, real-time dust exposure measurements. The accuracy of these devices must, however, be …

    nwu-za Repository record for Performance comparison of the Nanozen Dustcount personal real-time monitor with a conventional respirable dust exposure sampling method (opens in a new tab)

  9. Measurement and Control of Occupational Exposure to Engineered Nanoparticles

    … sources were identified and characterized by direct-reading instruments and area sampling. Area samples analyzed for EC yielded quantifiable mass concentrations inside an enclosure where unbound MWCNTs were handled and near a pelletizer where nanocomposite was cut, while those analyzed by …

    umn Repository record for Measurement and Control of Occupational Exposure to Engineered Nanoparticles (opens in a new tab)

  10. Characterization of Naturally-Occurring Alpha Diketone Emissions and Exposures at a Coffee Roasting Facility and Associated Retail Café

    … associated café, determining the extent to which direct reading measurements of CO, CO2, and total VOCs can serve as lower-cost surrogate indicators for diacetyl concentrations, and conduct a limited survey to quantify the effect that the process variable of roast type (i.e. light, medium, and …

    washington Repository record for Characterization of Naturally-Occurring Alpha Diketone Emissions and Exposures at a Coffee Roasting Facility and Associated Retail Café (opens in a new tab)