Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 31 for “"duplexer"”.
-
Adaptive Duplexer for Software Radio
… of the key architectural changes required. The duplexer is one such component. Since duplexing filters are not normally tuneable, each band requires a separate duplexer in a multi-band system. The duplexers are passive devices (ceramic or SAW) and multiple duplexers lead to a dramatic increase …
-
Duplexer pro pásmo 5,6 GHz
Cílem diplomové práce bylo navržení duplexeru pracujícím v bezlicenčním frekvenčním pásmu 5,6GHz. Práce se zabývá výběrem vhodného konceptu pro daný duplexer, vytvořením modelu v softwaru pro simulaci rozložení elektromagnetického pole a následnou realizací a ověřením parametrů duplexeru.
-
Adaptive Duplexer Control for Wireless Transceivers
… operation This work presents an adaptive duplexer architecture compatible with silicon integration. It is tunable over a wide frequency range and capable of carrier aggregation. The structure uses a combination of a low isolation device with multiple analog cancelling loops controlled by a …
-
Analysis And Design Of Miniaturized Rf Saw Duplexer Package
… radio frequency (RF) surface acoustic wave (SAW) duplexer package. Full-wave analysis based on the three dimensional (3-D) finite element method (FEM) is successfully applied to model the package. The die model is obtained by combining the acoustics and die busbars parasitics models. The acoustics …
-
Three dimensional full wave package design of RF SAW duplexer
Master of Science (M.S.)
-
A tunable low-isolation device for adaptive duplexers
… simultaneous transmission and reception. A duplexer isolates the sensitive receiver (Rx) circuits from the high-power transmitter (Tx) output. The classical duplexer relies on two highly selective filters using surface acoustic wave or thin film bulk acoustic resonator technology. One is …
-
Synthesis and Design of Microwave Filters and Duplexers with Single and Dual Band Responses
… been included. This is followed by microwave duplexer synthesis. Next, a technique to design dual band filter has been described including ways to achieve desired return loss and rejection levels at specific bands by manipulating the stopbands and transmission zeros. The concept of dual band …
-
Circuits and Systems for On-Chip RF Chemical Sensors and RF FDD Duplexers
Integrating RF bio-chemical sensors and RF duplexers helps to reduce cost and area in the current applications. Furthermore, new applications can exist based on the large scale integration of these crucial blocks. This dissertation addresses the integration of RF bio-chemical sensors and RF …
-
Wide band TX Leakage Cancellation for FDD Transceivers
… communication systems. A device called a duplexer is needed in order to separate the transmitter (TX) and the receiver (RX) signals. To avoid RX being saturated and desensitized, the isolation between the TX and RX ports of the duplexer needs to be as large as possible. However, such a …
-
Fully-Integrated Millimeter-Wave Duplexer Modules with Internal Power Amplifier and Low Noise Amplifier on 0.18-µm Bicmos Process For FDD 5g and Other Millimeter-Wave Applications
… (TX-RX) front-end modules, including duplexer (DUX), power amplifier (PA), and low noise amplifier (LNA) on TowerJazz 0.18-µm SiGe BiCMOS. Additionally, two new proposed structures of BiCMOS PAs operating at mm-wave ranges are presented. These new contributions would benefit the …
-
Development and Implementation of a VHF High Power Amplifier for the Multi-Channel Coherent Radar Depth Sounder/Imager System
… antenna by using a high-power circulator and a duplexer circuit composed of two 90° hybrid couplers and anti-parallel diodes. The duplexer is advantageous over switches based on PIN-diodes due to the moderately high power handling capability and fast switching time. The system presented here is …
-
A Novel Nonlinear Mason Model And Nonlinear Distortion Characterization For Surface Acoustic Wave Duplexers
… devices at radio frequency (RF). SAW filters and duplexers can be virtually found inside every mobile handset. SAW devices are traditionally recognized as passive devices with high linear signal processing behavior. However, recent deployments of third generation (3G) and fourth generation (4G) …
-
Micromachined microwave cavity filters for 5G systems: on a structured design procedure with mode matching synthesis
… devices and as such, the design of a set of duplexer bandpass filters is demonstrated for this targeted application area.
-
Design of a low-cost 60 GHz transceiver frontend
… frontend, equipped with a tailor-made antenna duplexer, is reconfigurable for frequency, power, and modulation scheme. The developed frontend is characterized for local oscillator, transmitter, and receiver operations. The adaptability of the frontend allows it to be used as an agent in a …
-
Numerical simulations of microacoustic resonators and filters
… considered is comprehensive modeling of a SAW duplexer, including electromagnetic modeling of the ceramic package. The parasitic capacitive and inductive couplings in the package are obtained using rigorous computation, allowing one to estimate the package effects on the duplexer performance.
-
Reflection Co-Efficients of Re-Entrant Hybrid Tee
… tee has wide application as impedance bridge, Duplexer, mixer, discriminator, and in cascading of one port amplifier. The field of study in the hybrid tee was widened by introduction of the E-H reentrant tee which interconnects the E and H ports. Such a loop has been studied with reflectionless …
-
Characterization and design of embedded passive circuits for applications up to millimeter-wave frequency
… high isolation between passbands. High-rejection duplexer has been designed in RXP substrate for chip-last embedded IC technology, and a novel matching circuit has been applied for the miniaturization as well. The 60 GHz V-band has special interest for wireless applications because of its high …
-
Development of micromachined millimeter-wave modules for next-generation wireless transceiver front-ends
… first time. By elevating a cavity-filter-based duplexer and a horn antenna on top of the substrate and using air as the filler, the dielectric loss can be eliminated. A full-duplex transceiver front-end integrated with amplifiers are designed, fabricated, and comprehensively characterized to …
-
Design and realisation of filters on MHMIC and MMIC fabrication processes for duplexers realisation
… requires a separate radio frequency filter or duplexer for each band. In addition to this, filters are relatively large in size compared to other front-end components. Consequently, filters and duplexers occupy an increasing portion of modem radio frequency transceivers' real-estate. This has …
Page 1 of 2