Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 66 for “"feed flow rate"”.
-
TIME SERIES DEEP LEARNING APPROACH FOR THE INTERMITTENT OPERATIONAL PERFORMANCE OF A WELLHEAD WATER TREATMENT AND DESALINATION SYSTEM
… nature of the communities, these systems must operate autonomously adapting to intermittent operations due to varying water use patterns and unavailability of continuous manual labor support. Machine Learning models describing and forecasting system performance are critical, allowing for …
-
A theoretical and experimental investigation of spouted beds with draft tubes.
A spouted bed with a draft tube insert and separate gas supplies into the annular region and central core at the bottom of the bed was built. The influence of the central gas feed flow rates, annular gas feed flow rate, and the bottom gap height on the solids circulation rate, gas bypassing rate …
-
Dynamic simulation and control of a distillation column
… can be minimized, and facilities can be operated in stable manner thus avoiding unnecessary trips. Hence, selection of proper controls for distillation columns is both challenging and critical. This study deals with the composition control of distillation columns by using rigorous simulators …
-
Towards Sustainable Handling of Waste_ Pyrolysis and Gasification of Biomass and Waste Tyre for Syngas Production: Kinetics Study and Process Simulation
… are as follows: (i) The increase in the heating rate shifted the differential thermogravimetric (i.e. DTG) curves to higher temperatures and resulted in the variation in the difference in weight loss thus the extent of positive synergetic interaction, (ii) Based on various kinetic analysis …
-
The process analysis for the laboratory distillation column control
An overhead composition control strategy was developed for the laboratory distillation column "Scott Model 9079". The column pressure, feed flow rate and accumulator level were held constant. The feed composition was taken as the disturbance variable. The overhead composition of the column was …
-
Concentration of feijoa and boysenberry fruit aroma condensates using pervaporation : a thesis presented in partial fulfillment of the requirements for the degree of Master of Food Technology at Massey University
… and boysenberry aroma condensates were concentrated in a pervaporation apparatus fitted with polydimethyl siloxane (PDMS: GFT1060, GFT1070) and poly-ether-block-amide (PEBA, GKSS) membranes, under the following operating conditions: feed temperature of 30°C, feed flow rate of 8.3 x 10 or 1.4 x …
-
Iron bioavailability and consumer acceptability of extruded common bean (Phaseolus vulgaris) flour
… moisture content, extruder die temperature and feed flow rate were optimized with respect to bean iron bioavailability, paste viscosity and consumer acceptability of extruded flours. Extrusion cooking increased both iron content and iron bioavailability and gave consumer acceptable flours with …
-
A Statistical Analysis of Hydrocyclone Parameters
… Three operating parameters were investigated: feed concentration, volume split and feed flow rate. In addition, three design parameters were cone angle, inlet diameter, and vortex finder length. The performance criterion parameters were the efficiency with which the solids were separated from …
-
The Effect of Various Design Variables on the Separation of Two Immiscible Liquids by Continuous Gravity Decantation
… studied were tangential versus perpendicular feed flow, height/diameter ratio, the total feed flow rate, the temperature and the intertace position with respect to feed inlet. The criteria used were the calculated immiscible concentration of water in CNFA overflow (Cw) and that of CNFA in …
-
DESALINATION OF SEA WATER USING REVERSE OSMOSIS METHOD
… salt (NaCl) solutions and sea water were used as feed solutions. The experimental results obtained were used to test the applicability of three permeator transport models, namely, the Ohya-Sourirajan approach, the complete-mixing model, and a lumped parameter approach introduced in this study. The …
-
A study of selected control variables for a bottom-fed thickener
… slurries. The three variable parameters were "Feed Flow Rate," "Feed pH," and "Feed Solids Concentration." These three input parameters were studied under three polymeric conditions. The X-ray analysis of underflow refuse samples from two coal preparation plants showed that the samples …
-
Optimized Design of Shale Gas Processing and NGL Recovery Plant under Uncertain Feed Conditions
… in utilizing shale gas is its fluctuating flow rate and compositional behavior. The flow rate of a shale gas well dwindles over a period of time and the composition of shale gas differs from well to well in the same shale play. This provides a challenge in designing a plant of optimum size …
-
MICROBIAL INACTIVATION AND SPRAY DRYING FOR THE RECOVERY OF SINGLE-CELL PROTEIN FROM CHEMICALLY DECONSTRUCTED POLYETHYLENE TEREPHTHALATE
… to ensure the safety and stability of generated SCP. Our study evaluated the effect of exposure time (45–60 minutes) at 140 °C with the goal of maximizing microbial inactivation. Our findings suggest that microbial inactivation can be achieved at 140 °C in 60 minutes. Since SCP is generated …
-
The Separation of Carbohydrates by Continuous Production Scale Chromatography
… one pass through the equipment. The effects of feed concentration, feed flow rate and change of switch period were investigated...
-
Removal of volatile organic compounds from contaminated groundwater by pervaporation
… inside the micellar core. The micellar solution flows through the bore of microporous hydrophobic hollow fibers wherein the micelles break down and release the surfactants and the TCE. The TCE is then removed through the pores and a nonporous thin silicone skin on the outside surface of the …
-
Alum treatment of caustic wash from chlorine bleached kraft pulp
… be used to dewater the sludge from the Dorr underflow. Approximately 5000 gallons of caustic wash from chlorine bleached kraft pulp was used for each phase of this investigation. The raw waste feed flow rate was varied from 1750 pounds per hour to 2499 Pounds per hour. The alum slurry flow rate …
-
Frequency response analysis of naphthalene biotransformation activity in a biological treatment system
… system was perturbed with a complex wastewater feed stream containing a sinusoidally-varying naphthalene concentration while all other feed constituents, total feed flow rate, and other reactor operating parameters were held nearly constant. Time series offgas analysis for naphthalene provided a …
-
Ion Exchange Polymer Coated Electrodes for Selective Electrosorption Based Water Softening Applications
… is a developing water treatment method and operates by applying an electrical potential between two porous electrodes. In membrane based electrosorption system, ion-exchange membranes are placed in front of each electrode to prevent the passage of co-ions, resulting in enhanced salt removal and …
-
Process Analysis and Optimization of Crude Glycerol Autothermal Reforming Using Response Surface Methodology and Artificial Neural Network
… temperature: 500 - 650oC, crude glycerol flow rate: 0.0019 - 0.0033 mols C/min, Steam to carbon ratio: 1.6 - 3.6, Oxygen to carbon ratio: 0.05 – 0.2, Catalyst weight: 0.05 - 0.25g. The highest feed conversion and yield were 92 mol% and 0.995 mols respectively at temp: 575oC, feed flow …
-
Methods and challenges of experimental system identification of a distillation column
… as a teaching tool, but is currently without a feedback control system. An eventual goal of developing such a control system requires that the behavior of the column be understood. It is necessary to identify which of the column parameters can change, either ones that change to cause a …
Page 1 of 4