Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 55 for “"flow quality"”.
-
Low-speed wind tunnel flow quality determination
… is 84% of the tunnel?s rated speed. The 2-D flow uniformity was within ±7% by pressure rake, and ±3% with a turbulence intensity ?0.11% at full speed using a CTA, affirming the tunnel?s viability as a demonstration platform. Spectral density plots in the boundary layer exhibit typical …
-
Measurement of Freeway Traffic Flow Quality Using GPS-Equipped Vehicles
The evaluation of freeway service quality is crucial work, and thus, transportation professionals have developed numerous measures including traffic volume, speed, and density. However, recent research efforts have indicated that such traditional measures may not fully reflect the quality of …
-
The measurement of wind tunnel flow quality at transonic speeds
The measurement of wind tunnel flow quality for the transonic flow regime has been plagued by the inability to interpret complex unsteady flow field information obtained in the free stream. Traditionally hot wire anemometry and fluctuating pressure techniques have been used to quantify the unsteady …
-
Dynamic flow quality measurements in a transonic cryogenic wind tunnel
… for time-resolved measurements of dynamic flow quality in a transonic cryogenic wind tunnel. The first one is a dual hot-wire aspirating probe for measurement of stagnation pressure and temperature. The second is a miniature high-frequency response angle probe consisting of surface mounted …
-
Variation in flow and flow quality from a semi-arid urban watershed.
… for the utilization of various predictive flow models to predict the total volume and peak runoff from a gaged watershed. The predictive flow models utilized were the rational method, the Viessman and Miller method, the Viessman, Keating, and Srinivasa method, and the British Road Research …
-
Dynamic Pressure Improvements to Closed-Circuit Wind Tunnels with Flow Quality Analysis
… is usually performed on sub-scale models, flow speeds that span the flight envelope are commonly tested. Traditionally the Texas A&M Engineering Experiment Station Low-Speed Wind Tunnel (LSWT) was limited through available power to a dynamic pressure of 120 psf. The addition of a higher …
-
Experimental measurement of venturi discharge coefficient including sensitivity to geometry and flow quality variations
… generally requires the measurement of the airflow rate used by the engine. Applying the direct-connect method, the AEDC turbine engine test facilities use measurements of the airflow through the air supply duct, typically obtained from venturi installations, to determine the engine airflow …
-
Optimization of Flow Quality In the Test Section of The 30-Inch x 40- Inch Subsonic Tunnel
The purpose of this study is to optimize the flow quality inside the 30-inch x 40-inch subsonic wind tunnel. The tunnel is an open circuit with its inlet positioned adjacent to the side door of the lab; forcing the air to make a ninety degrees turn entering the tunnel. The flow suffered from two …
-
Development of a subsonic free-jet nozzle for inlet-engine integration ground test facilities
… that subjects an aircraft propulsion system to a flow field approximating the flight environment. The free-jet nozzle provides a flow quality commensurate with inlet-engine compatibility test requirements over a wide range of pitch angles, yaw angles, and Mach numbers. The development of the …
-
Report of tests of a compressor configuration of DCA blading.
… angle and Reynolds number are reported. Flow quality and blade performance data were obtained using pneumatic probe surveys and surface pressure measurements. Changes in Reynolds number in the range of 500,000 to 770,000 did not measurably effect either flow quality or blade performance. …
-
An experimental study : using honeycomb to reduce secondary flows in curved ducts
… the effectiveness of using honeycomb to improve flow quality by reducing secondary flow in curved ducts. An experimental setup that consisted of two 90° elbows joined by a 6-inch straight connector duct was used. Traditional solid honeycomb and honeycombs of varying porosity (20%, 30%, and 40%) …
-
Optimisation of Natural Laminar Flow Aerofoils and Wings for Robustness to Critical Transition Amplification Factor
… optimisation methods to improve natural laminar flow (NLF) aerofoil and wing robustness to variations both in operating conditions and uncertainty in surface and flow quality. NLF is a promising method for aircraft drag reduction but has high sensitivity to operating conditions, flow quality and …
-
Development and Implementation of PIV Systems with Selective Particle Seeding For Production Wind Tunnel Testing
… use conventional tools and methods to capture flow characteristics in the 7 foot x 10 foot test section of the Oran W. Nicks Low Speed Wind Tunnel at Texas A&M University (LSWT). The systems are designed to measure velocity fields noninvasively to prevent affecting flow quality. Validation …
-
Experimental Investigation of the Effect of Wall Adaptation on Flow Over a Cylinder in a Modernized Adaptive-Wall Wind Tunnel
… wind tunnel was completed to improve flow quality, automate data acquisition, integrate a three-axis traversing mechanism, and regain functionality of an adaptive-wall test section. Redesign of the settling chamber significantly improved flow quality, with the resulting turbulence …
-
Formation microimager and facies analysis of the Codell sandstone, Redtail field, north-central Denver Basin
… using porosity and permeability as a function of flow quality characteristics. Flow quality was applied to facies and the low-angle planar laminated and massive sandstone have the best quality flow characteristics whereas the bioturbated sandstone, rippled sandstone, and massive mudstone have the …
-
Report of tests of a compressor configuration of CD blading
… were used to obtain blade performance and flow quality data. There was no measurable influence of the Reynolds number on the blade losses in the range of Re. = 474000 to Re. = 690000. Fourteen tests, using seven different inlet air angles over a range of 24 to 46 degrees generated generally …
-
Web-Based platform for tracking and comparing air quality across cities /
… design, implement and evaluate a real-time Air Quality Monitoring and Visualization System that integrates open sources (OpenAQ) and local low-cost sensors, applies quality control and calibration. Provides intuitive visualizations for citizens and institutions. The work covers architecture, …
-
Two-Phase Operational Performance of a Terry GS-2 Steam Turbine Using Air & Water as Working Fluids
… and governor valve under two-phase (air/water) flow conditions. Because of their robust design, Terry turbines are used within the nuclear power generation industry in Reactor Core Isolation Cooling (RCIC) systems to remove decay heat during isolation events. During the Fukushima Daiichi nuclear …
-
Stormwater Infiltration thru Sewer Lines in Brevard County, Florida
… a broad study of stormwater infiltration and inflow effects on two sewer systems with an equivalent size for comparison in Brevard County, Florida. The systems are Rockledge, which is located on the highest ground in the area, and Cocoa Beach, which is located down in the local water table. …
-
Study of compressible flow through a rectangular-to-semianular transition duct
… diffusing ducts designed for the HSR program. Flow quality data for this facility are presented and the design procedure involved is discussed. A recommended protocol for testing candidate ducts is presented with sample data from the validation duct.
Page 1 of 3