Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 779 for “"flume"”.
-
Numerical simulation of a chimney flume
The ventilation of buildings with chimney stacks has been a major problem because of the possibility of re-entry of exhaust gases through the fresh air vents. Harmful and odorous gases and vapors released from industries typically are controlled by employing exhaust systems designed to capture and …
-
Analysis of Cutthroat Flume Discharge Ratings
… by many investigators for various Cutthroat flume sizes are thoroughly reviewed and organized. Best-fit discharge parameters are obtained by performing the free-flow analysis and the submerged-flow analysis. Then, the transition submergence can be calculated. Afterwards, the unified free-flow …
-
Sand dispersion in a laboratory flume
This study is concerned mainly with the longitudinal dispersion of sand particles along the bed of an alluvial channel under conditions of steady, uniform flow. Attention is focused on developing a general one-dimensional stochastic model to describe and predict the longitudinal dispersion process. …
-
Sediment-resistant flume for hydrologic measurements
A Sediment-Resistant flume has been tested and analyzed in the laboratory and field to measure flow rate with high sediment concentration for natural and irrigation streams. This flume is basically an improvement of the well studied long-throat flume which has an additional chute proposed by J. A. …
-
Shape design optimization of parametric flume sections.
… optimization methodology for parametric surface flume sections. Flume sections or flow channels have been used widely in many areas such as water chutes in civil and agricultural engineering and water slides and bob sled tracks in the recreational and sports fields. Designing such a flow channel …
-
Flume construction on King Hill irrigation project
Thesis (Civil Engineering)--University of Kansas, Civil Engineering, 1921. ; Includes bibliographical references.
-
Constant shear along a boundary of a flume
… would give constant shear along the bed of a flume. In this investigation a flume has been designed according to White's theory and by two separate methods proven to give constant shearing force along the bed. The first method applied the Hydrogen Bubble Technique to obtain accurate values of …
-
Flume studies of gravel bed surface response to flowing water
… water was explored in a 6 meter by 0.5 meter flume using four different slopes and various water depths. Corrected bed shear stresses varied between 0.05 and 2.79 Pa. Step increases in discharge with a constant slope caused the bed surface to develop a structure which was more stable at the …
-
Analysis of colloids and flume simulations of abandoned mine drainage
… used to quantify total iron in AMD waters and flume simulations. Suspended iron was quantified near the mouth of Shamokin Creek, indicating that it contributes iron to the Susquehanna River even though Fe2+ concentrations are below detection limits. Flume simulations revealed that both the …
-
The controls of morphodynamics in steep, aggrading channels : a flume investigation
… of one dimensional alluvial fans using a novel flume setup. The two grain size distributions share the same median grain size (D₅₀ = 1.42 mm), one (GSD₁) is composed of log normally distributed material from 0.25 to 5.6 mm and the other (GSD₂) is only composed of two classes: 1.4 and 2.0 mm. …
-
Theory and design of a wave generator for a short flume
… use in a 39'-4¼'' long, 30" wide and 36" deep flume, and the re-design of a small wave generator previously built for a 21'-3 5/8" long, 8 3/4" wide and 10 5/8" deep flume. These relatively short flumes are installed in the Hydraulics Laboratory of the Department of Civil Engineering, …
-
Two prototype fluvial suspended sediment samplers evaluated in an instream flume
… sampler (CPS), were evaluated using an instream flume and a DPS sampler, placed in a small, low energy, second order stream in the Southern Interior of British Columbia, Canada. The time integrated passive sampler consisted of a passive instream sampler, and collected FSS continuously over a …
-
Flume Construction and RFID Tracking Techniques for Fluvial Sediment Transport Studies
… The goal of this research is to develop a flume with the capacity to accurately measure sediment inputs, transport, and export in real time. This is accomplished by automating the sediment supply, using a sediment trap with a light table to monitor sediment leaving the flume, and …
-
Parshall Flume Staff Gauge Location and Entrance Wingwall Discharge Calibration Corrections
… devices were tested, the majority were Parshall flumes. Many of the assessed Parshall flumes were not measuring flow to the specified ±5 percent design accuracy. Problems in flow measurement were due to issues with the staff gauge location and incorrect entrance geometry. Laboratory tests were …
-
Generalized Predictive Control of Ship Coupling Motions Using Active Flume Tanks
… coupled with the sway and yaw using an activated flume tank. GPC is a strategy based on system output prediction over finite horizon known as the prediction horizon. GPC controller is designed from the coefficients of the Autoregressive model with exogenous input (ARX) that are computed directly …
Page 1 of 39