Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 6 of 6 for “"friction augmentation"”.
-
Heat Transfer And Friction Augmentation In A Narrow Rectangular Duct With Symmetrical And Non-symmetrical Wedge-shaped Turbulators
… in heat transfer to the full rib cases with friction augmentations 5 to 10 times lower than the full rib cases. Further improvements to wedge heat transfer and pressure drop can be done by determining optimal wedge size and orientation.
-
Heat Transfer, Friction, and Turbulent Analysis on Single Ribbed-Wall Square Channel
… experimental investigation of heat transfer and friction behavior for a fully developed flow in a non-rotating square channel was conducted under a wide range of Reynolds numbers from 6,000 to 180,000. The rig used in this study was a single ribbed wall variant of Ahmed et al.'s [ 1 ] rig from …
-
Computations of Flow Structures and Heat Transfer in a Dimpled Channel at Low to Moderate Reynolds Number
… recirculation zones in the dimple with resulting augmentation ratios below unity. Flow transition is found to occur between Re = 1020 and 1130 after which both heat transfer and friction augmentation increase to values of 3.22 and 2.75, respectively, at Re = 2000. The presence of large scale …
-
The Effect Of Heat Transfer Coefficient On High Aspect Ratio Channel Accompanied By Varying Rib Aspect Ratio
… scheme to enhance the heat transfer and friction factor. Rib aspect ratios ranging from (1:1) to (1:5) rib-height-to-width ratio were used. The first channel rib-width-to-pitch (Wr/P) ratio was kept at 1/2 where flow was kept at relatively low Reynolds numbers, between 3000 and 13000. …
-
Heat Transfer Augmentation In A Narrow Rectangular Duct With Dimples Applied To A Single Wall
… study is an investigation of the heat transfer augmentation through the fully-developed portion of a narrow rectangular duct (AR=2) characterized by the application of dimples to the bottom wall of the channel. Experimental testing and numerical modeling is performed for full support and …
-
Heat Transfer Coefficient and Adiabatic Effectiveness Measurements for an Internal Turbine Vane Cooling Feature
Aircraft engine manufacturers strive for greater performance and efficiency by continually increasing the turbine inlet temperature. High turbine inlet temperatures significantly degrade the lifetime of components in the turbine. Modern gas turbines operate with turbine inlet temperatures well …