Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 31 for “"harmonic rejection"”.
-
Harmonic rejection mixers for wideband receivers
This dissertation presents novel Harmonic Rejection (HR) Mixer architectures to obtain a high level of harmonic rejection. This is achieved by reducing the sensitivity to mismatches in devices operating at high frequencies. Consequently, the HR performance for this mixer architecture is primarily …
-
A 40nm CMOS Single-Ended Switch-Capacitor Harmonic-Rejection Power Amplifier for ZigBee Application
… thesis describes a single-ended switch-capacitor harmonic-rejection power amplifier for the 915 MHz ISM band for ZigBee applications. A multipath feed-forward harmonic-rejection technique is employed to suppress the 2nd/3rd/4th harmonics of the switch-capacitor power amplifier (PA) by 48/17/24 dB, …
-
Design of a Low Power 70MHz-110MHz Harmonic Rejection Filter with Class-AB Output Stage
… FM transmitting feature. A low pass filter using harmonic rejection technique along with a low power class-AB output buffer is designed to meet the current market requirements on the FM transmitter chip. A harmonic rejection filter is designed to filter FM square wave signal from 70MHz to 110MHz …
-
Design of an Active Harmonic Rejection N-path Filter for Highly Tunable RF Channel Selection
… over a broad frequency range. Issues with harmonic transfer and poor attenuation limit the feasibility of using N-path filters in practice. The goal of this thesis is to design an integrated active N-path filter that improves upon the passive N-path filter’s poor harmonic rejection and …
-
Circuit techniques for the rejection of LO harmonics within CMOS Mixers
… mixers, where local oscillator (LO) harmonics can lead to downconversion of unfiltered interferers to baseband, along with the desired signal, thus degrading the signal-to-noise ratio. Recent broadband receivers utilize a harmonic rejection mixer to reject LO harmonics within the …
-
Design and implementation of band rejected antennas using adaptive surface meshing and genetic algorithms methods. Simulation and measurement of microstrip antennas with the ability of harmonic rejection for wireless and mobile applications including the antenna design optimisation using genetic algorithms.
… design of antennas is to suppress or attenuate harmonic contents due to the non-linear operation of the Radio Frequency (RF) front end. The objectives of this work were to investigate, design and implement antennas for harmonic suppression with the aid of a genetic algorithm (GA). Several …
-
High Efficiency Class E Microwave Frequency Multipliers
… an intuitive evaluation of class E operation and harmonic content of the switch waveforms. The analysis is shown to be applicable to both class E amplifiers and multipliers, providing closed-form equations for an intelligent first design. The proposed class E tripler configuration is evaluated …
-
Integrated Radio-Frequency Receivers for RF-to-Digital Converters
… Blocker tolerance in wideband RF front-ends; 2) harmonic rejection RF-front ends with on-chip N-path filtering; 3) transmitter self leakage cancellation, and; 4) blocker rejection and sensitivity issues in direct delta sigma receivers. Starting from the detailed description of these challenges, …
-
Flexible Receivers in CMOS for Wireless Communication
… mixer. Paper II builds on the idea of 8-phase harmonic rejection, but simplifies it to a 6-phase solution that can reject noise and interferers at the 3rd order harmonic of the local oscillator frequency. This provides a good trade-off between the traditional quadrature mixer and the 8- phase …
-
Analysis And Design Of Wideband Passive Mixer-First Receivers
… instead of the traditional 4 has benefits beyond harmonic rejection extending to improved noise performance and increased impedance tuning range. This receiver exhibits low noise figure (~3dB), excellent wideband linearity (IIP3[GREATER-THAN OR EQUAL TO]25dBm), and unprecedented RF impedance …
-
Circuit techniques for programmable broadband radio receivers
… (ADC). Broadband mixing requires the use of a harmonic rejection mixer (HRM) or tunable band pass filter to remove harmonic mixing effects, which in the past have suffered from a large primary clock tuning range and high power consumption. However, direct sampling of the RF input requires a …
-
Concurrent multi-band Sawless receiver for wireless communications and GNSS applications
… maintaining robust performance through effective harmonic rejection. Key performance metrics—conversion gain, sensitivity (noise figure), selectivity (out-of-band rejection), linearity (IIP2, IIP3, and -1 dB compression point), and impedance matching demonstrate excellent selectivity across a wide …
-
Comparison of synchronization techniques for generation of firing pulses for a HVDC converter
… to improve the dynamic response, robustness, harmonic rejection and stability of the converter system. These new techniques consist of an enhanced PLL and 3-phase PLL based on the DQZ method. A variety of these new synchronization techniques are investigated and compared with a conventional …
-
Rf Low Pass Filter Design And Fabrication Using Integrated Passive Device Technology
… optimization of both the inductors and IPD harmonic filters. The effective use of EM simulation enables us to realize the successful development of high performance harmonic filters. To make the optimization be more flexible and also for a deeper understanding of the optimization theory, …
-
Wideband and High-Performance Millimeter Wave Circuit Designs with SiGe BiCMOS Technology
… trade-offs among bandwidth, efficiency, and harmonic suppression. To overcome these constraints, this work introduces innovative topologies for Wilkinson power dividers, voltage-controlled oscillators (VCOs), and frequency multipliers, implemented in a 130 nm SiGe BiCMOS process. A Wilkinson …
-
Circuits and architectures for broadband radio receivers and spectrum channelizers
… receiver that employs a bank of two-stage harmonic rejection mixers (HRMs) is described. Each HRM internally synthesizes a distinct downconversion LO, while using a fixed high-frequency master clock. The HRMs also implement a quadrature phase matching technique for enhancing image …
-
Design Techniques for Timing Circuits in Wireline and Wireless Communication Systems
… (QVCO), dividers and harmonic rejection single sideband mixer (HR-SSBmixer) are combined to synthesize the desired frequency range without posing much phase noise penalty on the QVCO. The QVCO adopts a new phase-shift scheme to improve phase noise and to eliminate …
-
Evaluation of a TX-chain for Cognitive Radio Applications
… and 2.900-3.100 GHz. The design implements a harmonic rejection mixer, which relaxes the filter demands of the design. In terms of chip area and power efficiency, the results strongly suggest that the proposed design has an advantage compared to a more conventional design. The suggested …
-
Wide band electro-optic intensity modulator frequency response measurement using optical heterodyne, Down-conversation Technique
… wide band photodiodes. In addition, the harmonic rejection feature of our system is described. Our system "rejects" higher order harmonics, due to the non-linearities, generated in the DUT with proper selection of the modulation and the shift frequencies. This feature means that our …
-
Characterization of various types of power amplifiers
… and specifications also include gain, 2FO/3FO harmonic rejection, noise, stability, ruggedness, leakage power etc. This thesis introduces the fundamental principles and knowledge of various types of power amplifiers and highlights their unique pros and cons among the different topologies. A …
Page 1 of 2