Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 101 for “"high switching frequency"”.

  1. A Unified Approach to Dynamic Modeling of High Switching Frequency PWM Converters

    … for dynamic modeling of the PWM and soft-switching power converters. Dynamic modeling of non-linear power converters is very important for the design and stability of their closed loop control. While the use of equivalent circuits is often preferred due to simulation efficiency issues, no …

    ucf Repository record for A Unified Approach to Dynamic Modeling of High Switching Frequency PWM Converters (opens in a new tab)

  2. Investigation of ultra-high switching frequency to reduce size in rapid capacitor charging

    … in 10ms or less. The 50kV charger required a higher output voltage with a considerably lower input voltage requirement of 40-50VDC and was required to operate repetitively at 200Hz. Transformer, voltage multiplier, circuit board layouts, and battery system designs and tests are all covered.

    ttu Repository record for Investigation of ultra-high switching frequency to reduce size in rapid capacitor charging (opens in a new tab)

  3. Improving the performance of passive components of the power electronics at high switching frequency

    … switches, the power converter can be operated at high frequencies. However, the magnetic components are suffering from their parasitic capacitance at high frequencies. Modeling the parasitic capacitance of the magnetic components is crucial to design power converters at high frequency. To date, …

    msu Repository record for Improving the performance of passive components of the power electronics at high switching frequency (opens in a new tab)

  4. Design of a high switching frequency interleaved step-up converter with digital interface for Power Factor Correction applications

    … controlled switches can be used as a PFC. High frequency switching gives the advantage of physically small boost stage inductors and filters. The purpose of this thesis was to investigate the possibilities of utilizing high switching frequencies while maintaining a high efficiency. A short …

    chalmers Repository record for Design of a high switching frequency interleaved step-up converter with digital interface for Power Factor Correction applications (opens in a new tab)

  5. Condition monitoring of SiC MOSFETs on LLC resonant converter

    … are widely acknowledged for low loss, fast switching and remarkable thermal conductivity compared to silicon (Si) counterparts. SiC-based power electronic converters, therefore, are optimal when operated at medium voltage to high voltage in high switching frequency applications, which …

    uiuc Repository record for Condition monitoring of SiC MOSFETs on LLC resonant converter (opens in a new tab)

  6. Investigation of High-density Integrated Solution for AC/DC Conversion of a Distributed Power System

    … because of its modularity, maintainability and high reliability. Due to limited space and increasing power consumption, power supplies for telecom and server systems are required to deliver more power with smaller volume. As the key component of DPS system, front-end AC/DC converter is under the …

    vt Repository record for Investigation of High-density Integrated Solution for AC/DC Conversion of a Distributed Power System (opens in a new tab)

  7. Design and Evaluation of a Single Phase 5 Level Full Bridge Neutral Point Clamped Multi Level Converter

    … content and reduced voltage stress in the switching devices. A detailed study of the MLC topologies and modulation techniques is presented. Space vector modulation is analysed and implemented to evaluate the converter. A comprehensive assessment of the MLC is presented using wide bandgap …

    whiterose Download PDF for Design and Evaluation of a Single Phase 5 Level Full Bridge Neutral Point Clamped Multi Level Converter (opens in a new tab)

  8. Discovering semiconductors for power electronics through first-principles computations

    … electronics must efficiently convert power at high operating voltage and switching frequency, within a compact size. State-of-the-art SiC and GaN wide bandgap semiconductor devices cannot meet all future demands. Ultrawide bandgap alternatives theoretically improve conversion performance but …

    colo-mines Repository record for Discovering semiconductors for power electronics through first-principles computations (opens in a new tab)

  9. A Single-Phase GaN Totem-Pole Bridgeless PFC with an H-Bridge Active Power Decoupling

    … The proposed topology assures the achievement of high efficiency with unity power factor and high-power density with minimum losses over a wide range of voltages. Moreover, the GaN Totem-Pole PFC with the H-Bridge APD has shown a significant enhancement on the total energy storage requirement in …

    tamu Repository record for A Single-Phase GaN Totem-Pole Bridgeless PFC with an H-Bridge Active Power Decoupling (opens in a new tab)

  10. Characterizing and modeling methods for power converters

    … factor. With the evolution of technology, the switching frequency in a power converter is pushed to a higher frequency range, e.g., several MHz or even higher, to decrease its size. However, the loss generated in the converter increases drastically due to the high switching frequency. In …

    must-thes Repository record for Characterizing and modeling methods for power converters (opens in a new tab)

  11. Novel Full Bridge Topologies for VRM Applications

    … it has narrow duty cycles when it operates at high switching frequency with low output voltage (for example 1V). Narrow duty cycles yield high switching loss which limits the switching frequency of Buck; making it difficult to design a Buck based VRM that can achieve high efficiency at a high …

    queens Repository record for Novel Full Bridge Topologies for VRM Applications (opens in a new tab)

  12. Modeling and Simulation of Soft Switching in Traction Inverter

    In this thesis, two soft switching inverter topologies the Active Clamped Resonant DC Link Inverter (ACRDCLI) and theAuxiliary Resonant Commutated Pole Inverter (ARCPI) are designed. Their performance is compared with the Hard Switched Inverter (HSI) in simulations. In order to ensure the balance …

    chalmers Repository record for Modeling and Simulation of Soft Switching in Traction Inverter (opens in a new tab)

  13. Decision tree modulators for power electronics applications

    <p>This dissertation describes a new high performance, high switching frequency modulation method for power inverter applications. The new method, adaptive decision tree modulation, is a generalized method of inverter modulation that uses an inductive inference method to create decision tree …

    utk-theses Repository record for Decision tree modulators for power electronics applications (opens in a new tab)

  14. Efficient Control of the Series Resonant Converter for High Frequency Operation

    … are the major driving factors behind high frequency operation of switching power supplies. However, high speed operation is limited by topology, control, semiconductor, and packaging technologies. The inherent mitigation of switching loss in resonant converters makes them prime …

    queens Repository record for Efficient Control of the Series Resonant Converter for High Frequency Operation (opens in a new tab)

  15. Comparison Of Single Stage And Two Stage Stage Grid-tie Inverters

    … DC-DC converter on the input followed by a high switching frequency SPWM (Sinusoidal Pulse Width Modulation) stage to produce the required low frequency sine wave output. The novel second design approach employs a similar DC-DC input stage capable of being modulated to provide a rectified …

    ucf Repository record for Comparison Of Single Stage And Two Stage Stage Grid-tie Inverters (opens in a new tab)

  16. Development of a power electronics for a flywheel energy storage system

    … scheme is proposed to solve this problem. Third, high-switching frequency is necessary for the flywheel charger/discharger in order to reduce the size/weight of the system and to synthesize the high-frequency motor/generator current waveforms. A working prototype demonstrates that a high …

    vt Repository record for Development of a power electronics for a flywheel energy storage system (opens in a new tab)

  17. Controller implementation and performance evaluation of a high power three-phase active power filter using controller hardware-in-the-loop simulation

    This thesis presents a demonstration of Real-Time High-Speed controller hardware-in-the-loop (CHIL) testing for a digital signal processor (DSP) -based controller of a shunt active power filter (APF) for medium voltage (MV) grid power quality improvements. A recently developed Real-Time and …

    manitoba Repository record for Controller implementation and performance evaluation of a high power three-phase active power filter using controller hardware-in-the-loop simulation (opens in a new tab)

Page 1 of 6