Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 18 of 18 for “"higher-mode effects"”.
-
Design of Controlled Rocking Steel Frames to Limit Higher Mode Effects
… fully limit the peak seismic forces because of higher mode effects. If a structure is designed to account for these effects, it may be uneconomical, but if it is not designed to account for them, it may be unsafe. The purpose of this thesis is to develop recommendations for the design of …
-
Uncoupled Base Rocking and Shear Mechanisms for Controlling Higher-mode Effects in High-rise Buildings
While modern seismic design philosophies prioritize life safety under major earthquakes, structural damage is not precluded. As for high-rise buildings, earthquake-induced damage can be rather extensive and exacerbated as a result of higher-mode effects. This may lead to repair and replacement …
-
Self-Centering, Shear-Controlling Rocking-Isolation Podium System for Enhanced Resilience of Tall Buildings
… is to properly account for the contribution of higher modes of vibrations to the overall dynamic response of these structures, especially for reinforced concrete shear wall structures that are commonly used in tall building developments. It has been widely acknowledged that the actual seismic …
-
Seismic Response of Low -Rise Shear Wall Structures With Flexible Diaphragms
… estimate peak interstory drifts that account for higher mode effects are described for low-rise perimeter shear wall structures. The proposed methods are based on the principal modes obtained from a principal components analysis (PCA) of computed inelastic dynamic responses. The method can …
-
Linear transients in pneumatic transmission systems using state variable methods
… lines or systems is a difficult task. Accurate models exist, but they are not particularly adaptable for simulation purposes. In this paper an approximate transient analysis technique is developed for the dissipative model. The method is based on partial fraction expansion of pertinent transfer …
-
Studies on the Design and Behavior of Strongback Braced Frames
… vary. Designing the spine is challenging, as higher mode effects and partial nonlinear mechanisms have been shown to be significant. The results show that two proposed SBF-specific design methods provide value over a control procedure. Both SBF-specific methods produce designs with reserve …
-
Analytical and empirical seismic fragility analysis of irregular URM buildings with box behavior
… nonlinear analyses. The structural component model and pushover analysis seem preferable to be adopted in these methods as fast analytical tools. In general, the nonlinear static procedures assume that the building dynamic response is governed by the main translational mode. Thus, there is a …
-
Απόκριση κατασκευών σε σεισμικές διεγέρσεις του εγγύς-πεδίου
… spectrum to take account of the near-fault effects; (c) the assessment of existing methods for seismic design of new and existing structures for near-fault earthquakes. In order to define the near-fault region a process is applied based on the satisfaction of appropriate damage criteria. …
-
Resistance of reinforced concrete cantilever shear walls to seismic shear demands
… related to the amplifications of demands due to higher mode seismic shear, however, there has been little research regarding the resistance of these structures to higher mode seismic shear demands. It is theorized that due to the lack of experimental data on which more complex shear models could …
-
Seismic response of high-rise zipper braced frame structures with outrigger trusses
… (CBF) structures provide high stiffness and moderate ductility, while they are prone to damage concentrated within a single floor. To overcome this drawback, researchers have proposed to add a vertical member to the CBF system, labeled a “zipper column”, with the aim to involve the buckling …
-
Seismic shear demand in reinforced concete cantilever walls
… the dynamic amplification of shear force due to higher mode effects. Current design codes either do not account for this phenomenon, or vary considerably in the approach they take. In order to determine the reason for the variation, previous research is first examined, and it is found that the …
-
Strategic placement of viscous dampers for seismic structural design
… design ground motions be used for the SSSA Mode and Lavan A/R methods as well as caution against removal of upper storey damping, which prompts susceptibility to larger roof drifts due to higher-mode effects.</p><p>Various brace-damper arrangements were explored to determine strategic …
-
Seismic Response of a Full-scale 5-story Steel Frame Building Isolated by Triple Pendulum Bearings under 3D Excitations
… TPB element with a general friction model that accounts for the variation of friction coefficients on both velocity and vertical force was developed to predict the response of individual TPB and the overall isolation system. The element accounts for both vertical-horizontal coupling …
-
Seismic Behavior of Tall Rocking Mass Timber Walls
… were used to validate the proposed numerical modeling methodology. Next, a performance-based design process, including methods for preliminary design and detailed evaluation with nonlinear response history analysis, was used to design the lateral system for a full-scale 10-story mass timber …
-
Inelastic response of torsionally unbalanced multistorey shearwall buildings designed using elastic static and dynamic analyses
… of torsionally precarious structures. The effects of torsion on building response is a complex problem for even single storey structures because so many parameters are involved in the description of linear and nonlinear torsional response. Discrepancies exist between the results of many …
-
Fragility Assessment of Steel Frames under Post-Earthquake Hazards
… hazard. The concentrated plasticity model is an efficient approach to finite element modeling for seismic loading in OpenSees. However, the fire module relies exclusively on a distributed plasticity model to represent the temperature gradient across the section depth. Thus, the …
-
An Improved Static Seismic Design Method for Podium Structures with Vertical Irregularity of Mass and Stiffness
… that are not well-addressed by the current model codes. Specifically, mid-rise structures are increasingly incorporating a vertical combination of seismic force-resisting systems, in which a stiff and massive lower podium structure (e.g. a reinforced concrete moment resisting frame) is used …
-
Ultimate Limit States in Controlled Rocking Steel Braced Frames
… member forces are greatly influenced by the higher-mode response, resulting in more complex methods to design the frame members. This thesis begins by outlining two new design procedures for the frame members in controlled rocking steel braced frames that target both simplicity and accuracy. …