Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 11 of 11 for “"hooked bar"”.
-
Code provisions and practical design examples of hooked bar anchorage
In structural concrete, hooked bars are used to shorten anchorage length when the requirements for straight bar anchorage cannot be provided within the available dimensions of elements. The objective of this study was to provide an overview of hooked bar anchorage. Design examples and structural …
-
Hooked Bar Anchorages and their Use in Noncontact Lap Splices
… tension forces across discontinuous reinforcing bars to allow for continuity of load path in structural elements. Lap splices of straight reinforcing bars present a number of disadvantages when used in connections of large precast concrete elements typical of bridge substructure. Most …
-
Effectiveness of Alternative Reinforcing Strategies for Non-Contact Hooked Bar Lap Splices
… achieve this, bridge engineers have been using hooked bars in the closure joints in lieu of straight bars, with the assumption that this would allow for shorter splice lengths. Though engineers in practice are doing this, design guidance does not exist. One research project by Coleman (2024) …
-
ANCHORAGE STRENGTH OF STANDARD HOOKED BARS IN SIMULATED EXTERIOR BEAM-COLUMN JOINTS
The current ACI hooked bar design provisions are based on test results of 38 simulated beam-column joints containing two hooked bars. The provisions address the effects of hooked bar surface condition, concrete cover, amount of confining reinforcement confining the hooks, and type of concrete …
-
Anchorage Strength of Conventional and High-Strength Hooked Bars in Concrete
Key factors affecting the anchorage strength of hooked bars are investigated and design guidelines for the development length of hooked bars that apply to both conventional and high-strength steel and concrete are presented. In this study, 337 beam-column joint specimens were tested. Parameters …
-
The Effectiveness of Hooks for Plain Steel Reinforcement
… have not been trained with or worked with plain bar. Modern American Concrete Institute (ACI) and Canadian Standards Association (CSA) Group codes largely do not contain adequate provisions to assess the structural integrity of many historic buildings. Twenty-four beam-column joint specimens with …
-
ANCHORAGE OF HIGH-STRENGTH REINFORCING BARS WITH STANDARD HOOKS
Hooked bars are often used to anchor reinforcing steel where concrete dimensions are not sufficient to provide the required development length for straight reinforcement, such as in external beam-column joints. The purpose of this study is to expand the understanding of the behavior of hooked bars …
-
Compression Lap Splices of Straight Bars and Compression Development of Headed and Hooked Bars in Beam-Column Joints
… for compression lap splices and for headed and hooked bar development in special moment frame (SMF) joints were evaluated against databases of test results. Recommendations are made for simplifying and improving code requirements.Compression lap splice length provisions (ACI 318-19 §25.5.5) were …
-
BEHAVIOR OF EARTHQUAKE-RESISTANT REINFORCED CONCRETE COLUMN-FOUNDATION CONNECTIONS
… concrete column-foundation connections with hooked column longitudinal bars were performed to investigate the mechanisms of moment-transfer and breakout failure. Two tests were conducted and then analyzed in combination with results from four tests reported in Niyonyungu (2024) and one test …
-
DEVELOPMENT OF LARGE HIGH-STRENGTH REINFORCING BARS WITH STANDARD HOOKS AND HEADS
Hooked and headed reinforcing bars are viable alternatives for development of reinforcing steel when member geometry does not allow for a straight deformed bar to fully develop its yield strength. Current design provisions in ACI 318-19 Building Code impose limitations on the use of hooked and …
-
ANCHORAGE OF HIGH-STRENGTH REINFORCING BARS IN CONCRETE
Hooked and headed reinforcing bars are commonly used as a means of shortening development length of reinforcing bars, but a limited amount of previous research has resulted in restrictions on their use in practice. This study included two phases: In the first phase, 31 tests of simulated …