Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 14 of 14 for “"inductive peaking"”.
-
Transimpedance amplifier design using 0.18 um CMOS technology
… extension technique called shunt-series inductive peaking. A discussion of the different methods of bandwidth extension using inductive peaking is included, and the optimal configurations for maximally flat responses are shown for shunt inductive peaking,series inductive peaking, and …
-
A Proposed Large Signal Active Inductor in CTLE Applications
… Time Linear Equalizer (CTLE) design with a novel inductive-peaking active inductor for a 14Gb/s NRZ optical Analog Front-End (AFE) application in TSMC65nm CMOS technology. This CTLE design utilizes an additional feedforward path that provides extra gains at higher frequencies and a novel active …
-
Ultra-Wideband LNA Designs in Advanced SiGe BiCMOS Technology
… noise and wide bandwidth are resistive feedback, inductive emitter degeneration, gain staggering, and inductive peaking. The UWB LNA designs are implemented in an advanced SiGe BiCMOS process. The devices used in these designs are high performance heterojunction bipolar transistors (HBT) offered …
-
A silicon photonics receiver for multi-level signaling in short-reach optical interconnects
… Cherry Hooper post-amplifier. Series and shunt inductive peaking techniques are employed to improve the front-end's frequency response and custom designed inductors with stacked metal spirals are designed to minimize footprint. The Cherry Hooper and additional following post-amplifying stages …
-
Research and design of high-speed advanced analogue front-ends for fibre-optic transmission systems
… edges of the signal and bandwidth extensions by inductive peaking and different local feedback techniques. These techniques have been applied to a transmitter and receiver developed for advanced modulation formats such as PAM-4 (4 level pulse amplitude modulation). Such modulation format can …
-
Lumped silicon photonic Mach-Zehnder modulators for high-speed optical interconnects
… source impedance and controlled amounts of inductive peaking to reduce the need for transmitter-side precompensation.
-
Low-Noise Mixing Circuits in CMOS Microwave Integrated Circuits
… that operates at 5.4 GHz in 0.18 um CMOS. An inductive degenerated LNA is used as the transconductor. Together with a current bleeding circuit, a gain of 13.1 dB and a low 7.8 dB single-sideband noise figure are achieved. The circuit was fabricated and measured. Simulation and measurement …
-
Pulsed RF Circuits for Ultra Wideband Communications and Radar Applications
… 1.3 ns for switching speeds as high as 200 MHz. Inductive peaking is introduced in the noise cancelling topology to achieve a sub-4dB flat noise figure and a high gain of 16.6 dB for frequencies up to 10 GHz. The average power consumption is also below 10 mW with a 50% duty cycle clock.
-
Broadband Low-Noise CMOS Mixers For Wireless Communications
… and current bleeding techniques. Series inductive peaking is used to extend the bandwidth. Gain variation is achieved by a current-steering IF stage. Measurements show a wide gain control range of 13 dB and a low noise performance over the entire frequency and gain range. The lowest DSB …
-
All-Pass Delays and Residue Amplifier for a 10-GS/s Non-Blocking Subranging ADC
… and amplification (RGA) stage that employs inductive peaking and a tunable-gain post-amplifier reaching a high gain and a wide bandwidth, for a 10-GS/s, 8-bit NBS-ADC intended for radio telescope applications.
-
Digital mm-Wave Transmitters
… CMOS inverter topologies, with resistive and inductive feedback, selective differential-mode inductive peaking, and series stacking are analyzed. These techniques are demonstrated for an optical front-end at 60 Gb/s, with record 4.3-Vpp single-ended output swing, in a 28-nm FD-SOI CMOS …
-
High-Speed Low-Power Optical Transmitter and Receiver Front-End in 12nm CMOS FinFET Process
… board.On the receiver side, a modified series inductive peaking bandwidth (BW) extension technique is employed to improve the BW and noise performance of the inverter-based transimpedance amplifiers (TIAs). In this design, the open-loop gain-BW product (GBP) of the main amplifier is increased …
-
Laser Driver Design in 0.18 um CMOS Technology
… buffer, while stage two consists of a shunt inductively peaked differential pair using active inductors. A differential pair composed of large transistors is used in an open drain configuration for the output stage. Measurements of S-parameters are presented which accurately agree with …
-
Broadband Linear Modulator Driver Design for High-data-rate Wireline Communications
… modulators through the driver's 9-dB gain peaking. The core of the design revolves around a two-stage broadband amplifier, incorporating a novel shunt/double-series interstage network to achieve amplitude peaking at 75 GHz and extended bandwidth. The interstage network is optimized to …