Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 37 for “"interface Trap density"”.

  1. Effects of Depth Variation of Substrate Dopant Impurity Concentration on the Interface Trap Density Determination in Mos Devices (Semiconductor)

    … concentration variation with depth on the interface trap density determination using the high-frequency capacitance-voltage (HFCV) or Terman method with a constant dopant concentration assumption has been quantitatively studied. A systematic correction scheme for nonconstant dopant …

    uiuc Repository record for Effects of Depth Variation of Substrate Dopant Impurity Concentration on the Interface Trap Density Determination in Mos Devices (Semiconductor) (opens in a new tab)

  2. Electronic devices based on 2D material: fabrication, characterization and analysis

    … nitride (BN) capacitors, we extracted the interface trap density and time constant and found that the interface trap density in Al2O3 is about 10 times that in BP/BN capacitors, indicating the superior quality of the single-crystal BN. We confirmed that the interface trap density increases …

    uiuc Repository record for Electronic devices based on 2D material: fabrication, characterization and analysis (opens in a new tab)

  3. Total-dose gain degradation in modern bipolar transistors.

    … damage densities: the net oxide charge density and the midgap-level interface-trap density. Hardness assurance testing recommendations are made based on the observed experimental trends.

    arizona-thes Repository record for Total-dose gain degradation in modern bipolar transistors. (opens in a new tab)

  4. Influence of SiNx/Si interface states on Si solar cells

    Impact of the SiN_x/n^+-Si interface on silicon solar cell performance was investigated, where SiN_x is used as a passivation layer. Significant shifts in capacitance, conductance and leakage current characteristics were observed for metal/SiN:H/n^+-Si MOS capacitor when it was subjected to a …

    njit Repository record for Influence of SiNx/Si interface states on Si solar cells (opens in a new tab)

  5. PROCESS IMPROVEMENT IN 0.152 CMOS FOR PLASMA INDUCED DAMAGE IN GATE CURRENT PERFORMANCE

    … to measure the gate current performance. The interface trap density is characterized by Terman's method and high and low frequency C-V method. Based on the hypothesis and comparison of similar technologies, two splits have been carried out. The change of inter layer dielectric (ILD) materials …

    nus Repository record for PROCESS IMPROVEMENT IN 0.152 CMOS FOR PLASMA INDUCED DAMAGE IN GATE CURRENT PERFORMANCE (opens in a new tab) Download file for PROCESS IMPROVEMENT IN 0.152 CMOS FOR PLASMA INDUCED DAMAGE IN GATE CURRENT PERFORMANCE (opens in a new tab)

  6. BETA-GALLIUM OXIDE LATERAL FIELD-EFFECT TRANSISTORS: FABRICATION AND PERFORMANCE

    … advantage of fin geometry in mitigating the high interface trap density on the top surface of (0 1 0) β-Ga2O3 was also shown in this research. Besides, the ?-Ga2O3 fin dry etching has been studied to optimize the FinFET performance. Factors impacting the fin waist narrowing, including the thermal …

    cornell Repository record for BETA-GALLIUM OXIDE LATERAL FIELD-EFFECT TRANSISTORS: FABRICATION AND PERFORMANCE (opens in a new tab)

  7. Interface studies of rare earth oxides on silicon and germanium substrates

    In recent decades, the high-k/semiconductor interface is gaining much interest due to miniaturization of devices. The first part of this dissertation investigates the mechanisms behind interface dipole formation which is important for advanced gate stack engineering. Electron affinity and band …

    nus Repository record for Interface studies of rare earth oxides on silicon and germanium substrates (opens in a new tab) Download file for Interface studies of rare earth oxides on silicon and germanium substrates (opens in a new tab)

  8. Advanced III-V MOSFET

    … of all, beryllium oxide (BeO) is considered as interface passivation layer for InGaAs MOSFETs. In order to apply BeO onto InGaAs, the chemical and mechanical properties are first studied. Liquid BeO precursor is never used in ALD systems. The chemical properties of ALD BeO film are revealed from …

    texas Repository record for Advanced III-V MOSFET (opens in a new tab)

  9. Modeling and Characterization of 4H-SIC MOSFETs: High Field, High Temperature, and Transient Effects

    … phonon scattering, Coulomb scattering from interface traps, and surface roughness scattering. High temperature models for interface trap density of states and occupation probability of interface traps are also implemented. By rigorous comparison of simulated I-V characteristics to …

    maryland Repository record for Modeling and Characterization of 4H-SIC MOSFETs: High Field, High Temperature, and Transient Effects (opens in a new tab)

  10. Deposition and Characterization of Silicon Nitride/gallium Arsenide Metal Insulator Semiconductor Structures With Heteroepitaxial Interlayers

    … examining the insulator/semiconductor interface are complemented by in situ analyses such as reflection high electron energy diffraction, scanning tunneling microscopy, and x-ray photoelectron spectroscopy as well as ex situ spectroscopic ellipsometry and high resolution transmission …

    uiuc Repository record for Deposition and Characterization of Silicon Nitride/gallium Arsenide Metal Insulator Semiconductor Structures With Heteroepitaxial Interlayers (opens in a new tab)

  11. Interfacial Structures of Oxides on GaAs

    … oxide among others shows a low interface trap density (D$\rm\sb{it})$ at the oxide-GaAs interface. It is low enough to warrant the demonstration of both n- and p-channel enhancement GaAs MOSFETs. High-resolution transmission electron microscopy (HRTEM) indicates that deposition …

    uiuc Repository record for Interfacial Structures of Oxides on GaAs (opens in a new tab)

  12. Metal-assisted chemical etching of β-gallium oxide

    … β-Ga2O3 MOS capacitor structures, and the lowest interface trap density extracted from etched interfaces is only 2.73×1011cm-2-eV-1, which is comparable to that of other published values of unetched β-Ga2O3 surfaces. This confirms that MacEtch is an effective etching method for producing high …

    uiuc Repository record for Metal-assisted chemical etching of β-gallium oxide (opens in a new tab)

  13. Investigation of electrical and material characteristics of high-k / III-V MOS devices and SiOx ReRAMs

    … stable insulators that passivate the interface, which is also the main driving force in the research area of high k/III-V stack. One of the main focuses of this dissertation is developing a fabrication process flow to lower the interface trap density to enhance the performance of …

    texas Repository record for Investigation of electrical and material characteristics of high-k / III-V MOS devices and SiOx ReRAMs (opens in a new tab)

  14. Solution-processed zinc sulphide and magnesium oxide for thin film transistors applications

    … and a subthreshold swing of 10 V/dec, with an interface trap density of 3.5 × 10¹³ cm⁻². These findings demonstrate the potential of ZnS as an effective semiconductor material for TFTs. The second phase of the research examined ZnS films deposited using zinc diethyldithiocarbamate as a single …

    lancaster Download PDF for Solution-processed zinc sulphide and magnesium oxide for thin film transistors applications (opens in a new tab) Embargoed until 2028-08-01

  15. Electronic Structure of SiC/SiO2 by Density Functional Theory

    … main problem of SiC-based devices is the great density of imperfections at the SiC/SiO2 interface, which not only degrades the device performance but also causes reliability problems coming from the extreme operating conditions. The quality of the interface affects the channel mobility of …

    maryland Repository record for Electronic Structure of SiC/SiO2 by Density Functional Theory (opens in a new tab)

  16. Crystalline perovskite epitaxial growth on germanium (001) by atomic layer deposition

    … films and ALD-grown SrHfO3 films have the same interface structure, which has a 2×1 periodicity and with the alkaline earth metal (AEM) atoms between the Ge dimer rows. This result indicates that the ALD growth proceeds by forming the same Zintl-template layer that is purposely formed in MBE …

    texas Repository record for Crystalline perovskite epitaxial growth on germanium (001) by atomic layer deposition (opens in a new tab)

  17. Study of MoS2/high-k Interface and Implementation of MoS2 Based Memristor for Neuromorphic Computing Applications

    … the superior quality of 2D/high-? dielectric interfaces by fabricating MoS2 based FET transistors with different gate dielectrics. This low interface trap density of ~7x10^10 states/cm2-eV at the MoS2/Al2O3 interface establishes the case for van der Waals systems where the superior quality of …

    ucf Repository record for Study of MoS2/high-k Interface and Implementation of MoS2 Based Memristor for Neuromorphic Computing Applications (opens in a new tab)

  18. Nanoelectronics based on epitaxial oxides

    … as an approach to alleviate the gate dielectric interface quality problem that has tremendously hampered the adoption of next-generation Ge-based transistors. Different methods are shown to effectively decrease the interface trap density, and the gate stacks developed in this dissertation …

    texas Repository record for Nanoelectronics based on epitaxial oxides (opens in a new tab)

  19. STATIC CURRENT AND VOLTAGE TECHNIQUES FOR CMOS RELIABILITY CHARACTERIZATION

    … corresponding to the recombination current via interface traps in the channel region and in the LDD region, respectively. The stress-induced oxide charge shifts the peaks while the interface trapped charged causes a spread of the peaks. The peak height versus the forward emitter bias is used to …

    nus Repository record for STATIC CURRENT AND VOLTAGE TECHNIQUES FOR CMOS RELIABILITY CHARACTERIZATION (opens in a new tab) Download file for STATIC CURRENT AND VOLTAGE TECHNIQUES FOR CMOS RELIABILITY CHARACTERIZATION (opens in a new tab)

  20. III-V Devices for Emerging Electronic Applications

    … highly transparent superconductor-semiconductor interfaces. High-quality interfaces between superconductors and semiconductors are crucial for the implementation of gate-tunable hybrid superconductor-semiconductor qubits known as gatemon qubits. This thesis explores the potential of utilizing …

    lund Repository record for III-V Devices for Emerging Electronic Applications (opens in a new tab) Download PDF for III-V Devices for Emerging Electronic Applications (opens in a new tab)

Page 1 of 2