Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 15 of 15 for “"interfacial cracks"”.
-
Dynamic Analysis of Interfacial Cracks in Composite Laminates
The interfacial crack in composite laminates has been of great interest as composite materials are widely used today. In this paper, the order of dynamic stress singularity of interfacial cracks is derived, and a hybrid finite element method is successfully developed for this problem. Both the …
-
MICROSTRUCTURE MODIFICATION OF Cu0.2Ag2.8SbSeTe2 THROUGH
… microstructure. Normally cast samples exhibit cracks forming near the interfaces of the two phases. In this work we show that the cracks are caused by a low temperature monoclinic to cubic phase transition that occurs in the Ag2Te phase. We demonstrate that through rapid quenching we can …
-
Multiple Wave Scattering and Calculated Effective Stiffness and Wave Properties in Unidirectional Fiber-Reinforced Composites
… m, B and Y for fiber-reinforced composites with interfacial layers between fibers and matrix. The material properties of the layers are assumed to be either linearly or exponentially distributed between the fibers and matrix. A concise formula is obtained where parameters can be computed using a …
-
Infrared techniques for quantitative evaluation of interfacial fracture behaviour and damage tolerance in sandwich structures
… (TSA) is used to establish the stress state at interfacial cracks. In the vicinity of growing interfacial cracks large and discontinuous motion occurs that has a deleterious effect on TSA, therefore a new motion compensation (MC) method is required. The thesis describes how the MC was developed …
-
Nanoindentation of thin organic films and self-assembled monolayers
… of the bulk. It has also been observed that interfacial cracks actually grow in these interphase regions. Thus it is important to understand the mechanical behavior of materials in such thin materials. Self-assembled monolayers (SAMs) provide well-controlled models for such studies. They are …
-
A discrete modeling approach for progressive failure analysis of composite laminates and filament-wound pressure vessels
… but also indicate that discrete damage/cracks cannot be properly modeled by homogenized elements. We then attempt to model a tow break with interfacial cracks in a composite overwrap with traditionally used FE methods, but various kinds of erroneous results are observed, showing that the …
-
Effect of moisture on mixed-mode TSR on a glass/epoxy interface
The understanding of interfacial failure in adhesively bonded structures is important for several sectors including transportation and infrastructure. This problem has motivated studies for several decades. Adhesives are polymeric and, as such, present time, temperature, strain rate and moisture …
-
HYGROTHERMALLY-INDUCED DELAMINATION AND CRACKING IN PLASTIC IC PACKAGES
… may exist in bonded interfaces. These small interfacial defects induce very high stress concentrations around the defects leading to debonding and delamination growth. If the total stress intensity factor generated by the loading due to the hygrothermal stresses and steam pressure is higher …
-
Effect of morphological features of fuel cell cathodes on liquid water transport
… electrochemical activity in the catalyst layer. Cracks and interfacial voids are typical of catalyst layers in operating cells, and are thought to affect water management and other transport properties such as gas diffusion and conductivity. This thesis investigates the effect of such …
-
Nanoscale Structure and Properties of High-Performance Polymer Fibers and Nanoreinforced High-Temperature Resins
… observed in fiber fibrillation during failure. Interfacial separation energy measured at this scale for the first time correlated with and explained differences in fibrillation tendencies between UHMWPE and PPTA fibers. The newly measured separation energy exhibited power-law scaling with …
-
Experimental and theoretical study of on-chip back-end-of-line (BEOL) stack fracture during flip-chip reflow assembly
… zone models and parameters to study such interfacial cracks in sub-micron thick microelectronic layers. This work focuses on developing framework based on cohesive zone modeling approach to study interfacial delamination in sub-micron thick layers. Such a framework is then successfully …
-
Sensitivity Analysis of Interface Fatigue Crack Propagation in Elastic Composite Laminates
… of the work shed more light on mechanisms of interfacial crack propagation under cyclic shear in the case of a curved B/Ep-Al composite laminate. Moreover, the outcome of the sensitivity gradients demonstrated some advantages for using the sensitivity analysis to pinpoint directions for the …
-
Fundamental investigations on high temperature interactions of alumina-carbon refractories with molten iron at 1550 °C - implications for refractory recycling
… the chemical interactions occurring both in the interfacial region as well as in the bulk of the refractory. The sessile drop technique was used to determine the interfacial wetting behaviour and the phase transformations during the chemical reactions were determined using SEM, EDS and X-ray …
-
Real time resistance monitoring technology for microjoining process and reliability test
… resistance signals show rise until open, and cracks are observed from cross sectioning studies of failed samples. From the second PCB design with a larger resistor size, under the same stressing condition, the Sn57.6Bi0.4Ag solder joints show insignificant resistance change and become grainy …
-
Πρόβλεψη μη γραμμικής συμπεριφοράς και διάδοσης ρωγμής σε συνθήκες θερμομηχανικής κόπωσης με τη μέθοδο των συνοριακών στοιχείων
… and damage tolerance of structures with existing cracks. However, there exists a category of structures that experience severe thermal cycling that acts alongside the mechanical loads. Such structures include cooling system pipes, pressure vessels, pistons and combustion chambers of internal …