Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 43 for “"large mode area"”.
-
Bending losses in large mode area holey fibres
… the potential offered by holey fibres in the large-mode-area, single-mode regime, and to place their performance in context against conventional step-index fibres. In the study presented here, numerical and experimental techniques have been developed that are capable of accurately evaluating …
-
Power Scaling Of Large Mode Area Thulium Fiber Lasers In Various Spectral And Temporal Regimes
… to the experimental results, theoretical modeling of thulium fiber amplifier operation, simple thermal management analysis, as well as practical fiber and system design considerations for future power scaling are presented. Experimental and theoretical results of this work will enable the …
-
Measuring photodarkening from Yb doped fibers
… benchmarking and spectral studies on single-mode fibers was developed, and a similar alternative method was developed for large-mode-area fibers. Both approaches were studied experimentally and by simulations. Additionally, an experimental setup was built to study the spatial photodarkening …
-
Applications Of Volume Holographic Elements In High Power Fiber Lasers
… Output powers can be further scaled using large mode area fibers, however, at the cost of beam quality and instabilities due to the presence of higher order modes. The mechanisms limiting the performance of narrow-linewidth large mode area fiber lasers are investigated and solutions using …
-
New quantitative phase imaging modalities on standard microscope platforms
… of these new methods were evaluated using modelling and simulation as well as experimentation with known test cases. In addition to the development of new methods, existing methods for quantitative phase imaging were applied to characterize the effects of manufacturing, cleaving, and fusion …
-
Novel sensor and telecommunication applications of photonic crystal fibers
… attracted great interest in many research areas such as in nonlinear optics and measurement science as their manufacturing process allows for a high flexibility in the fiber design. Index-guiding photonic crystal fibers are commonly referred to as microstructured fibers whereas hollow-core …
-
Advanced Specialty Fiber Designs for High Power Fiber Lasers
… factors, namely nonlinear effects and transverse mode instability, prohibiting the power scaling capability of fiber lasers. The nonlinear effects, originating from high optical intensity, primarily limit the peak power scaling. The mode instability, on the other hand, arises from quantum-defect …
-
Microstructured tellurite glass fibre laser development.
… microstructured tellurite fibres which included large mode area fibres, motivated by the desire to fabricate a double clad fibre and the development of small core fibres which were used in the fibre laser experiments (Chapter 3). A spectroscopic study of the erbium III doped glass including …
-
Picosecond Yb-Doped Fiber Amplifier
… research is to study the YDFA by developing a model and building a YDFA setup in free space configuration. The active fiber used in the setup is a few modes, polarization-maintaining double-cladding ytterbium-doped large mode area (LMA) fiber and the length is 1m. The pump used is a tunable …
-
Two-Colour Nonlinear Amplification for Mid-infrared Generation by Difference Frequency Generation
… results being achieved with the use of a large-mode- area Yb:fiber. We demonstrate a two-colour laser source with colours centered at 1070 nm and 1120 nm with individual bandwidths of 30 nm and 21 nm respectively. This two-colour spectrum was amplified up to a total power of 6.76 W, with a …
-
Design And Implementation Of a High-Power Fiber Amplifier For Diamond Raman Laser Pump
… third and final amplifier stage uses an extra large mode area(XLMA) fiber for decreasing irradiance of the signal with in the fiber and thus mitigating the unwanted nonlinear effects at the output when the system will be pulsed. Engineering designs will be presented for fiberized components …
-
Development of High-power Single-mode Yb-doped Fiber Amplifiers and Beam Analysis
… compactness and ruggedness. However, single-mode fiber power scaling has stagnated in the past years, primarily due to the onset of nonlinear effects such as stimulated Brillouin/Raman scattering and transverse modal instabilities. This thesis addresses the analysis and mitigation of …
-
High Average Power Nanosecond Pulsed Tm:Fiber Laser for Pumping an Optical Parametric Oscillator
… peak powers. The amplifier stage consists of a large mode area, thulium-doped, step-index fiber seeded with powers up to 2 W from the oscillator. An output energy of 700 µJ with 81 ns pulse width, was achieved at a wavelength of 1.9 µm. The effect of the fiber holder temperature on the amplifier …
-
High Power Single-Frequency 976 nm Fiber Laser Source and its Frequency Doubling for Blue Laser Generation
… including high-brightness low-noise single-mode pumps for neodymium (Nd3+), ytterbium (Yb3+), or erbium (Er3+)-doped lasers and nonlinear frequency converters for visible and deep-UV laser generation, atom cooling, remote sensing, and spectroscopy. So far, several 100-W-level fiber laser …
-
High power pulsed thulium doped fibre lasers and their applications
… To exploit the peak power scalability of a large-mode-area (LMA) thulium doped fibre (TDF), a three-stage MOPA structure was first demonstrated to produce 1-MHz, 52-ps pulses with a maximum average/peak output power of 3.94 W/76 kW. A fourstage configuration was proposed to enhance the …
-
Machine Learning in Fiber Optics
… stabilize the imaging performance through multimode fibers (MMFs). We show that if the state of the MMF is traced closely, the output images can be used as probes to correct the image reconstruction inverse mapping. Robustness is increased through the AIP method but still quite limited by the …
-
Nonlinear effects in multimode optical fibers
Utilizing the modes of a multimode fiber forms a frontier between what is achievable with current fibre technology and what is required for the remainder of the 21st century. Large mode area multimode fibers accommodate the high power delivery demanded by fiber lasers used in industry for precision …
-
Nonlinear Phenomena In Higher Order Mode Fiber For Development Of Light Sources For Biomedical Imaging
Higher order mode (HOM) fibers present a breakthrough in fiber design, in its ability to provide anomalous dispersion in solid, silica-based fiber below 1300 nm. Anomalous dispersion is especially interesting for purposes of short-pulse propagation, since soliton propagation requires this sign of …
-
Ultrafast Lasers and Amplifiers based on Yb-doped Gain Materials
… a traditional grating compressor, and two single mode preamplifiers complete the front-end of the system, generating 100 mW output at rates ranging from 0.1 MHz to 1 MHz. Two diode-pumped, large-mode-area, ytterbium-doped fibers provide high power amplification. A large-core fiber amplifier …
-
Pulsed Tm-fiber Laser For Mid-ir Generation
… interest due to its long emission wavelength, large bandwidth (~1.8 – 2.1 µm), high efficiencies (~60 %), and high output power levels both in cw as well as pulsed regimes. Applications like remote sensing, machining, medical tissue ablation, and mid-infrared generation benefit from high peak …
Page 1 of 3