Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 6 of 6 for “"longitudinal weld"”.

  1. DEVELOPING A DESIGN METHODOLOGY FOR REINFORCING CRACK-LIKE DEFECTS IN THE LONGITUDINAL ELECTRONIC RESISTANCE WELDED SEAMS OF TRANSMISSION PIPELINES

    … 1920 and 1970 were typically constructed using a welding process known as electronic resistance welding, or ERW. At the time, this welding process was susceptible to multiple quality control problems which created small inclusions and flaws at the longitudinal weld seam at the time of manufacture. …

    tamu Repository record for DEVELOPING A DESIGN METHODOLOGY FOR REINFORCING CRACK-LIKE DEFECTS IN THE LONGITUDINAL ELECTRONIC RESISTANCE WELDED SEAMS OF TRANSMISSION PIPELINES (opens in a new tab)

  2. Sandwich Plate System Bridge Deck Tests

    … Next, fatigue tests were performed on the longitudinal weld between two sandwich plate panels. Two connections were tested to 10 million cycles, one connection was tested to 5 million cycles, and one connection was tested to 100,000 cycles. The fatigue class of the weld was determined and …

    vt Repository record for Sandwich Plate System Bridge Deck Tests (opens in a new tab)

  3. The Effect of Residual Stress Distribution on the Ultimate Strength of Tubular Beam-Columns

    Using data for the longitudinal residual stress distribution in welded steel tubes, curves describing these distributions are selected for study. Each of these curves are checked for static balance across the tube cross section. The curves that exhibit an imbalance are adjusted by a combination of …

    portland-state Repository record for The Effect of Residual Stress Distribution on the Ultimate Strength of Tubular Beam-Columns (opens in a new tab)

  4. The evolution of microstructure during porthole die extrusion of Al-Mg-Si alloys and its effect on plastic deformation near the weld seam

    … dies are often employed, which result in longitudinal weld seams of disturbed microstructure and crystallographic texture, as well as variable mechanical properties. In this research, extrusion through a simple porthole die was studied. The alloy used in this work contained Mn and Cr, …

    ubc Repository record for The evolution of microstructure during porthole die extrusion of Al-Mg-Si alloys and its effect on plastic deformation near the weld seam (opens in a new tab) Download PDF for The evolution of microstructure during porthole die extrusion of Al-Mg-Si alloys and its effect on plastic deformation near the weld seam (opens in a new tab)

  5. Seismic Evaluation of Welded Moment-resisting Connections

    Welded moment-resisting connections are used in the rigid frames of high-rise buildings. Most of the standards specify full penetration butt welds as a suitable type of weld for welding beam flanges to the column flange in seismic areas. New Zealand’s steel design standard is the only standard that …

    auckland-ms Repository record for Seismic Evaluation of Welded Moment-resisting Connections (opens in a new tab)

  6. Behavior Of Fillet Welds In Skewed Joints

    Fillet weld connections are very common in steel structures because they are easier and cheaper than other types of welded connections, such as groove welds. Several studies were performed on fillet weld of right dihedral angle, such as T-joints weld, to specify its capacity and failure mechanisms …

    uab Repository record for Behavior Of Fillet Welds In Skewed Joints (opens in a new tab)