Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 59 for “"melt phase"”.

  1. Processing melt blended polymer nanocomposites using a novel laboratory mini-mixer. Development of polymer nanocomposites in the melt phase using a novel mini-mixer.

    … with the Creep and Recovery, Viscosity and Phase Angle properties in the molten state. This approach was also used in an additional set of experiments whereby the temperature, speed, residence time and compatibiliser were kept constant but the clay loading was increased in 1% wt. increments. …

    bradford Repository record for Processing melt blended polymer nanocomposites using a novel laboratory mini-mixer. Development of polymer nanocomposites in the melt phase using a novel mini-mixer. (opens in a new tab)

  2. Processing melt blended polymer nanocomposites using a novel laboratory mini-mixer. Development of polymer nanocomposites in the melt phase using a novel mini-mixer.

    … with the Creep and Recovery, Viscosity and Phase Angle properties in the molten state. This approach was also used in an additional set of experiments whereby the temperature, speed, residence time and compatibiliser were kept constant but the clay loading was increased in 1% wt. increments. …

    bradford Repository record for Processing melt blended polymer nanocomposites using a novel laboratory mini-mixer. Development of polymer nanocomposites in the melt phase using a novel mini-mixer. (opens in a new tab)

  3. Free Radical Processes in Plasma Functionalisation of Polyolefins in the Melt State

    … This work extends this approach to the melt phase, an area where its use has been comparatively limited. The thesis examines the radical reactions that arise when molten polyolefins are exposed to plasma. Characterisation of plasma‑treated low‑density polyethylene shows that plasma …

    auckland-ms Repository record for Free Radical Processes in Plasma Functionalisation of Polyolefins in the Melt State (opens in a new tab)

  4. An Examination of Sea Ice Spring and Summer Retreat in the Canadian Arctic Archipelago: 1989 to 2010

    … ice retreat processes in the CAA follow a four-phase process: a slow ice melt phase that usually lasts until early June (phase 1); a quick melt phase with large daily sea ice extent change which lasts close to half-a-month (phase 2); a slow melt phase that looks like slow sea ice melt or even a …

    waterloo Repository record for An Examination of Sea Ice Spring and Summer Retreat in the Canadian Arctic Archipelago: 1989 to 2010 (opens in a new tab)

  5. Polypropylene Modified by Polydimethylsiloxane in Catalytic Cross Metathesis Reactions

    … possibility that cross metathesis of olefins in melt phase could be used to produce polydimethylsiloxane (PDMS) modified polypropylene (PP). The intention of this project was also to study and quantify relationships among the main experimental factors in the reaction: temperature, catalyst …

    waterloo Repository record for Polypropylene Modified by Polydimethylsiloxane in Catalytic Cross Metathesis Reactions (opens in a new tab)

  6. Crystal-Amorphous Transformation Via Defect-Templating in Phase-Change Materials

    Phase-change materials (PCM) such as GeTe and Ge-Sb-Te alloys are potential candidates for non-volatile memory applications, because they can reversibly and rapidly transform between a crystalline phase and an amorphous phase with medium-range order. Traditionally, crystal-amorphous transformation …

    penn Repository record for Crystal-Amorphous Transformation Via Defect-Templating in Phase-Change Materials (opens in a new tab)

  7. Light-induced structural transition and reflectivity of a silica-gallium interface

    … in the range 12 °C to 36 °C, across the solid to melt phase transition. Transient pump-probe reflectivity measurements revealed the dynamics of a silica-gallium interface reflectivity change in the visible part of the spectrum for the first time. Reflectivity rise times of a few ps were observed …

    soton Download PDF for Light-induced structural transition and reflectivity of a silica-gallium interface (opens in a new tab)

  8. Part I - Access to UV photocured nanostructures via selective morphological trapping of block copolymer melts. Part II - Morphological phase behavior of poly(RTIL) containing block copolymer melts

    … fidelity translation of block copolymer based melt-state morphologies into their equivalent solid analogs. Cationic photoacids were combined with partially epoxidized polyisoprene-b-poly(ethylene oxide) (PI-PEO) block copolymers, forming composite blends that allow for extended thermal …

    colostate Repository record for Part I - Access to UV photocured nanostructures via selective morphological trapping of block copolymer melts. Part II - Morphological phase behavior of poly(RTIL) containing block copolymer melts (opens in a new tab)

  9. A reactive melt modification of polyethylene terephthalate

    … of polyethylene terephthalate in the melt phase with low molecular weight multifunctional glycidyl compounds as reactive additives. Polyethylene terephthalate undergoes chain extension and/or branching reactions with the additives that result in modified rheological properties suitable …

    njit Repository record for A reactive melt modification of polyethylene terephthalate (opens in a new tab)

  10. Processing and characterization of boron nitride composites and films

    … shown that the treatment of the oligomer in the melt phase can enhance the crystallinity of the final BN. The stability, electrical properties, wear, and mechanical behavior of BN matrix composites are then presented. The substitution of a BN matrix in place of a carbon matrix is shown to enhance …

    uiuc Repository record for Processing and characterization of boron nitride composites and films (opens in a new tab)

  11. Chromium Modified Crystallization of Silicon Thin Films Crystallized by Flash Lamp Annealing

    … of silicon and randomized void formation during melt-phase crystallization [2]. Chromium underlayers have been successfully used [3] to promote silicon adhesion in thicker films, but there are many potential interactions between Cr and Si, such as the formation of silicides and generation of …

    rit Repository record for Chromium Modified Crystallization of Silicon Thin Films Crystallized by Flash Lamp Annealing (opens in a new tab)

  12. Analysis of Droplets and Bubbles in Crystal Growth Processes: Migration and Engulfment

    … as sapphire and silicon being grown from the melt, bubbles could enter the melt phase and make their way into the crystal by the process of engulfment. This is very commonly observed in sapphire crystals. There is also a chance for growth instabilities during certain solution growth processes, …

    umn Repository record for Analysis of Droplets and Bubbles in Crystal Growth Processes: Migration and Engulfment (opens in a new tab)

  13. Spectroscopic and Electrical Characterization of Cr:Al:ZnSe Gain Elements

    … Initially, the study explores annealing in the melt phase as an alternative to vapor annealing for doping optimization. The results demonstrate successful liquid annealing methods that preserve favorable optical characteristics of the samples. An alternative approach utilizing Se vapor annealing …

    uab Repository record for Spectroscopic and Electrical Characterization of Cr:Al:ZnSe Gain Elements (opens in a new tab)

  14. Formation Mechanism and Computational Modelling of Isle of Rum Plagioclase Stellates

    … diffusion of simplified plagioclase in the melt phase. Isothermal phase transitions modelled via first order chemical reactions are subsequently coupled with stochastic dynamics at the crystal growth front to simulate energy minimization processes including twinning during crystallization in …

    ottawa-retro Repository record for Formation Mechanism and Computational Modelling of Isle of Rum Plagioclase Stellates (opens in a new tab)

  15. Deciphering Biomass Fragmentation using Millisecond Microreactor Kinetics

    … includes thousands of reactions through multiple phases occurring in less than a second. The underlying chemistry of lignocellulose decomposition has been studied for decades, and numerous conflicting mechanisms and kinetic models have been proposed. The fundamental science of biomass pyrolysis is …

    umn Repository record for Deciphering Biomass Fragmentation using Millisecond Microreactor Kinetics (opens in a new tab)

  16. Oxidation studies of a novel barrier polymer system

    … formed during oxidation of the models in the melt phase, to free radical products and to a lesser extent as a catalyst for the initiation of the oxidation reaction by complex formation with the amide, which is more likely to take place in the solid phase. An oxidation cycle has been proposed …

    aston Download PDF for Oxidation studies of a novel barrier polymer system (opens in a new tab)

  17. Mineralogy and petrology of the Buck claim lithium pegmatite, Bernic Lake, southeastern Manitoba

    … without the direct involvement of a silicate melt phase. Subsequent to formation most of the primary assemblage of the dike was altered during an extensive phase of albitization. Hydrothermal and supergene alteration and depostion are evident as late stage processes of limited extent...

    manitoba Repository record for Mineralogy and petrology of the Buck claim lithium pegmatite, Bernic Lake, southeastern Manitoba (opens in a new tab)

  18. Impact of material attributes & process parameters on critical quality attributes of the amorphous solid dispersion products obtained using hot melt extrusion

    The feasibility of hot melt extrusion (HME) was explored for development of amorphous solid dispersion systems. Controlled release formulations were developed using a cellulose based derivative, AffinisolTMHPMC 100cP and 4M grades. BCS class II drugs ibuprofen and posaconazole were selected due to …

    bradford Repository record for Impact of material attributes & process parameters on critical quality attributes of the amorphous solid dispersion products obtained using hot melt extrusion (opens in a new tab)

  19. Quantifying primary producer phenology in the Canadian Arctic using submersed oceanographic sensors and satellite remote sensing

    … variables were used to identify snow and sea-ice melt phase timing. The results revealed a relationship between light availability and surface primary producer timing and magnitude. Specifically, an 18-day difference in the length of ice algal blooms between 2017 and 2019 was observed, with both …

    manitoba Repository record for Quantifying primary producer phenology in the Canadian Arctic using submersed oceanographic sensors and satellite remote sensing (opens in a new tab)

  20. Glass Forming Ability and Relaxation Behavior of Zr Based Metallic Glasses

    … of preparing metallic glasses from the liquid melt phase and how the properties of metallic glasses change due to relaxation need to be understood better. The glass forming ability (GFA) with variation in composition and inclusion of different alloying elements was studied by using thermal …

    tamu Repository record for Glass Forming Ability and Relaxation Behavior of Zr Based Metallic Glasses (opens in a new tab)

Page 1 of 3