Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 13 of 13 for “"pulse-echo method"”.
-
Ultrasonic system models and measurements
… impedance and its sensitivity. A new model-based method for simultaneously determining the impedance and sensitivity of commercial ultrasonic immersion transducers is developed. This method is based on a pulse-echo setup and relies only on electrical measurements. It is demonstrated that …
-
Ultrasonic ranging system for gait analysis
<p>A new method of measuring range for gait analysis is described. The method is based on a coherent measurement of the phase shift of an ultrasonic signal as a function of range.</p><p>A prototype of the ranging system was breadboarded, tested, and found to have a relative accuracy of better than …
-
Low Temperature Phase Transitions of Gadolinium and Ytterbium Using Resonant Ultrasound Spectroscopy
… Previous studies of these materials utilized a pulse-echo method that is not as robust as RUS. The advantagesof RUS include the ability to study very small samples and the ability to obtain all elastic properties of the sample from a single frequency spectrum. A laboratory system was developed …
-
Detection of an artificial defect and influence of sand on the damping of a pressure pulse in a pipeline section
… The generation and detection of the acoustic pulse is non-intrusive and can be performed with just an electrical contact of the pipe. Acoustic pulses are generated by a pulsed magnetic field. In the investigation, the magnetic pressure in a coil generates the acoustic pulses. The pulses …
-
Surface wave techniques for the study of engineering structures and materials
A wire drive pulse echo method of measuring the spectrum of solid bodies described. Using an 's' plane representation, a general analysis of the transient response of such solids has been carried out. This was used for the study of the stepped amplitude transient of high order modes of disks and …
-
High-temperature elastic constants of gold single-crystals
… gold wires using the thin-line ultrasonic pulse-echo method. The adiabatic elastic constants $c\sbsp{\rm ij}{\rm S}$ ($c\sb{11}$, $c\sb{12}$, $c\sb{44}$) were measured on two, high purity, gold single-crystals: (100) and (110) orientations. A modulus defect was observed for each of the …
-
Structural Health Monitoring Using Multiple Piezoelectric Sensors and Actuators
… and actuators. The basic idea utilizes the pulse-echo method often used in ultrasonic testing, together with wavelet decomposition to extract traveling pulses from a noisy signal. The results for a one-dimensional structure show that we can determine the damage location to within a spatial …
-
The characterisation of multiple defects in components using artificial neural networks
… three kinds of non-destructive test: an impact method that sent a stress wave through the component, an analysis of natural frequencies, and an ultrasonic pulse-echo method. The inputs to the ANNs were data from the numerical model, and the outputs were the x and y co-ordinates of the defect in …
-
Modelling and testing of a piezoelectric sensor for defect detection in steel rods using acoustic guided waves
… rods remains elusive. However, a promising method for corrosion detection is being explored that is based on acoustic guided waves. An acoustic pulse is transmitted into a steel rod using a piezoelectric element. The transmitted wave echoes off of any defects which may be present, letting …
-
An Ultrasonic Method to Measure Thin Surface Coatings and Films Using A Superimposed Standing Wave
… to acceptable risk levels. Ultrasound methods can be used to measure a coating/film layer thickness that is out of direct reach. Most pulse-echo ultrasonic methods use a time-of-flight through the layer to determine its thickness. As the layer becomes thinner, the reflected echoes …
-
Využití termografické metody pro diagnostiku betonových mostů
… termografii, georadaru a ultrazvukové pulse-echo metodě. Na základě výsledků disertační práce byly vypracovány doporučení pro použití termografické zkušební metody v praxi.
-
Využití ultrazvukové odrazové metody pro diagnostiku konstrukcí
Bakalářská práce se zabývá popisem nedestruktivních diagnostických metod, které jsou v praxi běžně používány. Důraz je kladen na ultrazvukovou odrazovou metodu, její princip a možné uplatnění při diagnostice železobetonových konstrukcí. Při praktických úlohách byla tato metoda aplikována na různých …