Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 157 for “"rectangular channel"”.
-
Turbulent flow through a rectangular channel
… at 80 normal locations across a two-inch high rectangular water channel. A two polarization, three beam He-Ne Laser-Doppler Velocimetry system was used. The water channel was specifically designed and constructed to facilitate these optical measurements. It had negligible vibration and flow …
-
Flow of suspensions in a rectangular channel
… distributions in the vertical plane of a rectangular channel. These measurements provided considerable insight into the fundamental mechanisms of suspension of solids. This in turn led to the developnent of theoretical expressions for the prediction of the concentration and velocity …
-
Heat Transfer Enhancement in Rectangular Channel with Compound Cooling Techniques
… flow configurations were considered, a uniform channel flow setup as well as a jet impingement setup. There were a total of sixteen cases performed for the experiment, eight for the channel flow and eight for the jet impingement. The types of cases that were performed were: a smooth surface …
-
Velocity profiles for the transition region in an open rectangular channel
… from laminar to turbulent flow in an open channel was investigated by means of velocity profiles. Water was used as the experimental fluid. The velocity profiles were measured by a hot-wire anemometer. The flow was varied over a range of Reynolds numbers from 1084 to 32,208. All velocity …
-
Heat transfer studies on a rectangular channel with offset plate fins
… heat transfer characteristics of a liquid cooled rectangular channel, containing offset plate fins were investigated experimentally. The selected geometry was a 10x model of the fluid circulation passages in the commercially available SEM-E type electronic cooling modules. The test surface …
-
An experimental study of Taylor-Goertler vortices in a curved rectangular channel
A rectangular cross section channel, designed and built by R. McKee to create the laminar secondary Taylor-Goertler vortex flow, was modified to expand the experimental investigation of the vortex flow. The modification allowed the hot wire anemometer, used to obtain velocity profiles, to be moved …
-
An experimental study of Taylor-Goertler vortices in a curved rectangular channel.
A rectangular cross section channel, with both a straight and a curved portion, was designed and built to create the laminar secondary Taylor-Goertler vortex flow. An aerosol was used to visualize these flow patterns, and photographs of the results are presented. A hot wire anemometer investigation …
-
Prediction Relations for Pressure Drop Across Finned Sections in a Rectangular Channel
… range of about 20,000 to 70,000. The fins were rectangular in shape and the tests run in a rectangular channel. A total of four hundred and thirty two test runs were made.
-
Experimental Two-Phase Flow Characterization of Subcooled Boiling in a Rectangular Channel
… using HFE-301 refrigerant ow through a vertical rectangular channel with one heated wall. Measurements were performed at liquid Reynolds numbers of 3309, 9929 and 16549 over a wall heat flux range of 0.0 to 64.0 kW=m2. From the PTV measurements, liquid two dimensional turbulence statistics are …
-
The development and structural characteristics of Dean vortices in a curved rectangular channel
… and structure of Dean vortices in a curved channel were measured and studied. A 40:1 aspect ratio channel with mild curvature was employed. Circulation of mean streamwise vorticity, and maxima of streamwise, spanwise and radial components of vorticity increase as the Dean number increases …
-
Isothermal helium flow measurements twrough a rectangular channel for a Wide Knudsen range
… the isothermal steady flow of Helium through a rectangular microchannel from the continuum to the free-molecular regime. The intention is to expand the measured Knudsen number range for rectangular cross section microchannels as compared with that presently found in in the literature. As …
-
STUDY OF TWO-PHASE VOID FRACTION IN A RECTANGULAR CHANNEL USING CAPACITANCE SENSOR
… flow calibration loop. The sensor consists of rectangular acrylic duct made of four side plates with dimensions 6 inches x 4 inches x 0.2 inches (length x width x thickness) and one square base with the edge of 5 inches. Eighteen fully threaded copper screws served as electrodes are attached to …
-
Investigation of Flow Field Structures in a Rectangular Channel with a Pin Fin Array
… of circular pin fins with 8 rows of 7.5 pins in rectangular channel with Reynolds number varying from 10,000 to 20,000. The Pin array is in a staggered configuration with stream wise (Y/D) spacing of 2.5 and span wise (X/D) spacing of 2.5, and height to pin diameter (H/D) of 2. A supplemental …
-
Pressure Drop And Endwall Heat Transfer Effects Of Porous Turbulators In A Rectangular Channel
… of a staggered array of porous pin fins within a rectangular channel. The porous pin fins were made from aluminum and had a pore density of 10 pores per inch (PPI). The pressure drop through the channel was also determined for several flow rates and presented in terms of the friction factor. Local …
-
PIV Measurements of Turbulent Flow in a Rectangular Channel over Superhydrophobic Surfaces with Riblets
… characteristics of turbulent flow in a channel where one of the walls has riblets, superhydrophobic microribs, or a hybrid surface with traditional riblets built on a superhydrophobic microrib surface. PIV measurements are used to find the velocity profile, the turbulent statistics, and …
-
Observations from a series of flume experiments on contraction scour along a rectangular channel
To view the abstract, please see the full text of the document.
-
Heat transfer enhancement for turbulent flow through blockages with elongated holes in a rectangular channel
… of blockages with elongated holes in a rectangular channel was studied. The rectangular channel has a width-to-height ratio of 12:1. The blockages have the same cross section as that of the channel. The diameter of all elongated holes of the blockages is three quarters of the channel …
-
An incompressible three-dimensional turbulent boundary layer on the floor of a recurving rectangular channel
… in any single profile. A recurving or s-shaped rectangular channel was used to experimentally investigate the possible existence of such a turbulent boundary layer flow. The time average velocity profiles along the centerline of this channel were obtained with a hot film anemometer. The …
-
Large smooth cylindrical elements located in a rectangular channel : upstream hydraulic conditions and drag force evaluation
… of small cylindrical elements located in large channels cannot be transferred to the case of a large roughness elements placed in small channels. The introduction of LWD in a small channel can generate a significant modification of the upstream hydraulic conditions. This modification has direct …
Page 1 of 8