Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 96 for “"saturation temperature"”.

  1. Heat transfer enhancement due to bubble pumping in FC-72 near the saturation temperature.

    The use of boiling heat transfer in the liquid immersion cooling of electronic components has always been hampered by the excessive superheat necessary to initiate nucleation in the fluorinated hydrocarbons used as dielectric cooling fluids. In an attempt to overcome some of these difficulties, an …

    nps Repository record for Heat transfer enhancement due to bubble pumping in FC-72 near the saturation temperature. (opens in a new tab)

  2. Linear growth rates of single copper sulfate crystals

    … were grown under controlled conditions of supersaturation, solution velocity, and temperature.</p><p>The data from this work indicates that:</p><p>(a) Crystal growth rate is independent of crystal size for the size range covered (4 to 12 mesh).</p><p>(b) Crystal growth rate is directly …

    njit Repository record for Linear growth rates of single copper sulfate crystals (opens in a new tab)

  3. Heat Transfer and Pressure Drop During Condensation of Refrigerants in Microchannels

    … kg/m2-s and quality 0 < x < 1 at four different saturation temperatures between 30 and 60oC. The results obtained from this study capture the effect of variations in mass flux, quality, saturation temperature, hydraulic diameter, and channel aspect ratio on the observed pressure drop and heat …

    gatech Repository record for Heat Transfer and Pressure Drop During Condensation of Refrigerants in Microchannels (opens in a new tab)

  4. 3D Computational Modeling of Multiphase Phenomena in Boiling Heat Transfer

    … bubble growth with a sharp interface and with a saturation condition. In addition, 3D modeling of bubble growth leads to simulations with millions of computational cells and requires expensive computer resources with multicore capabilities. The present work proposes methods to perform …

    rit Repository record for 3D Computational Modeling of Multiphase Phenomena in Boiling Heat Transfer (opens in a new tab)

  5. Crystal growth of potassium aluminum sulfate under nonuniform conditions

    … free region was observed. The degree of supersaturation and saturation temperature had an effect on the growth rate. The Reynolds number, degree of supersaturation, saturation temperature and the jet to crystal distance had an effect on the inclusion free diameter. The supersaturation at the …

    iastate Repository record for Crystal growth of potassium aluminum sulfate under nonuniform conditions (opens in a new tab)

  6. Internal Combustion Engine Coolant Jacket design guidelines study with 3D CHT-CFD

    … to the coolant jacket design. By using CHT, the temperature eld within both the coolant and solid regions can be simulated within a common model. In this master thesis, a parameter sensitivity analysis has been performed on a cylinder head of a SI engine using a 3D-CHT-CFD model. The analysis …

    chalmers Repository record for Internal Combustion Engine Coolant Jacket design guidelines study with 3D CHT-CFD (opens in a new tab)

  7. The effect of oil on the onset of nucleate pool boiling of R-124 from a single horizontal tube

    … from a single horizontal tube was conducted at saturation temperature of 2.2 deg C. Pure R-124 and R-124/oil mixtures of 3% and 10% (by weight) miscible alkylbenzene oil were used. The tubes tested were: (1) smooth tube, (2) 19 fins per inch and (3) 26 fins per inch low-integral finned (GEWA-K) …

    nps Repository record for The effect of oil on the onset of nucleate pool boiling of R-124 from a single horizontal tube (opens in a new tab)

  8. THERMODYNAMIC PROPERTIES OF WATER FOR COMPUTER SIMULATION OF POWER PLANTS.

    … factor Z, in terms of pressure and temperature, was obtained by curve fitting, and the enthalpy, entropy, and internal energy were derived by standard relationships. Formulations for heat capacity, saturation temperature as a function of saturation pressure, the specific volume of …

    arizona-thes Repository record for THERMODYNAMIC PROPERTIES OF WATER FOR COMPUTER SIMULATION OF POWER PLANTS. (opens in a new tab)

  9. Analytical and computational modeling of multiphase flow in ferrofluid charged oscillating heat pipes

    … of the liquid-vapor phase interface, and a temperature-dependent model for interphase mass transfer by evaporation and condensation. Different model and numerical scheme combinations were investigated to identify an efficient and consistently accurate method using currently available …

    oklahoma-thes Repository record for Analytical and computational modeling of multiphase flow in ferrofluid charged oscillating heat pipes (opens in a new tab)

  10. ENHANCEMENT OF SATURATION BOILING OF PF-5060 DIELECTRIC LIQUID ON MICROPOROUS SURFACES

    … environmentally friendly, and has low enough saturation temperature (~ 54oC at 0.10 MPa). This helps maintain the chip junctions temperature below that recommended by the chip manufacturer (85-120 oC, depending on the application).'

    unm Repository record for ENHANCEMENT OF SATURATION BOILING OF PF-5060 DIELECTRIC LIQUID ON MICROPOROUS SURFACES (opens in a new tab)

  11. Control of nuclear propulsion plant power transients

    … excursions, minimize reactor coolant hot leg temperature and maximize boiler saturation temperature while maintaining average coolant temperature constant. Combinations of control rod movement and changes in reactor coolant flow rate are studied in order to determine the control systems that …

    nps Repository record for Control of nuclear propulsion plant power transients (opens in a new tab)

  12. Ebulição nucleada em placa plana horizontal com baixos fluxos de calor

    ln a horizontal copper disk inmersed in water at saturation temperature heat is transfered in steady state. Levels of heat flux are regulated so that free convection and then nucleate boiling are observed. The value of heat flux is determined experimentally and high speed film is used to register …

    brazil-uerj Repository record for Ebulição nucleada em placa plana horizontal com baixos fluxos de calor (opens in a new tab)

  13. Numerical Investigation of Heat and Mass Transfer Phenomena in Boiling

    … (i) computation of mass transfer with local temperature differences or with temperature gradients at cell-centers rather than with temperature gradients at the interface, (ii) modified discretization schemes at neighboring-cells or a transition region to account for the interface saturation …

    rit Repository record for Numerical Investigation of Heat and Mass Transfer Phenomena in Boiling (opens in a new tab)

  14. Heat Transfer in Boiling Dilute Emulsion with Strong Buoyancy

    … 100 W/cm2 or more, but must be maintained at low temperatures. So far, research on single phase convection and flow boiling in small diameter channels have yet to provide an adequate solution. Emulsions allow the engineer to tailor the solution to the specific problem. The fluid can be customized …

    umn Repository record for Heat Transfer in Boiling Dilute Emulsion with Strong Buoyancy (opens in a new tab)

  15. An Analytic Study of Microlayer Evaporation and Related Bubble Growth Effects in Nucleate Boiling

    … a high heat flux with only a relatively small temperature difference. The demand for a better understanding of the behavior of a liquid as it exceeds its saturation temperature and changes to vapor has been the result of design problems in liquid cooled rocket nozzles and nuclear reactor cores. …

    utk-theses Repository record for An Analytic Study of Microlayer Evaporation and Related Bubble Growth Effects in Nucleate Boiling (opens in a new tab)

  16. PREDICTION OF HEAT TRANSFER AND PRESSURE DROP OF CONDENSING REFRIGERANT FLOW IN A HIGH ASPECT RATIO MICRO-CHANNELS

    … study investigated the effects of variations in saturation temperature ranging from 30 oC to 70 oC, mass flux from 50 to 500 kg/m2s, and inlet super heat from 0 oC to 15 oC on the average heat transfer and overall pressure drop coefficient of the micro-channel condenser. In all cases the inlet …

    maryland Repository record for PREDICTION OF HEAT TRANSFER AND PRESSURE DROP OF CONDENSING REFRIGERANT FLOW IN A HIGH ASPECT RATIO MICRO-CHANNELS (opens in a new tab)

  17. CLATHRATE HYDRATE PROCESS FOR CARBON DIOXIDE CAPTURE FROM FUEL GAS

    … hydrate formation under high pressure and low temperature, the CO2 component is selectively enclathrated into the solid hydrate phase and thus separated from the gas mixture. The major challenge for this technology is to develop an efficient hydrate generation method. This thesis employed a …

    nus Repository record for CLATHRATE HYDRATE PROCESS FOR CARBON DIOXIDE CAPTURE FROM FUEL GAS (opens in a new tab) Download file for CLATHRATE HYDRATE PROCESS FOR CARBON DIOXIDE CAPTURE FROM FUEL GAS (opens in a new tab)

  18. Extreme Geotechnical Response to High Heat From Tunnel Fires

    … a severe fire, which typically involve extreme temperature and prolonged duration. Currently, there is little research being done in this area. An analytical model has been developed to predict the temperature rise of dry soil in the experimental soil column configuration and there is good …

    maryland Repository record for Extreme Geotechnical Response to High Heat From Tunnel Fires (opens in a new tab)

  19. A study of nucleate boiling in an accelerated system

    … The change in the heat flux as a function of the temperature difference AT between the wire temperature and the saturation temperature of the water was used as a comparison for the standard one and 2.85 times the standard gravitational field.

    rice Repository record for A study of nucleate boiling in an accelerated system (opens in a new tab)

  20. Optimization of the thermal design of a cryogenically-cooled computer

    … be implemented in order to maintain low board temperatures and avoid damage to the circuit components, in this paper, the performance and cost of three types of cryogenic cooling systems, the "once-through" system, the saturated pool boiling refrigerated sytem, and the subcooled pool boiling …

    ut-knoxville Repository record for Optimization of the thermal design of a cryogenically-cooled computer (opens in a new tab)

Page 1 of 5