Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 46 for “"shear crack."”.
-
Shear crack initiation and propagation in foam core sandwich structures
… analyses. Experiments were performed on sharp-cracked specimens using the compact-tension-shear (CTS) test loading device. Foams of three different densities were tested. The CTS specimen was, in association with a special loading device, an appropriate apparatus for experimental mixed-mode …
-
An analysis of an antiplane shear crack in a nonhomogeneous elastic medium
… release rate is calculated for an antiplane shear crack whose shear modulus corresponds to a reduced rigidity about the crack tip. Plastic zones about the crack tip are calculated based upon the yielding condition of von Mises, and the effect of decreasing rigidity upon these zones is …
-
Evaluating the Shear Behaviour of FRP-Reinforced Concrete Beams Using the Shear Crack Propagation Theory
… those of steel; therefore, the flexural and shear behaviour of FRP-RC members requires investigation. In general, predictions from flexural design equations are close to results from experimental data. However, shear strength predictions based on different modelling approaches can vary …
-
Shear Strengthening of RC Beams Using Externally Bonded and Anchored FRP U-wraps
Externally bonded FRP U-wraps are a common shear strengthening configuration for RC beams, however premature debonding of the wraps is a major problem, which limits the effectiveness and efficiency of the FRP strengthening. In this investigation a new π-shape carbon anchor was used to fasten the …
-
Finite Opening of Propagating Shear Cracks
Molecular Dynamics (MD) simulations of shear-dominated crack propagation by Abraham and Gao (2000) showed that there was finite crack opening when the crack propagated at a sub-Rayleigh speed while the crack opening became negligible when the crack propagated faster than the shear wave speed. On …
-
Development, Characterization, and Modeling of Ballistic Impact on Composite Laminates Under Compressive Pre-Stress
… the development of an impact initiated shear crack (IISC), and the shear failure of a pre-stressed composite due to impact. It was observed that the compressive failure threshold quadratically decreased in relation to the impact velocity up to velocities that caused partial penetration. …
-
Failure Mechanisms and Key Parameters of FRP Debonding from Cracked Concrete Beams
Intermediate crack (IC) induced debonding failure of Fiber Reinforced Polymer (FRP)-strengthened reinforced concrete beams starts at the tip of flexural/shear cracks within the shear span and propagates towards the FRP plate termination. In this study, experimental and numerical programs are …
-
Shear strength and bearing capacity of reinforced concrete deep beams
… distributed load at the top. It is found that a shear crack is formed along the line joining the inner edge of the support to the third point at the top level of the bean. The concrete block on the outer side of the crack rotates about the centre of pressure in the compression zone. Shear …
-
Experimental and analytical investigation of reinforced concrete bridge pier caps with an externally bonded stainless steel system
… equations were developed for calculating the shear strength of these types of structural elements when a diagonal shear crack is formed under loading. In addition, a combined strut-and-tie/truss model is proposed for determining the strength of reinforced concrete bridge caps with externally …
-
Active Retrofit of Shear Critical RC Components Using Self-Prestressing Iron-Based Shape Memory Alloys
… shape memory alloys (Fe-SMAs) as an active shear retrofit strategy for RC components. SMAs are a class of smart materials with the unique property of the shape memory effect, allowing them to fully recover plastic deformations when subsequently heated. By installing pre-strained Fe-SMA …
-
Fracture analysis of bridges by spline finite strip method
… primary objective of this thesis is to develop crack strip method and verify the convergency of the method, finally to perform fracture analysis of bridge structures using spline finite strip method. In this thesis, combining the shape function of spline finite strip with the eigenfunction …
-
Finite element analysis of failure modes in dynamically loaded pre-cracked steel plates
… study transient stresses and strains in the pre-cracked (pre-notched) 4340 steel plates impacted by a projectile in the direction of the notch ligament. The computations employed Johnson - Cook model which takes into account strain hardening, strain-rate hardening and thermal softening. An …
-
Development length of prestressing strand
… was studied. Load capacity of beams that cracked in web-shear appeared to be governed by the available development length from the shear-crack at the face of support. Flexural-shear crack was observed to be a critical section for development length requirement evaluation.</p>
-
Development of domain integral and generalized finite element methods for three dimensional analysis of near-surface cracking in flexible pavements
… in the analysis of classical bottom-up fatigue cracking of relatively thin flexible pavements, where tensile stresses and strains govern the behavior at the asphalt layer. However, elastic theories are incapable of predicting other pavement distresses, including near-surface cracking. Similarly, …
-
A study on geosynthetic-reinforced asphalt systems
… capacity as well as mitigation of reflective cracking. This research presents a study on various aspects relevant to geosynthetic-reinforced asphalts. Specifically, this thesis has been organized in three stand-alone sections: 1) Literature Review; 2) Overlay Testing; 3) Shear Fatigue Testing. …
-
Geophysical Signatures of Fracture Mechanisms
… and coalescence of new and pre-existing cracks. Methods based on the interpretation of seismic waves are of great interest because the waves can be used to probe internal damage in rock. The objective of this research is to characterize crack initiation, propagation, and coalescence …
-
Shear strengthening of reinforced concrete beams with externally bonded FRP composites: finite element modeling and parametric study
Shear failure in reinforced concrete (RC) beams has always been a major concern for engineers to deal with, particularly in deep beams such as RC girders. Nevertheless, with the use of fiberreinforced polymer (FRP) composites, this type of failure can be avoided. Using externally bonded (EB) FRP …
-
Experimental investigation on the shear characteristics of GFRP reinforcement systems embedded in concrete.
… This paper presents the results of the shear performance of GFRP reinforcement crossing varied crack angles. Fifteen push-off specimens were tested to investigate the shear characteristics of the GFRP and steel reinforcement. Tests were performed with three varied orientations of steel …
-
Experimental methods for investigating the effects of soil settlements and vibrations in cultural heritage buildings, induced by underground structures
… and high static loads, they have resulted in cracking, at relatively low number of cycles. As for the experimental works on the in-plane behavior in piers and spandrel specimens, under a vertical uplift, a sequential in-plane failure is identified through flexural and shear cracking in the …
-
Failure and deformation of rocks in compression for underground design
… of the pre-existing as well as stress-induced cracks. Different types of laboratory tests were employed to observe the different scales of cracks and to obtain different types of crack information. The crack information is dependent on the scale used. The cracks propagate along the …
Page 1 of 3