Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 14 of 14 for “"slag replacement"”.
-
LONG TERM DEFORMATIONS OF PORTLAND BLAST FURNACE SLAG CEMENT CONCRETE
… PBFC concrete containing Portland blast furnace slag cement (PBFC) were studied with particular reference to the effects of the percentage of ground granulated blast furnace slag (ggbs) in cementitious materials, fineness of slag, type of blending (interground and blended), water-binder ratio and …
-
Effects of Sodium Chloride on the Rheological Properties, Setting Time, Self-desiccation and Strength of Cemented Paste Backfill
… cementitious materials such as blast furnace slag. Therefore, this thesis examines the impacts of NaCl concentration and binder composition on the yield stress, viscosity, initial and final setting time, and strength development of CPB. A robust experimental program has been undertaken in …
-
The Effect of Cement and Blast Furnace Slag Characteristics on Expansion of Heat-Cured Mortar Specimens
… failure. Ground granulated blast furnace slag (GGBFS, slag) is often used in blended concrete mixtures for both economic and environmental purposes but it also possesses durability benefits. ACI 201.2R-16 (Guide to Durable Concrete) [2] recommends a minimum of slag replacement level of …
-
Designing High Performance Geopolymer Concrete Using Fly Ash and Slag
… geopolymer was developed using fly ash, slag, and alkali solution, which when combined with aggregate produces a material that has high compressive strength, acceptable workability, and suitable setting time. The compressive strength and setting time of fly ash-based geopolymer …
-
Gaining higher salt scaling resistance with slag concretes
Deicing salts are believed to influence slag concretes chemically and to better understand this, the hydration of portland cement and slag blends has been studied. It was found that hydrocalumite is formed during the hydration of these cementitious blends, which along with other AFm phases and …
-
A study of the durability in class-M concrete due to chlorid permeability
… the previous research done into the cementitious replacement of sla SCC's an effect on permeability. A replacement of cement with 50% slag was used to create the slag concrete, and a 9% addition of silica fume was used for the SCC concrete. During this study, three different concrete mix designs …
-
The Effect of Chemical Composition of Blast-Furnace Slag on Compressive Strength and Durability Properties of Mortar Specimens
… replace cement. Ground granulated blast furnace slag, for instance, is an industrial by-product of iron refinement and is frequently used in concrete mixture design to not only reduce cost, but also increase later-age strength as well as durability. However, published literature indicates that …
-
Evaluation of Resistivity Meters for Concrete Quality Assurance, Project TR201414
… paving mixture with 20% Class C fly ash and 30% slag replacement for cement also demonstrated low permeability as well as high compressive strength with an average value of over 9,000 psi at 90 days. The two repair mixtures showed moderate to low penetrability readings and high early strength …
-
Selecting material constituents and proportions for specific roller-compacted concrete mechanical properties
… Fly ash or ground granulated blast furnace slag replacement of cement statistically reduced the early-age RCC strength and likely would delay opening the RCC pavement to traffic. In general, fracture properties of RCC with virgin and recycled aggregates were similar or greater than fracture …
-
Setting behavior and shrinkage of high performance pavement concrete: Effect of supplementary cementitious materials, chemical admixtures and temperature
… Types B and D) and with 0 or 20% Class C fly ash replacement for Type I cement. The initial and final set times of these mixtures were measured by the penetration resistance method according to ASTM C 403. The temperature rise of the mixtures was monitored using a thermal couple, and the concrete …
-
Analysis of Autogenous and Drying Shrinkage of Concrete
… (w), maximum aggregate size (size), silica fume replacement percent (SF), ground granulated furnace slag replacement percent (GGBFS), and volume of coarse aggregate (CA), on the magnitude of autogenous and drying shrinkage. A new test setup was developed to measure autogenous shrinkage, capillary …
-
Evaluation of de-icer deterioration of concrete
… resistance and evaluation of concrete containing slag cement and 2). Effect of the Interfacial Transition Zone on Joint Deterioration of Concrete Pavements. In the first paper, an alternative test method was proposed to evaluate scaling resistance of concrete containing SCMs, which is believed to …
-
Laboratory Evaluation of Organic Soil Mixing
Organic soils present a difficult challenge for roadway designers and construction due to the high compressibility of the soil structure, the often associated high water table, and the high moisture content. For other soft or loose soils (inorganic soils), stabilization via cement or similar …
-
Mechanism of chloride concentrate and its effects on microstructure and electrochemical properties of cement-based materials
… EDL with different chloride concentrations and slag replacements were investigated and used to explain the variation of Nc. According to the Stern model concerning EDL formed at the solid- liquid interface, the chloride distribution was represented with mathematical equation and the chloride …