Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 27 for “"split injection"”.
-
LOW TEMPERATURE SPLIT INJECTION SPRAY COMBUSTION: IGNITION, FLAME STABILIZATION AND SOOT FORMATION CHARACTERISTICS IN DIESEL ENGINE CONDITIONS
… differences in combustion behavior when split injections are used in low temperature combustion regime. In this thesis, the first injection is also called as pilot injection and second injection is also called as main injection. The broad aspects which are studied encompassing the …
-
Effects of split injection and exhaust gas recirculation strategies on combustion and emissions characteristics in a modern V6 diesel engine
… engine emissions through the combined effects of injection strategy (fuel injection pressure, dwell period, pilot fuel quantity) and cooled Exhaust Gas Recirculation (EGR) on a modern V6 common rail direct injection diesel engine. In the case of using EGR (49–52%) at 1500 rpm and 10% of engine …
-
COLD START ANALYSIS AND MODELING OF A DIRECT-INJECTION GASOLINE ENGINE
… works related to cold start of a direct-injection (DI) gasoline engine are shown. First, effect of split injection is studied on engine exhaust temperature and hydrocarbon emissions for cold start conditions. Instead of single injection, two injections are done, one injection during the …
-
Modelling for turbulent autoignition with split fuel injection
Split-injection is applied in automotive diesel engines in order to control heat release and pollution production. Injecting fuel prior to the main fuel injection, known as pilot injection, increases premixing and tends to reduce NOx emission. Injecting a portion of the fuel after the main …
-
Exploration of Injection Strategy and Fuel Property Effects on Advanced Combustion
… unit (ECU) allowing for flexible control of fuel injection parameters, exhaust gas recirculation (EGR), boost pressure, and other independent control variables. Four different fuels with varying fuel properties, including but not limited to cetane number, aromatic content, 90 percent distillation …
-
Studies on the reduction of nitrogen oxides emission in a large-bore diesel engine
… the output power, while keeping the same fuel injection pressure.At partial load, a more extensive study of different Miller rates was performed. An advanced Miller rate resulted in NOx reduction up to 55%. Since the Miller cycle presented some limitations, other techniques were implemented …
-
Comparison of packed and wide-bore, open-tubular gas chromatographic columns
… associate open-tubular columns exclusively with split injection, often perceived as less repeatable or quantitative. Also, many packed-column methods use application-specific stationary phases which are not readily available on capillary columns. WBOT columns with standard phases can often be …
-
Combustion performance and emissions characteristics of 2-methyltetrahydrofuran and cyclopentanone in a DISI engine
… Air fuel ratio (AFR), Spark timing and fuel injection pressure. The effect of the gasoline blends of the two oxygenated fuels were also investigated along with single pulse fuel injections and split injection strategy. 2-Methylfuran (MF), Ethanol and gasoline were used as the based fuel for …
-
Experimental study on diesel spray with single and multiple injection under room temperature and low temperature
Multiple-injection strategy can downsize the penetration and boost the atomization, causing higher IMEP and lower emissions. Multiple-injection however is complex, especially under cold condition. The injection characteristics were first studied by applying long-tube measuring instrument. Single …
-
Spray, combustion and emission characteristics of dieseline fuel
… were much lower than diesel. With advanced injection timing and large amounts of EGR, both the NOx and PM emissions of dieseline combustion were reduced significantly at part loads. Using split injection strategies gave even more flexibility for the control of mixing strength and combustion …
-
Concentration and Size Distributions of Nanoparticle Emissions during Low Temperature Combustion using Fuels for Advanced Combustion Engines (FACE)
… recirculation (EGR) combined with flexible fuel injection strategies. However, fuel chemistry plays a significant role in the ignition delay; hence, influencing the overall combustion characteristics and the resulting emissions. The Advanced Vehicles, Fuels, and Lubricants (AVFL) committee of the …
-
The Role of Low Carbon Alcohol Fuels in Advanced Combustion
… ignition (TSCI), can be enabled using a split injection of wet ethanol to gain control over the heat release process. The current work further investigates TSCI with wet ethanol experimentally on a diesel engine architecture, finding that the effectiveness of TSCI’s heat release control …
-
Combustion and emissions performance of oxygenated fuels in a modern spark ignition engine
… fuels has been investigated in a modern direct-injection spark-ignition (DISI) engine. In particular, the new biofuel candidate, 2,5-dimethylfuran, otherwise known as DMF, has been assessed as a future automotive fuel against ethanol, the most commercially accepted spark-ignition (SI) biofuel. …
-
Quantitative analysis of rocket propellant by capillary gas chromatography
… the solvent, the analysis time, and the use of splitless injection were investigated. Precision was shown to be improved by: 1. using a non-volatile solvent (toluene) rather than CH₂Cl₂, 2. using the most time-efficient method that will allow adequate resolution of the components, 3. using …
-
Combustion characteristics and control of marine hydrogen-diesel dual-fuel engines with port fuel injection
… and dual-fuel conditions.Firstly, the diesel injection strategy was optimised to enhance flame propagation, reducing the unburnt hydrogen fraction from 50% to 1% and thereby improving hydrogen combustion completeness.Then, the combustion and emission characteristics at different hydrogen …
-
Coupled solid phase extraction-supercritical fluid extraction on-line gas chromatography of explosives from water
… column. This problem has been avoided by using a split injection interface previously described by Hawthorne. The quantitative reproducibility of this interface will be investigated for nanogram quantities of nitroaromatics.
-
Study of Ignition and Combustion Characteristics of Consecutive Injections with iso-Octane and n-Heptane as Fuels
… ignition. Additional tests performed using a split-injection strategy with iso-octane as fuel demonstrate their potentials to reduce the transient stabilisation phase of the test flames, when compared with a single-injection test case with iso-octane as fuel. In the second part of this work …
-
Investigation of Emission Characteristics during Low Temperature Combustion using Multivariate Adaptive Regression Splines
… significantly affected by fuel composition and injection strategy. The starting point of this study is a collection of data correlating injection system parameters, and fuel characteristics, to response parameters such as engine-out emissions (oxides of nitrogen (NOx), total particulate matter …
Page 1 of 2