Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 40 for “"standing wave ratio."”.

  1. Determination of the Residual VSWR [Voltage Standing Wave Ratio] of a Slotted Line.

    … which give rise to reflections, which cause a standing wave to be produced even though the line is terminated I its characteristic impedance.

    unm Repository record for Determination of the Residual VSWR [Voltage Standing Wave Ratio] of a Slotted Line. (opens in a new tab)

  2. The Use of Compensation With Directional Couplers

    … an improved technique for measuring voltage standing wave ratio (VSWR). The reflectometer system is analyzed, and an improved coaxial system is presented which more accurately measures VSWR.

    unm Repository record for The Use of Compensation With Directional Couplers (opens in a new tab)

  3. Plačiajuosčių mikrobangų jutiklių kūrimas, tyrimas ir taikymas /

    … made from n-type Si is mounted in a double ridge waveguide. Developed sensor was devoted for the measurement of high power microwave pulses. The sensor should meet the following requirements: its resistance should be lower than 1 k, a voltage standing wave ratio has been set < 1.5, and the …

    vilnius Repository record for Plačiajuosčių mikrobangų jutiklių kūrimas, tyrimas ir taikymas / (opens in a new tab)

  4. Development, research and application of wide band resistive sensors /

    … made from n-type Si is mounted in a double ridge waveguide. Developed sensor was devoted for the measurement of high power microwave pulses. The sensor should meet the following requirements: its resistance should be lower than 1 k, a voltage standing wave ratio has been set < 1.5, and the …

    vilnius Repository record for Development, research and application of wide band resistive sensors / (opens in a new tab)

  5. Communications antenna for a micro RPV

    … simulation of four potential antenna configurations it was found that a monopole on a cylindrical end cap provides the lowest voltage standing wave ratio (VSWR) and a nearly hemispherical radiation pattern. The data was generated at frequencies near 1 GHz using two method of moments …

    nps Repository record for Communications antenna for a micro RPV (opens in a new tab)

  6. 5 GHz dažnio planarinių antenų modeliavimas ir tyrimas /

    … same frequency range, so there was a problem of wave interference. Since 2009, 5 GHz frequency range was included in IEEE 802.11 standard and nowadays most routers have both 2.4 GHz and 5 GHz frequencies. Antennas play a major role in wireless local area network (Wi-Fi) systems. Antennas are …

    vilnius Repository record for 5 GHz dažnio planarinių antenų modeliavimas ir tyrimas / (opens in a new tab)

  7. Propagation loss study and antenna design for the Micro-Remotely Powered Vehicle (MRPV)

    … measured results. One possible antenna configuration for the MRPV, a circumferential slot, is analyzed and design parameters varied to obtain optimum antenna gain. A prototype of the slot antenna was developed. The antenna patterns, efficiency, and Voltage Standing Wave Ratio (VSWR) are …

    nps Repository record for Propagation loss study and antenna design for the Micro-Remotely Powered Vehicle (MRPV) (opens in a new tab)

  8. Design and Analysis of New Printed Wideband Antennas for Wireless Applications

    … achieve a 120% frequency bandwidth for a voltage standing-wave ratio ≤ 2. Two different designs are tested and their performance is compared: the segmented-ring antenna and the split-ring antenna. Both antennas achieved a stable radiation pattern and a moderate gain. Nearly omnidirectional …

    ndsu Repository record for Design and Analysis of New Printed Wideband Antennas for Wireless Applications (opens in a new tab)

  9. Computer modeling of tactical high frequency antennas

    … gain at the desired takeoff angles, the voltage standing wave ratio (VSWR) of each antenna and its omni-directional capability. The buried antenna models, the ELPA-3 02 and horizontal dipole, were most effective when employed over poor ground conditions. The best performance under all conditions …

    nps Repository record for Computer modeling of tactical high frequency antennas (opens in a new tab)

  10. Manipulation of antenna-mode radar cross-section in patch antennas

    … through equally spaced points on a fixed Voltage Standing Wave Ratio (VSWR) circle on a Smith chart. The behavior was simulated at the fundamental frequency and the first and second harmonics. The patch antenna and the various loads were fabricated, and the actual change in RCS was measured in an …

    uiuc Repository record for Manipulation of antenna-mode radar cross-section in patch antennas (opens in a new tab)

  11. Microwave propagation through isotropic inhomogeneous photoconductive media

    "The electromagnetic field equations for microwave propagation through a rectangular waveguide filled with a lossy, isotropic, linear, inhomogeneous material are derived in matrix form and solved numerically by computer. The theoretical effects of photo-induced conductivity and dielectric constant …

    must-thes Repository record for Microwave propagation through isotropic inhomogeneous photoconductive media (opens in a new tab)

  12. Análise de antenas de microfita em rampa com múltiplas camadas dielétricas

    … height variations on the properties of configurations such as microstrip patch antennas, microstrip patch antennas with overlay and suspendeô microstrip patch antennas. The dielectric substrates can be isotropic or anisotropic ones. This accurate analysis is based on the full-wave formulation. …

    brazil-ufrn Repository record for Análise de antenas de microfita em rampa com múltiplas camadas dielétricas (opens in a new tab)

  13. Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications

    … substantially increase the peak-to-average-power ratio (PAPR) of transmitted signals. To enable power amplifiers (PAs) to operate efficiently under this conditions, load-modulated balanced amplifiers (LMBAs) have been developed as an effective solution while inherently supporting broadband …

    ucf Repository record for Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications (opens in a new tab)

  14. Development of a dual frequency, folded topology, dielectric waveguide lens antenna

    … of operating in the field of high power microwaves (HPMs) especially those which exhibit high gain, wide bandwidth, and steering. Conventional high gain antennas are often based on large and heavy metal structures which may be reflector based. The weight of a simulated all metal antenna design …

    missouri Repository record for Development of a dual frequency, folded topology, dielectric waveguide lens antenna (opens in a new tab)

  15. A Non-Pyramidal Rectangular-to-Trough Waveguide Transition and Pattern Reconfigurable Trough Waveguide Antenna

    Trough waveguides (TWG) have been utilized in a variety of radio frequency (RF) and other related applications including radar, the treatment of hypothermia and in the generation of plasmas. Perturbing the guided wave in these structures with blocks, rods, dielectrics, and other structures can …

    tamu Repository record for A Non-Pyramidal Rectangular-to-Trough Waveguide Transition and Pattern Reconfigurable Trough Waveguide Antenna (opens in a new tab)

  16. The Study and Implementation of Electrically Small Printed Antennas for an Integrated Transceiver Design

    … study is evaluated based upon return loss, operational bandwidth, and radiation pattern characteristics. For our purposes, return loss is measured using the S11-port reflection coefficient which helps characterize how efficiently the small antenna is able to be fed. Operational bandwidth is …

    ku Repository record for The Study and Implementation of Electrically Small Printed Antennas for an Integrated Transceiver Design (opens in a new tab)

  17. A Study of Microfluidic Reconfiguration Mechanisms Enabled by Functionalized Dispersions of Colloidal Material for Radio Frequency Applications

    … frequency applications. Circuit-based reconfiguration mechanisms continue to promote radio frequency (RF) application flexibility; however, increasing limitations have resulted in hindering performance. Therefore, the implementation of a "wireless" reconfiguration mechanism provides the required …

    tamu Repository record for A Study of Microfluidic Reconfiguration Mechanisms Enabled by Functionalized Dispersions of Colloidal Material for Radio Frequency Applications (opens in a new tab)

  18. Novel techniques of RF high power measurement

    … rapidly degrading with the increase in Voltage Standing Wave Ratio (VSWR) due to unmatched loads. My thesis research proved that by using a proper digital correction algorithm better then 1% RF measurement accuracy could be obtained. An improved power measurement technique for real impedance …

    colostate Repository record for Novel techniques of RF high power measurement (opens in a new tab)

  19. Analysis of the equiangular spiral antenna

    … requirement on its minimum boresight gain, axial ratio, or voltage standing-wave ratio when matched with an appropriate transmission line. The analysis of the spiral antenna in the context of a detection system provides information on the effect of the ground on the GPR system and to what extent …

    gatech Repository record for Analysis of the equiangular spiral antenna (opens in a new tab)

Page 1 of 2