Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 27 for “"start of combustion"”.
-
Investigation of oxides of nitrogen emissions from biodiesel-fueled engines
… friendly alternative diesel fuel consisting of the alkyl monoesters of fatty acids. It is obtained from triglycerides through the transesterfication process. The objective of this research was to determine the reason for the higher levels of NOx emissions that have been observed from …
-
The effect of biodiesel oxidation on engine performance and emissions
<p>Biodiesel is a fuel consisting of the alkyl monoesters of vegetable oils or animal fats. Biodiesel is nontoxic, renewable, and biodegradable. Biodiesel-fueled engines produce less carbon monoxide, unburned hydrocarbon, and particulate emissions than diesel fueled engines. One drawback of …
-
Advancing the understanding of pilot ignition in dual fuel engines : Experimental and conceptual studies
… new technologies to reduce CO2 emissions. One of the promising options is the dual fuel engine. In this concept, based on a diesel engine, a small pilot diesel injection is used to ignite a second fuel. This second fuel can be a low carbon or renewable high-octane fuel, that otherwise could not …
-
IGNITION QUALITY TESTER CHARACTERIZATION WITH PURE COMPONENT AND CONVENTIONAL NAVY FUELS
… on conventional diesel fuels as a part of the environmental initiative commonly referred to as “The Great Green Fleet”. The purpose of this research was to characterize the measurements of ignition delay gathered by the Advanced Engine Technology Ignition Quality Tester (IQT) with …
-
The Comparison of Hydrotreated Vegetable Oils With respect to Petroleum Derived Fuels and the Effects of Transient Plasma Ignition in a Compression-Ignition Engine
This thesis presents the results of an experimental study of the combustion characteristics of algae and camelina derived biofuels as well as the effects of Transient Plasma Ignition in a Compression-Ignition Engine. Testing was conducted for Hydrotreated Renewable Diesel, algae, and benchmarked …
-
The Effects of Fuel Additives on Diesel Engine Emissions during Steady State and Transient Operation
Internal combustion engines have propelled society's transportation and power needs for the last century. However, with the regulatory demand to reduce air pollution, internal combustion engines are a major focus to reduce the emissions from these engines. Compression ignition or diesel engines are …
-
Ignition delay properties of alternative fuels with Navy-relevant diesel injectors
In support of the Navy’s Green Fleet Initiative, this thesis researched the ignition characteristics for diesel replacement fuels used with Navy-relevant fuel injectors. A constant-volume combustion chamber was used to simulate Top-Dead-Center conditions of a diesel engine using an ethylene-air …
-
MODEL-BASED CONTROL OF AN RCCI ENGINE
… controlled compression ignition (RCCI) is a combustion strategy that offers high fuel conversion efficiency and near zero emissions of NOx and soot which can help in improving fuel economy in mobile and stationary internal combustion engine (ICE) applications and at the same time lower …
-
Quantification Of Auto-Ignition In Diesel Engines
… to quantify the auto-ignition quality of fuels by calculating global activation energy using Arrhenius plots with data measured for the ignition delay period (ID). Large variation in the activation energy of fuels has been observed even for fuels with closer CN values. More recently, …
-
Part Load Characterization of a Small-Bore Diesel Piloted Dual Fuel Compression Ignition Engine with Methane
… 3 cylinder turbocharged diesel engine was retrofitted for premixed and port injected dual fuel operation. Diesel baseline testing was conducted and conventional diesel trends in efficiency and emissions were found in relation to pilot start of injection (SOI) and load. However, at low loads the …
-
A Detailed Multi-Zone Thermodynamic Simulation For Direct-Injection Diesel Engine Combustion
… for the direct-injection (DI) diesel engine combustion process. For the purpose of predicting heterogeneous type combustion systems, the model explores the formation of pre-ignition radicals, start of combustion, and eventual heat release. These mechanisms are described based on the current …
-
Investigation of the Difference in Cool Flame Characteristics between Petroleum Diesel and Soybean Biodiesel Operating in Low Temperature Combustion Mode
One of the promising solutions to rising emission standards is the in-cylinder emission reduction, through low temperature combustion. Low temperature combustion defeats conventional soot-NOx trade off by simultaneous reduction of both emissions by controlling the in-cylinder temperature below the …
-
Modelling the combustion in a dual fuel HCCI engine. Investigation of knock, compression ratio, equivalence ratio and timing in a Homogeneous Charge Compression Ignition (HCCI) engine with natural gas and diesel fuels using modelling and simulation.
This thesis is about modelling of the combustion and emissions of dual fuel HCCI engines for design of “engine combustion system”. For modelling the combustion first the laminar flamelet model and a hybrid Lagrangian / Eulerian method are developed and implemented to provide a framework for …
-
Conceptual analysis of a four -stroke linear engine
… generation devices has led to the development of a novel crankless reciprocating internal combustion engine. This dissertation presents a conceptual design of a Four-Stroke Linear Engine based on the numerical simulation of the operation of this type of linear engine. The engine consists of …
-
Characterization and Control of Multi-Cylinder Partially Premixed Combustion
In the last decade diesel combustion has developed in a new direction. Research has been carried out trying to prolong the ignition delay and enhance fuel/air premixing to avoid diffusion combustion as well as lowering the combustion temperature through use of EGR. One of these new combustion …
-
MODELING AND ANALYSIS OF REACTIVITY CONTROLLED COMPRESSION IGNITION (RCCI) COMBUSTION
… and Premixed Charge Compression Ignition (PCCI) combustion strategies are promising methods for achieving low engine-out NOx and soot emissions as well as high indicated efficiency. However, these combustion strategies have difficulties with controlling the rate of heat release and lack of an …
-
High-pressure direct-injection of natural gas with entrained diesel into a compression-ignition engine
The high-pressure direct-injection (HPDI) of natural gas in a compression ignition engine has the potential to reduce demand for petroleum derived fuels and significantly reduce the level of pollutants and greenhouse gases emitted from heavy duty transport vehicles. A new HPDI injector was tested …
-
System Simulation of Partially Premixed Combustion in Heavy-Duty Engines : Gas Exchange, Fuels and In-cylinder Analysis
The concept of partially premixed combustion (PPC), applied to conventional diesel engines, has shown to yield high gross efficiencies and low emissions of oxides of nitrogen and soot. PPC emerged from the knowledge gained from homogeneous charge compression ignition (HCCI) research. To extend the …
-
Increasing the Number of Injections Per Cycle in a Gasoline Compression Ignition Strategy: An Experimental Study
… strategy which utilizes the high octane number of gasoline to improve diesel soot and NOx emissions by enabling partially premixed injections of fuel. GCI work in the literature typically uses single, double, or triple injection strategies, with higher numbers of injections noted for their …
-
The effect of altitude on turbocharger performance parameters for heavy duty diesel engines: experiments and GT-Power modeling
Operation at high altitude increases the risk of high cycle fatigue (HCF) failure on turbine blades in internal combustion engine turbochargers. Because engine manufacturers rarely acquire performance data at the high altitude limits of their engines, it is imperative that manufacturers rely on …
Page 1 of 2