Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 735 for “"temperature difference"”.
-
Small temperature difference measurements
… a subjective presentation of the topic of small temperature difference measurements. The basic thermal concepts, thermodynamic laws, and modes of heat transference pertaining to the subject was presented in the first two chapters, followed by a brief discussion of the phenomenon of radiation. …
-
Modeling for improved minimum resolvable temperature difference measurements
The minimum resolvable temperature difference (MRTD) is widely accepted as the parameter that best describes the field performance of a thermal imaging system (TIS). Mathematical modeling that accurately predicts the MRTD has been of major interest to the infrared community over the last 10 years. …
-
Effect of surface-to-jet temperature difference on impingement cooling of rotating bodies
The effect of the surface-to-jet temperature difference on the convective heat transfer from rotating bodies cooled by jet impingement is investigated. The rotating bodies are circular disks, and impingement is provided by a single circular jet of oil impinging at the axis of rotation of the disk. …
-
Modelling and optimization of High Temperature Difference (HTD) gamma-type Stirling engine prototype
… thesis was first focused on modelling of High Temperature Difference (HTD) gamma-type Stirling engine prototype (ST05-CNC) and investigating means of improving its performance. Secondly, newly parallel-geometry mini-channel regenerators (with hydraulic diameters of 0.5, 1, 1.5 mm) and their …
-
Lithium Ion Battery Failure Detection Using Temperature Difference Between Internal Point and Surface
… time. In this thesis, a new method based on temperature difference between internal point and surface (TDIS) of the battery is developed to detect the thermal failure especially the thermal runaway in early time. A lumped simple thermal model of a lithium-ion battery is developed based on …
-
Measurements and modeling enhancements for the NPS minimum resolvable temperature difference model, VISMODII
Minimum Resolvable Temperature Difference (MRTD) measurement has long been used to describe the performance of thermal imaging systems. Computer models such as U.S. Armyαs FLIR92, that were developed to predict the MRTD, were reported to have deficiencies in dealing with sampling and aliasing …
-
Investigation of minimum resolvable temperature difference formulation for polarized thermal imaging range prediction
… polarization filter can increase ship-background temperature contrast in the infrared, while decreasing the received radiance. Application of this technique to increasing range for detection or recognition of ship targets is being investigated through detection range modeling for a generic FLIR …
-
Development of a model for an objective minimum resolvable temperature difference characterization of an infrared camera
… thermal imaging camera is the minimum resolvable temperature difference. Unfortunately, this criterion is subjectively determined by a group of observers and as a consequence significantly varying results can be obtained at different times. This project describes work on an approach which …
-
The role of elevated central-peripheral temperature difference in early detection of late-onset sepsis in preterm infants
Um die Mortalität und Morbidität von Sepsisepisoden bei Frühgeborenen zu verbessern, kommt einer frühen und sicheren Diagnosestellung besonderes Interesse entgegen. In dieser Arbeit wurde untersucht, inwiefern durch eine Analyse einfacher klinischer Symptome die Wahrscheinlichkeit einer …
-
Development and validation of a second generation visibility-based model for predicting subjective and objective minimum resolvable temperature difference for staring thermal imaging systems
… been proposed to predict the minimum resolvable temperature difference (MRTD) performance of second generation thermal imaging systems (TIS) which incorporate staring focal plane arrays. It has been suggested that these models are not accurate for predicting the performance of second generation …
-
Modeling greenhouse air temperature
Research has been completed to predict the temperature difference between the inside and the outside of the greenhouse. Predicting the temperature difference would aid in determining the inside air temperature of the water-based greenhouse. Determination of the inside a1r temperature of the …
-
Theoretical and experimental analysis of FRP bridge decks under thermal loads
The temperature difference between the top and bottom of a fiber reinforced polymer (FRP) composite deck (120°F) is nearly three times that of conventional concrete decks (40°F). The large temperature difference is attributed to low thermal conductivity of FRP material and low thermal mass due to …
-
Correlation of Soil Moisture with Soil Surface Temperature Obtained by Thermography
… emitted by the earth, the actual surface temperature is difficult to measure accurately from satellite heights. However, the temperature difference between two locations on the earth can be measured to a better approximation if the atmosphere attenuates the radiation equally over both …
-
Thermal image measurements of infrared signatures
… and meteorological parameters to give the temperature and radiance distributions of the target. The influences of reflected sky radiation on the background radiance was observed under varying sea surface conditions. A predictive model of effective radiance temperature difference of the …
-
Automatic Optimisation of a Battery Pack Cooling Plate
… cooling system in terms of maximum battery cell temperature difference, maximum battery cell temperature and pressure drop. The analysed part of the cooling system consists of aluminium plates with channels, where coolant flows through. One configuration consisting of one large cooling plate and …
-
Modeled detection and recognition range for a polarization filtered FLIR sensor
… were based on environmental parameters and ship temperatures recorded during the EOPACE measurement series in San Diego bay in 1996. These scenarios represent a FLIR sensor on a platform in level flight at 100 m or 1000 m approaching a ship target, represented as a gray body at the recorded ship …
-
Efficiency improvement in MEMS thermoelectric generators employing solar concentration
… of thermoelectric generators depends on the temperature difference across the device, the average temperature of operation, and on the thermoelectric properties of the material. Most work on improving the TEG efficiency deals with improving the thermoelectric properties of the material. In …
-
Oscillating microbubbles created by water drops falling on fresh and salt water : amplitude, damping and the effects of temperature and salinity.
… radiate more energy as the magnitude of the temperature difference between the drop and surface increases. These findings are examined in more detail using the pressure decay curve of both large and small raindrops. Using small raindrops it is shown that bubbles in salt water have a larger …
Page 1 of 37