Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 123 for “"tensile behavior"”.
-
Fracture energy and tensile behavior of concrete
Fracture behavior of concrete has been a subject of investigation for the past two decades. The need of understanding the complete tensile response of concrete is absolutely essential for theoretical modelling as well as design application of plain concrete structures. In this study, attempts were …
-
Tensile behavior of unidirectional and cross-ply ceramic matrix composites
The tensile behavior of two ceramic matrix composites (CMC's) was observed. The materials of interest in this study were a glass-ceramic matrix composite (GCMC) reinforced with Nicalon fibers and a Blackglas™ composite also reinforced with Nicalon fibers. Both had a symmetric cross-ply layup. …
-
The tensile behavior of AA6013 at room temperature and 240 °C
Automotive manufacturers are pursuing technologies, such as lightweighting, that improve vehicle fuel-efficiency and reduce emissions. High-strength aluminum alloys might provide performance equal to the current ultra-high-strength steels while decreasing vehicle weight. High-strength 6xxx-series …
-
Tensile behavior of concrete and mortar under direct impact tensile load
… to develop a standard test set-up for direct tensile testing of cementitious composites. to study the tensile behavior of mortar and concrete under direct impact tensile load. to develop a simplified formula to predict the behavior of mortar and concrete under direct tensile impact loading. A …
-
Tensile behavior of aluminum reinforced with angle-ply boron epoxy laminates
An experimental investigation of the tensile behavior of aluminum reinforced with angle-ply boron/epoxy laminates was conducted. It is shown that the ultimate stresses of a wide variety of laminate configurations fall within a very narrow range of values. Some configurations of composite reinforced …
-
A Comparative Study of Tensile Behavior and Fracture-Zone Development in Paper
… is a fibrous network material whose mechanical behavior depends not only on fiber properties and interfiber bonding, but also on how damage develops and localizes during fracture. This thesis presents a comparative experimental study of several paper grades, including historical book papers, …
-
Mechanism of Tensile Behavior and Failure of Asphalt Cements in Thin Films
Made available in DSpace on 2014-12-08T23:56:55Z (GMT). No. of bitstreams: 1 6801803.pdf: 7614383 bytes, checksum: 672a5ab1ce47f99e70b394ed07d7d7a1 (MD5) Previous issue date: 1967
-
Feasibility of a New Technique to Determine Dynamic Tensile Behavior of Brittle Materials
Dynamic tensile characterization of geo-materials is critical to the modeling and design of protective structures that are often made of concrete. One of the most commonly used techniques currently associated with this type of testing is performed with a Kolsky bar and is known as the spall …
-
CORRELATIONS BETWEEN COMPRESSIVE, FLEXURAL, AND TENSILE BEHAVIOR OF SELF-CONSOLIDATING FIBER REINFORCED CONCRETE
… members has been shown to result in improved behavior under shear, flexure, and compression relative to conventional reinforced concrete. The aim of this study was to investigate relationships between the compressive and tensile responses of SCFRC as well as relationships between measured …
-
MULTISCALE MODELING OF SOLVENT-MEDIATED ENTROPIC EFFECTS ON POLYMER BINDING AND TENSILE BEHAVIOR
… important in describing the equilibrium behavior of polymers with high molecular weights or complex architectures. Despite its key role, entropy is often overlooked in materials design due to its nuanced, hard-to-quantify nature, and non-trivial coupling to enthalpic interactions. In this …
-
As-deposited microstructure and tensile behavior of solid-state additive manufactured Ti–6Al–4V
… Ti64 deposition cross section. Quasi-static tensile experiments performed on as-built AFS-D Ti64 samples quantified the strength and ductility, and the results were compared to the data available in the open literature of Ti64 produced by other popular AM methods. In conclusion, the …
-
Tensile behavior of expansion and undercut anchors in concrete affected by alkali-silica reaction
This thesis addresses the tensile capacity and load-deflection behavior of wedge-type expansion and undercut anchors in concrete affected by alkali-silica reaction (ASR). ASR is a chemical reaction that occurs between alkalis in the cement and silica in the aggregates. The reaction occurs with the …
-
Characterization and Assessment of Tensile Behavior of Carbon Nanofibers Enhanced Ultra-High Performance Concrete
… the interest of stakeholders to explore the UHPC tensile capabilities and behaviors. Evidently, there has been a growth in UHPC tensile research. The literature lacks any set of extensive data with variable fiber dosage.In this study, extensive data is examined and commented on. This study is …
-
Pullout and Tensile Behavior of Crimped Steel Reinforcement for Mechanically Stabilized Earth (MSE) Walls
… pullout box was designed and constructed, where tensile and pullout tests were performed on the crimped reinforcement. Different crimp geometries on different bar diameters were tested under a range of confining pressures. From this, force-displacement curves were developed for these crimp …
-
Hot Tensile Behavior of Ti-6Al-4V Alloy Using Artificial Neural Network and Constitutive Modeling
… (the relative amount of deformation), the flow behavior of material at these temperature is rather straightforward. At high temperature other parameters, namely temperature and strain rates, should be also taken into account in predicting the flow stress. Our goal in this research is to predict …
-
Effect of Strain Rate on the Tensile Behavior of CoCrFeNi and CoCrFeMnNi High Entropy Alloys
… materials. The focus of this study was on the tensile behavior of the two materials at quasi-static and dynamic strain-rates (〖10〗^(-4) to 〖10〗^3 s^(-1)) and the underlying microstructural phenomena driving the behaviors. Electron back-scatter diffraction was performed on both HEAs to study the …
-
The Effect of Friction Stir Processing on The Microstructure and Tensile Behavior of Aluminum Alloys
… with single and multiple passes. Analysis of tensile test results and work hardening characteristics showed that for the high quality ingot, a single pass was sufficient to eliminate the structural defects. Subsequent FSP passes had no effect on the work hardening characteristics. In contrast, …
Page 1 of 7