Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 36 for “"third order intercept"”.

  1. PMODFET and NMOSFET broadband mixer design

    … TSMC process were designed and fabricated in order to obtain low conversion loss and high input third order intercept point(IIP3), and in order to compare the flicker noise of NMOSFET to PMOSFET. These mixers were designed for wireless applications with RF and IF frequency ranges of I to 3 …

    hawaii Repository record for PMODFET and NMOSFET broadband mixer design (opens in a new tab)

  2. Automatic test system for characterizing radio frequency amplifiers

    … (S-parameters), 1dB Compression Point (P1dB) and Third-Order Intercept Point (IP3).

    ttu Repository record for Automatic test system for characterizing radio frequency amplifiers (opens in a new tab)

  3. Analysis of Intermodulation Distortion for MESFET Small-signal Amplifiers

    … representation, analytical expressions for the third-order intermodulation distortion power and intercept point for a MESFET small-signal amplifier are derived when its equivalent circuit is bilateral and includes the gate-to-drain capacitance (Cgd) explicitly as a nonlinear element. Previously …

    portland-state Repository record for Analysis of Intermodulation Distortion for MESFET Small-signal Amplifiers (opens in a new tab)

  4. Nonlinear Analysis and Digital Pre-Distortion of the SC-FDMA Signals in LTE Uplink System

    … amplifiers having nonlinear properties; 2) In order to obtain adequate capacity, wide bandwidth is applied to the latest communication systems. Since in previous systems the pre-distorter would focus on memory-less distortion with relatively narrow bandwidth, this change makes memory distortion …

    portland-state Repository record for Nonlinear Analysis and Digital Pre-Distortion of the SC-FDMA Signals in LTE Uplink System (opens in a new tab)

  5. Modeling of Signals and Spectra: 5G and Beyond

    … prediction of amplified dual-band spectrum. The third paper emphasizes the significance of out-of-band intermodulation products and derives an analytical expression using third-order intercept points. The fourth paper presents a unified spectrum expression for OFDM, FBMC, and F-OFDM, facilitating …

    portland-state Repository record for Modeling of Signals and Spectra: 5G and Beyond (opens in a new tab)

  6. A NOVEL CMOS IC SENSOR FOR REMOTE RF SIGNAL SENSING

    … techniques were developed to maximize the third-order intercept point, and suppress flicker noise for the LNAs and GCMs, resulting in improved sensing accuracy. The overall system-level evaluation results showed state-of-art angle-of-arrival sensing capability with an upper limit error of …

    maryland Repository record for A NOVEL CMOS IC SENSOR FOR REMOTE RF SIGNAL SENSING (opens in a new tab)

  7. CMOS bulk-driven mixers with passive baluns

    … point (P1dB) of −14 dBm, an input-referred third-order intercept point (IIP3) of −5.2 dBm, a gain of 13.6 dB, a noise figure (NF) of 26 dB, and an LO-to-RF isolation of 50 dB. The overall performance of both mixers is found to be comparable with other CMOS mixers, but with a higher noise …

    ubc Repository record for CMOS bulk-driven mixers with passive baluns (opens in a new tab) Download PDF for CMOS bulk-driven mixers with passive baluns (opens in a new tab)

  8. Structured LNA Design for Next Generation Mobile Communication

    … P1dB compression point of -10 dBm and input third order intercept point (IIP3) of around 0.015 dBm with 75 mw power consumption. The good agreement between simulated and measured results proved the viability of the design for next generation mobile communication LTE standard.

    chalmers Repository record for Structured LNA Design for Next Generation Mobile Communication (opens in a new tab)

  9. UHF Applications for Radar and Pico-Satellite Communication Systems

    … dB gain, 3 dB noise figure, and 30.6 dBm output third-order intercept. The second part of the thesis discusses the CubeSat project at the University of Hawaiʻi and presents an analysis on the radiation pattern of the active antenna on the cube satellite. The analysis for the active antenna …

    hawaii Repository record for UHF Applications for Radar and Pico-Satellite Communication Systems (opens in a new tab)

  10. Characterizing and minimizing nonlinearities responsible for intermodulation distortion in high speed and high power photodiodes

    … in the limit of weak nonlinearity was used in order to characterize the effects of nonlinearity on high speed and high power photodiodes. The combined influences of a) optical illumination, b) photocurrent, and c) interaction of the photodiode with an external circuit, were incorporated into …

    gatech Repository record for Characterizing and minimizing nonlinearities responsible for intermodulation distortion in high speed and high power photodiodes (opens in a new tab)

  11. Spectrum Regrowth for OFDM-based LTE and WIMAX Systems

    … power amplifier is usually described by IP3 (the third-order intercept point). However, there is need of a clear relationship or expression between the out-of-band power emission level and IP3 for LTE and WiMAX Systems, which helps the RF designers to choose components. This thesis presents the …

    portland-state Repository record for Spectrum Regrowth for OFDM-based LTE and WIMAX Systems (opens in a new tab)

  12. Design and Analysis of Supply-Scaled Distributed Power Amplifiers

    … output-referred 1 dB compression point and third-order intercept points are 9 dBm and 16 dBm, respectively. A third distributed amplifier design used a bulk CMOS 180nm process. Compared to an SOI process, the CMOS substrate is relatively lossy. Consequently, the design and discussion focused …

    cornell Repository record for Design and Analysis of Supply-Scaled Distributed Power Amplifiers (opens in a new tab)

  13. Inductorless balun low-noise amplifier (LNA) for RF wideband application to IEEE 802.22

    … entire band (with 2.4 dB min figure), an input third-order intercept point (IIP3) > 3.3 dBm (7.6 dBm max.) and an input power reflection coefficient S11 < -16 dB. When optimized for best NF, it achieves a voltage gain > 24.7 dB (power gain > 19.8 dB), a NF < 2 dB over the entire band, an IIP3 > …

    brazil-ufrgs Repository record for Inductorless balun low-noise amplifier (LNA) for RF wideband application to IEEE 802.22 (opens in a new tab)

  14. Power Spectrum Prediction of Amplified Dual-Band LTE-Advanced Signals

    … designers should know about the nonlinearity in order to compensate for it. A two-tone test is a relatively widely used method to measure the nonlinearity of a power amplifier, which means the third order intercept point (IP3) can be measured from the two-tone test. Through the two-tone test, …

    portland-state Repository record for Power Spectrum Prediction of Amplified Dual-Band LTE-Advanced Signals (opens in a new tab)

  15. Gallium Nitride Phase Shifters

    … circuit (MMIC) exhibited an input-referred third-order intercept point (IIP3) higher than 46 dBm. A K-band phase shifter was also designed to test the limits of the technology. The high-power phase shifters have been fabricated in a 0.5 μm GaN HEMT process and were designed using an …

    carleton Repository record for Gallium Nitride Phase Shifters (opens in a new tab)

  16. Understanding distortion in silicon-germanium transistors, and its application to RF circuits

    … for small-signal linearity is the Input/Output Third Order Intercept Point (IIP3/OIP3), which represents the input/output power level at which the power of fundamental frequency (PFUND) become equal to that of the third-order intermodulation product (P3rd). Clearly, a higher IIP3 number yields …

    gatech Repository record for Understanding distortion in silicon-germanium transistors, and its application to RF circuits (opens in a new tab)

  17. Digitally assisted test methodology for RF receivers

    … like gain, noise figure (NF), and input-referred third-order intercept point (IIP3). In addition, the test method can extract important baseband (BB) parameters like the BB filter 3 dB bandwidth (BW), filter rejection at specific BB frequencies, or the BB filter profile. The motivation behind the …

    texas Repository record for Digitally assisted test methodology for RF receivers (opens in a new tab)

  18. Radio frequency circuit design and packaging for silicon-germanium hetrojunction bipolar technology.

    … point (P1dB) is 1.73 dBm, with an input third-order intercept point (IIP3) of -3.98 dBm. Lastly, Chapter 4 covers the packaging techniques for the SiGe monolithic integrated circuit (MMIC). We present the modeling of a liquid crystal polymer (LCP) package for use with an X-band SiGe HBT …

    gatech Repository record for Radio frequency circuit design and packaging for silicon-germanium hetrojunction bipolar technology. (opens in a new tab)

  19. A 0.18-μm BICMOS 20-57 GHz Ultra-Wideband Low-Noise Amplifier Utilizing Frequency-Controlled Positive-Negative Feedback Technique

    … point higher than -19 dBm, and an input third-order intercept point greater than -8 dBm. It dissipates 16.6 mW from 1.8 V DC supply and has a chip area of 700×400 μm^2.

    tamu Repository record for A 0.18-μm BICMOS 20-57 GHz Ultra-Wideband Low-Noise Amplifier Utilizing Frequency-Controlled Positive-Negative Feedback Technique (opens in a new tab)

  20. Study Of Design For Reliability Of Rf And Analog Circuits

    … source inductance is more reliable for the input third-order intercept point. A RF power amplifier with adaptive gate biasing is proposed to improve the circuit device reliability degradation and process variation. The performances of the power amplifier with adaptive gate biasing are compared …

    ucf Repository record for Study Of Design For Reliability Of Rf And Analog Circuits (opens in a new tab)

Page 1 of 2