Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 26 for “"track testing"”.

  1. On-Track Testing as a Validation Method of Computational Fluid Dynamic Simulations of a Formula SAE Vehicle

    This thesis is about the validation of a computational fluid dynamics simulation of a ground vehicle by means of a low-budget coast-down test. The vehicle is built to the standards of the 2014 Formula SAE rules. It is equipped with large wings in the front and rear of the car; the vertical loads on …

    ku Repository record for On-Track Testing as a Validation Method of Computational Fluid Dynamic Simulations of a Formula SAE Vehicle (opens in a new tab)

  2. The Use of Simulation to Expedite Experimental Investigations of the Effect of High-Performance Shock Absorbers

    Successful race teams rely heavily on track testing to search for the ideal suspension setup. As more restrictions are placed on the amount of on-track testing by major racing sanctioning bodies, such as NASCAR, teams have increased their attention to alternate testing methods to augment their …

    vt Repository record for The Use of Simulation to Expedite Experimental Investigations of the Effect of High-Performance Shock Absorbers (opens in a new tab)

  3. Optimal Vehicle Path Generator Using Optimization Methods

    … with a feedback steering controller to automate track testing experiment. This study specifically concentrates on applying optimization concepts to generate paths that meet two separate objective functions; minimum time and maximum tire forces. A three-degree-of freedom vehicle model is used to …

    vt Repository record for Optimal Vehicle Path Generator Using Optimization Methods (opens in a new tab)

  4. On-road aerodynamic state estimation using sparse pressure sensors with application to truck platooning

    … using one of three methods: 1. wind-tunnel testing (often supported by computational fluid dynamics); 2. controlled track testing; and 3. on-road testing. While wind-tunnel and track- testing benefit from the ease of repeatability and control, they suffer from a dearth of real-world effects …

    queens Repository record for On-road aerodynamic state estimation using sparse pressure sensors with application to truck platooning (opens in a new tab)

  5. Real-Time Control Interface for a Steered and Braked Converter Dolly for High Capacity Transport Vehicles

    … a hardware-in-the-loop simulation as well as on-track testing further on. The main-outcomes are a ready-to-use interface for algorithm development in MATLAB/Simulink that allows to request steering angles individually for each axle and supplies feedback for all relevant parameters (e.g. …

    chalmers Repository record for Real-Time Control Interface for a Steered and Braked Converter Dolly for High Capacity Transport Vehicles (opens in a new tab)

  6. Modelling and Model Predictive Control of Power-Split Hybrid Powertrains for Self-Driving Vehicles

    … to the torque at each wheel. Extensive road testing of the vehicle was performed to identify parameters of the powertrain and braking models. Experimental data was measured using a vehicle measurement system and CAN bus diagnostic signals. Model parameters were identified using optimization …

    waterloo Repository record for Modelling and Model Predictive Control of Power-Split Hybrid Powertrains for Self-Driving Vehicles (opens in a new tab)

  7. High-Speed Roll Stability Evaluation of A-Double Tractor-Trailers

    … trailers is evaluated through simulation and track testing. The changes in CG position due to the type of trailer (straight-rail vs. drop-frame) and laterally and longitudinally off-centered loads are considered. The simulation results show that imbalanced trailer loading induces roll …

    vt Repository record for High-Speed Roll Stability Evaluation of A-Double Tractor-Trailers (opens in a new tab)

  8. Experimental Evaluation of Roll Stability Control System Effectiveness for A-double Commercial Trucks

    Some of the results of an extensive track testing program at the Center for Vehicle Systems and Safety (CVeSS) at Virginia Tech for evaluating the roll stability of commercial trucks with 33-ft A-double trailers are evaluated. The study includes straight-rail trailers with heavy and light loading …

    vt Repository record for Experimental Evaluation of Roll Stability Control System Effectiveness for A-double Commercial Trucks (opens in a new tab)

  9. Physical validation of predictive acceleration control on a parallel hybrid electric vehicle

    … Area Network (CAN) bus. Results from on-track testing indicate a Fuel Economy (FE) improvement in the range of 7% is possible to achieve using PAE control in the real world. To the author's knowledge this is the first time that this type of testing has ever been implemented on a vehicle …

    colostate Repository record for Physical validation of predictive acceleration control on a parallel hybrid electric vehicle (opens in a new tab)

  10. Active Yaw Rate Stabilization for Steer-by-Wire Cars

    … response is established using a linear single-track reference model. Against strict hardware constraints specifically a 50 ms actuation delay. A model-free Proportional (P) controller proved superior to model-based alternatives, guaranteeing absolute stability and preventing the delay-induced …

    chalmers Repository record for Active Yaw Rate Stabilization for Steer-by-Wire Cars (opens in a new tab)

  11. Identifiability and parameter estimation in rail vehicle dynamics

    … decisions, and they can reduce the amount of on-track testing required to qualify new designs for service. This work addresses two major issues: the determination of parameter identifiability and the estimation of rail vehicle parameters from laboratory tests. Usually, the identifiability issue …

    vt Repository record for Identifiability and parameter estimation in rail vehicle dynamics (opens in a new tab)

  12. Learning interventions in olympic skeleton through the use of physical simulation

    … on task specific stimuli cueing. Two on-ice track-testing sessions were conducted. They primarily provided the acquisition of on-track sled dynamic measurements and athlete subjective data, which helped formulate hypotheses around which cueing stimuli was important within a VE training …

    soton Download PDF for Learning interventions in olympic skeleton through the use of physical simulation (opens in a new tab)

  13. Evaluation of Moisture Susceptibility of Warm Mix Asphalt

    … Resilient Modulus (MR) and Hamburg Wheel-Track Testing (HWTT). Specimens for IDT and MR were tested dry and then tested wet after conditioning as described in AASHTO T283 with one freeze-thaw cycle. HWTT was used to assess both moisture susceptibility and rutting potential under repeated …

    tamu Repository record for Evaluation of Moisture Susceptibility of Warm Mix Asphalt (opens in a new tab)

  14. Design of a Portable Tire Test Rig and Vehicle Roll-Over Stability Control

    … the easiest and cheapest method for vehicle testing. No longer do multiple, intensive, physical tests need be performed to analyze the performance parameters that one wishes to validate. One component of the vehicle simulation that is crucial to the correctness of the result is the tire. …

    vt Repository record for Design of a Portable Tire Test Rig and Vehicle Roll-Over Stability Control (opens in a new tab)

  15. Healthcare Workers' Perspectives on Financial Incentives to Increase Pediatric HIV Testing

    … Financial Incentives to Increase Pediatric HIV Testing Dana Atkins Chair of the Supervisory Committee: Grace John-Stewart Departments of Epidemiology, Global Health, Medicine & Pediatrics Background: Financial incentives (FI) have been used to modify health behavior. The Financial Incentives to …

    washington Repository record for Healthcare Workers' Perspectives on Financial Incentives to Increase Pediatric HIV Testing (opens in a new tab)

  16. Generic and complete vehicle dynamic models for open-source platforms

    … advanced model for offline simulation prior to track testing. In addition to model development, an investigation has been made on the level of modelling details suitable for automated driving for non-critical highway and city driving on dry asphalt. For instance, a clutch model was implemented …

    chalmers Repository record for Generic and complete vehicle dynamic models for open-source platforms (opens in a new tab)

  17. Energy Consumption Testing of Connected and Automated Vehicle Technologies

    … and test systems to enable energy consumption testing of Connected and Automated Vehicle (CAV) technologies. The research in this work was conducted in environments spanning simulation, dynamometers, and test tracks using new methodologies capable of accommodating both production Advanced …

    washington Repository record for Energy Consumption Testing of Connected and Automated Vehicle Technologies (opens in a new tab)

  18. Stochastic track-structure simulation methods and the determination of product yields in the radiolysis of water containing various solutes

    … treat the early chemistry within a radiation track. Testing of these codes against several new experimental data compilations revealed several areas in which some of the basic model assumptions needed adjustment. Several improvements to the computer model were made, including adjustments to …

    utk-theses Repository record for Stochastic track-structure simulation methods and the determination of product yields in the radiolysis of water containing various solutes (opens in a new tab)

  19. Neuroevolution and Machine Learning Research Applied to Connected Automated Vehicle and Powertrain Control

    … reported using simulation and during closed-loop track testing. In the second study, no such timing information exists, and the cohorts must collaborate to enable safe operation at uncontrolled intersections. Here, the cohorts share states' information to minimize deceleration and acceleration …

    mtu Repository record for Neuroevolution and Machine Learning Research Applied to Connected Automated Vehicle and Powertrain Control (opens in a new tab)

  20. RANDOM ROAD ANALYSIS AND IMPROVED GEAR RATIO SELECTION OF A FRONT WHEEL DRIVE DRAG RACING CAR

    … can get in order to excel in their field. On-track testing is very expensive and can consume large amounts of time and resources that a race team may not be able to afford. One way to address this potential problem of high cost is by using computer simulation to show how your drag race car may …

    clemson Repository record for RANDOM ROAD ANALYSIS AND IMPROVED GEAR RATIO SELECTION OF A FRONT WHEEL DRIVE DRAG RACING CAR (opens in a new tab)

Page 1 of 2