Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 5 of 5 for “"twist compression test"”.
-
A novel method of detecting galling and other forms of catastrophic adhesion in tribotests
Tribotests are used to evaluate the performance of lubricants and surface treatments intended for use in industrial applications. They are invaluable tools for lubricant development since many lubricant parameters can be screened in the laboratory with only the best going on to production trials. …
-
Characterization of Formability and Friction during Hot Stamping of Al-Si Coated Press Hardened Steel
… while a coating weight of 80 g/m2 was also tested for the PHS1500, designated PHS1500-AS80. Testing was done under conditions representative of hot stamping. Friction characterization using the twist compression test (TCT) was performed considering sliding speeds in the range 10 to 38 mm/s …
-
Characterization and Simulation of Warm Forming of 6xxx and 7xxx Series Aluminum Alloys
… the LPS Dry Film PTFE Spray, was obtained in the Twist Compression Test (TCT) at a test temperature of 170°C. For uncoated tooling, the steady-state COF and observation of surface damage demonstrated early film breakdown for the LPS Dry Film PTFE Spray at 170°C whereas the OKS 536 experienced …
-
Constitutive and Friction Characterization and Simulation of AA7075 Aluminum Alloy Sheet under Die Quenching Conditions
… the Omer-fit corresponding to the 470°C, 0.1 s-1 test with an R2 value of 0.7798, whereas the worst case for the Wang-fit was the 400°C, 0.1 s-1 test condition with an R2 value of 0.8992. All other tests conditions exhibited R2 values closer to unity. A numerical model of tensile testing under DQ …
-
Effect of Pre-Bending and Hydroforming Parameters on the Formability of Advanced High Strength Steel Tube
With increasing fuel costs and the current drive to reduce greenhouse gas emissions and fuel consumption, a need to reduce vehicle weight is apparent. Weight reduction can be achieved by replacing conventionally stamped structural members with hydroformed parts. The weight reduction can be further …