Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 26 for “"wall interference"”.
-
EFFECTS OF WALL INTERFERENCE ON UNSTEADY TRANSONIC FLOWS.
… For unsteady flow, the effects of wind tunnel walls or a finite computational domain are the least understood and perhaps the most important. Although various techniques can be used in steady wind tunnel testing to minimize wall reflections, e.g., using slotted walls with ventilation, wind …
-
Wall interference correction based on interface measurements in subsonic wind tunnel testing
<p>Two types of wall interference correction methods based on interface measurements in subsonic wind tunnel testing are investigated.</p> <p>The first method, called the Two-Interface method, is derived based on a small perturbation solution of the two-dimensional potential equation in subsonic …
-
Strut and wall interference on jet-induced ground effects of a STOVL aircraft in hover
… to make a relative assessment of the aerodynamic interference of a proposed strut configuration and a wall configuration on the ground plane stagnation line. A simplified flat plate model representative of a generic jet-powered STOVL aircraft was used to simulate the LSPM. Cold air jets were used …
-
Statistical Calibration and Validation of a Homogeneous Ventilated Wall-Interference Correction Method for the National Transonic Facility
… corrections made to these data is due to wall interference. In an effort to understand the accuracy and suitability of these corrections, a statistical validation process for wall interference correction methods has been developed. This process is based on the use of independent cases …
-
An Extended Calibration and Validation of a Slotted-Wall Transonic Wall-Interference Correction Method for the National Transonic Facility
Correcting wind tunnel data for wall interference is a critical part of relating the acquired data to a free-air condition. Accurately determining and correcting for the interference caused by the presence of boundaries in wind tunnels can be difficult especially for facilities employing ventilated …
-
A Computational Evaluation of Transonic Wind Tunnel Wall Interference on High Aspect Ratio Models in the Arnold Engineering Development Complex 16 Foot Transonic Tunnel
… of the model flow field and the test section walls. If high quality aerodynamic data is required for the system under test it is necessary to determine the impact of the test section walls on the flow field around the model. A parametric study was undertaken using the CFD code USM3Dns to …
-
A study of wind tunnel aerodynamic data correction with panel method and two-variable method
… is to find fast and efficient ways to improve wall in-terference calculations for subsonic and transonic wind tunnel testing. The study consists of three portions. In the first portion, a panel method code, PMARC, has been modified to calculate wall interference effects using the improved test …
-
Improvement of subsonic wall corrections in an industrial wind tunnel
… possibility of experiencing relatively larger wall-interference effects compared to full span tests. Subsonic wall-interference effects due to the partially open boundaries at the NRC 5ft wind tunnel are corrected by the “one-variable” method, resulting in corrections in Mach number and angle …
-
A CFD investigation of wind tunnel interference on delta wing aerodynamics
… test facilities on delta wing aerodynamics, the interference has been separated into two distinct types, wall interference and support structure interference. The wall interference effects have been split into three further components, tunnel blockage, side wall interference, and roof and floor …
-
Understanding and Exploiting Wind Tunnels with Porous Flexible Walls for Aerodynamic Measurement
… behavior of wind tunnels with porous, flexible walls formed from tensioned Kevlar has been characterized and new measurement techniques in such wind tunnels explored. The objective is to bring the aerodynamic capabilities of so-called Kevlar-wall test sections in-line with those of traditional …
-
ΕΞΟΜΟΙΩΣΗ ΡΟΙΚΟΥ ΠΕΔΙΟΥ ΑΞΟΝΟΣΥΜΜΕΤΡΙΚΩΝ ΣΩΜΑΤΩΝ ΣΕ ΘΑΛΑΜΟ ΜΕΤΡΗΣΕΩΝ ΑΕΡΟΣΗΡΑΓΓΑΣ
… UNCONFINED FLOW PATTERN APPLYING THE CONTOURED WALL TECHNIQUE FOR THE MINIMIZATION OF THE WALL INTERFERENCE. THE CONFINED AND POTENTIAL FLOWFIELD ANALYSIS IS BASED ON THE LINEARISED COMPRESSIBLE FLOW THEORY AND THE METHOD OF IMAGES. THE SUPPORT SYSTEM IS OF A STING TYPE AND IT IS MODELED IN THE …
-
A theoretical analysis of unsteady transonic cascade flow.
… adjacent blade "isolated foil" potentials with interference potentials of unknown strength. Imposition of flow tangency requirements leads to integral equations for the unknown source distributions of the interference coefficients for the steady and oscillating cases. The steady case is extended …
-
New Test Capabilities for the 0.3-Meter Transonic Cryogenic Wind Tunnel
… by its reliance on a two-dimensional adaptive wall test section coupled with an inadequate facility control system. Access to the test section is restricted, the walls require excess time for convergence and are mechanically constrained by a wall jacking system that degrades under cyclic …
-
A tolerant axisymmetric wind tunnel
A solution to the current problem of wind tunnel wall interference could be achieved by ventilating the test section and thereby controlling the flow pattern around the model. The motivation for the slotted wall test section arises from the fact that a fully open jet and a fully closed jet …
-
An investigation of the aerodynamic characteristics of ventilated test section walls for transonic wind tunnels
… of the aerodynamic characteristics of ventilated walls. A combined experimental-theoretical technique is selected, wherein static pressure measurements made at the boundaries of a two-dimensional flow yield sufficient information for calculation of the remaining parameters of interest. The …
-
On transonic wind tunnel design considerations
… viscous flow research purpose. The wind tunnel wall has been designed such that it becomes the testing model. By varying the configuration along the tunnel wall, a wide variation in Reynolds number flow can be realized. Especially, the current tunnel is designed to reach the value of the …
-
A Study of Aerodynamics in Kevlar-Wall Test Sections
… characterize the aerodynamic behavior of Kevlar-wall test sections and specifically those containing two-dimensional, lifting models. The performance of the Kevlar-wall test section can be evaluated against the standard of the hard-wall test section, which in the case of the Stability Wind Tunnel …
-
Development of the tolerant wind tunnel for bluff body testing
In conventional wind tunnels the solid-wall or open-jet test section imposes on the flow field around the test model new boundary conditions absent in free air. Unless a small model is used, the solid-wall test section generally increases the loadings on the model while the open-jet boundary …
Page 1 of 2