Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 283 for “"wind tunnel testing"”.

  1. Wind Tunnel Testing of a Novel Quadrotor Design

    … of attack model support system was developed for wind tunnel testing, enabling precise replication of in-flight conditions. The support system, controlled via LabVIEW, adjusts angle of attack based on real-time tilt sensor feedback, facilitating force and moment testing across various speeds. Wind …

    odu Repository record for Wind Tunnel Testing of a Novel Quadrotor Design (opens in a new tab)

  2. CFD simulations in support of wind tunnel testing

    CFD and wind tunnel simulations are complementary due to their inherent limitations. Wind tunnel tests apply to any hypothesis, but are limited by the tunnel wall interference/blockage, the model details, and even the distortion of the model. CFD are not limited in any of these ways, but limited in …

    glasgow Download PDF for CFD simulations in support of wind tunnel testing (opens in a new tab)

  3. Morphing wing system integration with wind tunnel testing

    … detect the transition during aerodynamic testing in the subsonic wind tunnel at the IAR-NRC in Ottawa. The first part of the work is dedicated to establishing the necessary fieldbus communications between the control system and the wing. The ‘CANopen’ protocol is implemented to ensure real …

    ets-quebec Download PDF for Morphing wing system integration with wind tunnel testing (opens in a new tab)

  4. An analysis of curved flow wind tunnel testing

    … of the flows involved in the curved flow wind tunnel and in curved flight. Equations for the forces and moments for each of these flows are presented and then used to develop equations for the corrections to the forces and moments obtained in curved flow wind tunnel tests. An example of …

    vt Repository record for An analysis of curved flow wind tunnel testing (opens in a new tab)

  5. Dynamic Force Measurement Capabilities for Hypersonic Wind Tunnel Testing

    … in collaboration with the Hypervelocity Wind Tunnel 9 at AEDC in White Oak, Maryland, is expected to provide accurate static and dynamic force and moment measurements on conventional test articles, providing simultaneous force, moment, heat transfer, and pressure measurements for maximal …

    maryland Repository record for Dynamic Force Measurement Capabilities for Hypersonic Wind Tunnel Testing (opens in a new tab)

  6. An analysis of data quality in transonic wind tunnel testing

    … of Tennessee Space Institute Transonic Wind Tunnel. Since no measurement is perfect, the aim was to provide a basis on which to suggest changes in equipment and technique in order to effect increased data accuracy.</p><p>Sources of uncertainty were identified through examination of test …

    ut-knoxville Repository record for An analysis of data quality in transonic wind tunnel testing (opens in a new tab)

  7. Boundary Layer Measurements Related to Wind Tunnel Testing of Riblets

    … conditions on scaled models in a low speed wind tunnel and examine boundary layer behavior. In this project, boundary layer measurement techniques, such as rake measurements and Preston tube measurements on a flat plate mounted on the wind tunnel side wall are presented with calibration …

    odu Repository record for Boundary Layer Measurements Related to Wind Tunnel Testing of Riblets (opens in a new tab)

  8. Structural Design and Wind Tunnel Testing of the Standing Whale Sculpture

    … was also used to model the load effects of wind considering a rigid structure. Because of how tall the structure is in comparison to its width, and how slender many of the structural elements are, a critical consideration was the assessment of the structure’s dynamic performance under wind …

    queens Repository record for Structural Design and Wind Tunnel Testing of the Standing Whale Sculpture (opens in a new tab)

  9. INVESTIGATION OF COMPOUND ROTORCRAFT AEROMECHANICS THROUGH WIND-TUNNEL TESTING AND ANALYSIS

    … compound rotorcraft is investigated through wind-tunnel testing and comprehensive analysis. The emphasis is on a lift-offset wing compound with a hingeless rotor configuration. A new Maryland Compound Rig is developed and instrumented for wind-tunnel testing and an in-house rotor …

    maryland Repository record for INVESTIGATION OF COMPOUND ROTORCRAFT AEROMECHANICS THROUGH WIND-TUNNEL TESTING AND ANALYSIS (opens in a new tab)

  10. External Aerodynamics of Heavy Ground Vehicles: Computations and Wind Tunnel Testing

    … In addition, engine cooling, air conditioning, wind noise, visibility, stability and crosswind sensitivity are some other tasks for vehicle aerodynamics. All of these areas benefit from drag reduction and changing the lift force in favor of the operating conditions. This can be achieved by …

    odu Repository record for External Aerodynamics of Heavy Ground Vehicles: Computations and Wind Tunnel Testing (opens in a new tab)

  11. Investigation of a grid induced turbulent environment for wind tunnel testing

    In performing wind tunnel model tests of a two-dimensional nature, a grid constructed of 3.6 x 0.75 inch boards on 18 inch centers was used at the entrance of the tunnel. Important properties of the turbulent flow behind the uniform coarse grid were determined. The flow was found to be quite …

    vt Repository record for Investigation of a grid induced turbulent environment for wind tunnel testing (opens in a new tab)

  12. Transition Detection for Low Speed Wind Tunnel Testing Using Infrared Thermography

    … important phenomenon in large scale, commercial, wind tunnel testing at low speeds because it is an excellent indicator of an airfoil performance. It is difficult to estimate transition through numerical techniques because of the complex nature of viscous flow. Therefore experimental techniques …

    vt Repository record for Transition Detection for Low Speed Wind Tunnel Testing Using Infrared Thermography (opens in a new tab)

  13. Wall interference correction based on interface measurements in subsonic wind tunnel testing

    … based on interface measurements in subsonic wind tunnel testing are investigated.</p> <p>The first method, called the Two-Interface method, is derived based on a small perturbation solution of the two-dimensional potential equation in subsonic flow. The method calculates a surface pressure …

    utk-theses Repository record for Wall interference correction based on interface measurements in subsonic wind tunnel testing (opens in a new tab)

  14. Transient Jet Interaction Force and Moment Reconstruction in Dynamic Wind-Tunnel Testing

    … when designing robust missile autopilots.</p> <p>Testing techniques for determining the transient jet interaction effect must be able to interpret force and moment data in the presence of the modal response of the missile model. Two techniques for accomplishing this have been investigated. One …

    utk-theses Repository record for Transient Jet Interaction Force and Moment Reconstruction in Dynamic Wind-Tunnel Testing (opens in a new tab)

  15. A method of automatic computer controlled model attitude during wind tunnel testing

    … to position the model to required angles during wind tunnel operation. Sting movements are achieved by outputting to digital to analog converters which drive motors in positioning the sting support system. Feedback to the computer allows predictions to be based on previous positions which reduces …

    ut-knoxville Repository record for A method of automatic computer controlled model attitude during wind tunnel testing (opens in a new tab)

  16. Evaluation of Ambient Particulate Matter (PM) Sampler Performance Through Wind Tunnel Testing

    … and existing ambient conditions. Controlled testing in a wind tunnel is needed to obtain a clearer understanding and quantification of the performance shifts of these samplers under varying aerosol concentrations, wind speeds and dust types. In this study, sampler performance was tested in a …

    tamu Repository record for Evaluation of Ambient Particulate Matter (PM) Sampler Performance Through Wind Tunnel Testing (opens in a new tab)

  17. Wind Tunnel Testing to Evaluate Noise Emissions from a Small Wind Turbine

    The wind power industry has experienced fast and tremendous growth, globally, in recent years. Consequently, there is a growing interest in investigating aerodynamics and aeroacoustics characteristics of wind turbines and developing environmental standards aimed at decreasing noise levels in the …

    carleton Repository record for Wind Tunnel Testing to Evaluate Noise Emissions from a Small Wind Turbine (opens in a new tab)

  18. A study of wind tunnel testing operations information management with a micro-computer

    … certain project management tasks for wind tunnel tests. The two methods are: traditional methods and a new proposed method using the Test Matrix Scheduling Program (TMSP) recently developed at the Arnold Engineering Development Center (AEDC) in the Propulsion Wind Tunnel (PWT) facility …

    ut-knoxville Repository record for A study of wind tunnel testing operations information management with a micro-computer (opens in a new tab)

Page 1 of 15