Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 44 for “"yield surfaces"”.

  1. An investigation of initial yield surfaces for unidirectional reinforced composites.

    Initial yield surfaces of unidirectional fiber reinforced composites subjected to combined longitudinal, transverse normal, and longitudinal shear loads are calculated. The composite is composed of filaments arranged in a periodic square array embedded in a matrix material. The constituent …

    nps Repository record for An investigation of initial yield surfaces for unidirectional reinforced composites. (opens in a new tab)

  2. Análise limite de problemas de estado plano

    … elements and the sectional linearization of the yield surfaces was required. The yield surfaces were based on the Tresca and von Mises resistence criteria. For solving the linear programming problem a revised Simplex algorithm was used in the computer program developed for checking the …

    brazil-uerj Repository record for Análise limite de problemas de estado plano (opens in a new tab)

  3. Experimental Study: Investigating Effect of Injection on Yield Surface, Stress Path Coefficients, and Associated Hysteresis in Unconsolidated Sands

    … changing the minimum in-situ stress magnitude, yield behavior, and associated hysteresis in unconsolidated sands. A novel sample preparation technique is presented to make consistent and representative samples of the target reservoir in deep-water. The variation of minimum in-situ stresses with …

    houston Repository record for Experimental Study: Investigating Effect of Injection on Yield Surface, Stress Path Coefficients, and Associated Hysteresis in Unconsolidated Sands (opens in a new tab)

  4. Development of a strain softening constitutive model for rock

    A plasticity based constitutive model with two yield surfaces is developed to model the nonlinear axial and volumetric behavior observed for rocks in triaxial compression. The failure surface is allowed to soften at low pressures to simulate fracturing. A method for treating the corner where the …

    rice Repository record for Development of a strain softening constitutive model for rock (opens in a new tab)

  5. The middle surface concept and its application to constitutive modeling of soils.

    … modeling concepts, characterized by a single yield surface, however, limit our ability to model complex stress-strain responses. In this dissertation, a novel modeling concept called the Middle Surface Concept (MSC), is developed using multiple pseudo yield surfaces. The MSC is first developed …

    oklahoma-thes Repository record for The middle surface concept and its application to constitutive modeling of soils. (opens in a new tab)

  6. Micromechanical modeling of elastic-plastic porous materials using finite element analysis

    … for elastic constants in terms of porosity. Yield surfaces are plotted and approximated by a yield function. The function's shape, hydrostatic strength, and deviatoric strength closely match the data for a wide range of porosities. Most significantly, plotting plastic strain rates relative to …

    rice Repository record for Micromechanical modeling of elastic-plastic porous materials using finite element analysis (opens in a new tab)

  7. Limit and shakedown analyses by the p-version fem

    … stage and use of approximate piecewise linear yield functions. The p-adaptive scheme produces a non-uniform p-distribution and helps to greatly reduce the number of degrees of freedom needed while still guaranteeing the required level of accuracy. The overall gain is that the sizes of the …

    unsw Repository record for Limit and shakedown analyses by the p-version fem (opens in a new tab)

  8. Time-critical design methods for suction caisson foundations

    … linear elastic soil reactions with plastic yield surfaces. To model cohesive soil, the plastic yield surfaces were calibrated against 3DFE analyses using linear elastic, perfectly plastic soil with a von Mises yield criterion.</p> <br> <p>Altogether, these design methods allow a rapid …

    oxford Repository record for Time-critical design methods for suction caisson foundations (opens in a new tab)

  9. Ανάλυση προσαρμογής μεταλλικών κατασκευών, υποβαλλόμενων σε αβέβαιη ελλειψοειδή φόρτιση, με τεχνικές στιβαρής βελτιστοποίησης

    … load domains and linearized or non-linear yield criteria, yielding computationally tractable linear/non-linear programming problems. However, non-linear load domains result into computationally intractable problems with an infinite number of constraints, called semi-infinite programming …

    greece Repository record for Ανάλυση προσαρμογής μεταλλικών κατασκευών, υποβαλλόμενων σε αβέβαιη ελλειψοειδή φόρτιση, με τεχνικές στιβαρής βελτιστοποίησης (opens in a new tab)

  10. Partially-drained loading of shallow foundations on sand

    … load:deformation behaviour and the combined load yield surfaces is described.</p>

    oxford Repository record for Partially-drained loading of shallow foundations on sand (opens in a new tab)

  11. Partially-drained loading of shallow foundations on sand

    … load:deformation behaviour and the combined yield surfaces are described.

    oxford Repository record for Partially-drained loading of shallow foundations on sand (opens in a new tab)

  12. Undrained behavior of plate anchors subjected to general loading

    … be used both to predict anchor capacity and as yield surfaces for conducting plastic limit analyses, a method capable of predicting post yield anchor trajectory. The model predictions are shown in reasonable good agreement with the experimental results. For SEPLA, a theoretical model of plastic …

    tamu Repository record for Undrained behavior of plate anchors subjected to general loading (opens in a new tab)

  13. On a Proposal for a Continuum With Microstructure

    … dynamics are deduced. When plastic strain and yield are identified in terms of the parameters characterizing the dislocation states, familiar flow rules and yield surfaces are produced. The capability of the model to predict not only Tresca and Von-Mises plastic behavior but also phenomena such …

    uiuc Repository record for On a Proposal for a Continuum With Microstructure (opens in a new tab)

  14. Anisotropic hardening of an initially isotropic porous limestone

    … behavior of a compacting material that exhibits yield-strength dependence upon hydrostatic pressure, prompted the present study to determine experimentally a yield envelope that would predict the material behavior more accurately. True triaxial tests were performed on Cordova Limestone in order …

    rice Repository record for Anisotropic hardening of an initially isotropic porous limestone (opens in a new tab)

  15. The earthquake stability of earth structures

    … method of dynamic analysis uses a set of nested yield surfaces to represent shear stress-strain behaviour. These yield surfaces are defined by von Mises failure criterion, have an associated flow rule and undergo both kinematic and isotropic hardening. An empirical model is used to calculate the …

    auckland-ms Repository record for The earthquake stability of earth structures (opens in a new tab)

  16. Experimental Methods for the Constitutive Characterization of Sheet Materials in Generalized Plane Strain

    … parts, but determination of the plane strain yield strength is complicated. Although plane strain notch experiments are simple to perform, their analysis is not straightforward since the load distribution along the sample gauge width transitions from plane strain tension in the middle to …

    waterloo Repository record for Experimental Methods for the Constitutive Characterization of Sheet Materials in Generalized Plane Strain (opens in a new tab)

  17. Finite element modeling of tornado missile impact on reinforced concrete wall panels

    … proposed to describe the initial and subsequent yield surfaces of concrete material, which avoids underestimation of the effect of high hydrostatic stresses on the yielding behavior of concrete. Ottosen's four-parameter failure criterion is used to define the failure surface of concrete. A crack …

    ttu Repository record for Finite element modeling of tornado missile impact on reinforced concrete wall panels (opens in a new tab)

  18. Eλαστοπλαστικά κριτήρια διαρροής πολλαπλών επιφανειών: αριθμητική επίλυση στο χώρο των κύριων τάσεων και εφαρμογή σε προβλήματα γεωτεχνικής μηχανικής

    … algorithms for the numerical treatment of yield criteria defined by multiple intersecting surfaces. The objective of this thesis is the numerical implementation of a simple, general, reliable and efficient procedure for the numerical treatment of the abovementioned problem, within the …

    greece Repository record for Eλαστοπλαστικά κριτήρια διαρροής πολλαπλών επιφανειών: αριθμητική επίλυση στο χώρο των κύριων τάσεων και εφαρμογή σε προβλήματα γεωτεχνικής μηχανικής (opens in a new tab)

  19. A nonlinear viscoplastic double yield surface constitutive model for geologic materials

    … this aim the constitutive model is based on two yield surfaces based on overstress viscoplasticity theory: one is quasi-instantaneous (for the fast part of plastic deformations) and the other is viscous (for the slow part of plastic deformations). This assumption permits the reliable simulation …

    trento Repository record for A nonlinear viscoplastic double yield surface constitutive model for geologic materials (opens in a new tab)

Page 1 of 3