{"id":{"repo_id":"utahstate","oai_identifier":"oai:digitalcommons.usu.edu:etd-1734"},"canonical_url":"https://search.ndltd.org/etd/utahstate/oai:digitalcommons.usu.edu:etd-1734","repository":{"repo_id":"utahstate","name":"Utah State University","base_url":"https://digitalcommons.usu.edu/do/oai/"},"display":{"title":"Comparative Studies on Oxygen Mass Transfer for the Design and Development of a Single-Use Fermentor","abstract":"Accurate experimental oxygen mass transfer coefficient, a measure of how quickly oxygen travels from a gas bubble to the bulk liquid, is important for comparing performance and for evaluating the oxygen transfer capability of a fermentor. Delays in probe response and changing gas volumes upon start-up of gassing affect the accuracy of oxygen transfer measurements. To mitigate these inaccuracies, a standard correction procedure for oxygen mass transfer data was established for highly oxygenated, well-mixed fermentation systems. Probe response time correction was generated by applying a second-order response model to dissolved oxygen probes and shown to be effective within 4%. By using a derived model for transient volume rise, the effect of changing gas volume at start-up was shown to cause very minimal error (1-2%) in kLa. The unsteady-state method of kLa determination was used to compare design aspects of a hypothetical fermentor, including gas sparging devices and locations, baffle geometries and quantities, and impeller configurations. It was shown that locating the sparging device in the center of the tank, directly below the drive shaft and bottom impeller, is optimal for oxygen mass transfer. Sparger type was shown to have little effect on oxygen mass transfer values, although an open-pipe sparger was shown to provide slightly more oxygen mass transfer than a ring sparger. The use of rounded baffles in place of traditional rectangular baffles resulted in a 67-80% decrease in oxygen mass transfer coefficient. A comparison of three and four traditional baffles showed that three baffles produced a higher oxygen mass transfer than four. Correlation of baffle ratio and oxygen mass transfer coefficient indicated that the optimum baffle ratio is approximately one. Radial impellers were observed to provide better mixing, and thus higher oxygen mass transfer coefficients than axial impellers. In seven of ten comparisons, an impeller quantity ratio of 1.33 instead of 1.00 provided significant improvement in kLa. Additionally, only two of ten comparisons showed a difference between traditional Rushton turbine impellers and Smith turbine impellers, indicating that the difference in oxygen mass transfer capability of the two is negligible.","abstract_html":"Accurate experimental oxygen mass transfer coefficient, a measure of how quickly oxygen travels from a gas bubble to the bulk liquid, is important for comparing performance and for evaluating the oxygen transfer capability of a fermentor. Delays in probe response and changing gas volumes upon start-up of gassing affect the accuracy of oxygen transfer measurements. To mitigate these inaccuracies, a standard correction procedure for oxygen mass transfer data was established for highly oxygenated, well-mixed fermentation systems. Probe response time correction was generated by applying a second-order response model to dissolved oxygen probes and shown to be effective within 4%. By using a derived model for transient volume rise, the effect of changing gas volume at start-up was shown to cause very minimal error (1-2%) in kLa. The unsteady-state method of kLa determination was used to compare design aspects of a hypothetical fermentor, including gas sparging devices and locations, baffle geometries and quantities, and impeller configurations. It was shown that locating the sparging device in the center of the tank, directly below the drive shaft and bottom impeller, is optimal for oxygen mass transfer. Sparger type was shown to have little effect on oxygen mass transfer values, although an open-pipe sparger was shown to provide slightly more oxygen mass transfer than a ring sparger. The use of rounded baffles in place of traditional rectangular baffles resulted in a 67-80% decrease in oxygen mass transfer coefficient. A comparison of three and four traditional baffles showed that three baffles produced a higher oxygen mass transfer than four. Correlation of baffle ratio and oxygen mass transfer coefficient indicated that the optimum baffle ratio is approximately one. Radial impellers were observed to provide better mixing, and thus higher oxygen mass transfer coefficients than axial impellers. In seven of ten comparisons, an impeller quantity ratio of 1.33 instead of 1.00 provided significant improvement in kLa. Additionally, only two of ten comparisons showed a difference between traditional Rushton turbine impellers and Smith turbine impellers, indicating that the difference in oxygen mass transfer capability of the two is negligible.","abstract_has_math":false,"creators":["Sorenson, Kristan L."],"institution":"Hosted by Utah State University Libraries","degree_name":"Master of Science (MS)","degree_level":"Thesis","degree_discipline":"Biological Engineering","degree_department":null,"school":null,"contributors":["Timothy Taylor","Ronald Sims","Heng Ban"],"advisors":[],"committee_chairs":[],"committee_members":[],"year":null,"date_issued":"","date_published":null,"updated_at":"2026-11-19T08:46:30Z","subjects":["comparative studies","oxygen mass transfer","design","development","single-use fermentor","Biomedical Engineering and Bioengineering","Chemical Engineering"],"languages":[],"rights":[],"rights_urls":[],"identifier_entries":[{"key":"dc:identifier.doi","label":"DOI","values":["https://doi.org/10.26076/0d17-f7fa"],"render_values":[{"text":"https://doi.org/10.26076/0d17-f7fa","href":"https://doi.org/10.26076/0d17-f7fa","code":true}]}],"person_identifier_entries":[]},"links":{"outbound_url":"https://digitalcommons.usu.edu/etd/738","outbound_label":"Repository record","outbound_source":"dc:identifier","record_url":"https://digitalcommons.usu.edu/etd/738","record_label":"Repository record","record_kind":"record","record_source":"dc:identifier","download_url":null,"download_label":null,"download_source":null,"access_status":null,"embargo_until":null,"access_note":null},"source_record":{"url":"https://digitalcommons.usu.edu/do/oai/?verb=GetRecord&metadataPrefix=oai_etdms&identifier=oai%3Adigitalcommons.usu.edu%3Aetd-1734","prefix":"oai_etdms"},"metadata_groups":[{"id":"people","label":"People","entries":[{"key":"dc:contributor","label":"Contributor","values":["Timothy Taylor","Ronald Sims","Heng Ban"]},{"key":"dc:creator","label":"Author","values":["Sorenson, Kristan L."]}]},{"id":"academic_context","label":"Academic Context","entries":[{"key":"dc:date.available","label":"Dc Date Available","values":["2010-08-30T07:00:00Z"]},{"key":"dc:date.created","label":"Dc Date Created","values":["2010-05-01T07:00:00Z"]},{"key":"dc:publisher","label":"Institution","values":["Hosted by Utah State University Libraries"]},{"key":"thesis:degree_discipline","label":"Discipline","values":["Biological Engineering"]},{"key":"thesis:degree_level","label":"Degree Level","values":["Thesis"]},{"key":"thesis:degree_name","label":"Degree Name","values":["Master of Science (MS)"]}]},{"id":"subjects_keywords","label":"Subjects and Keywords","entries":[{"key":"dc:subject","label":"Dc Subject","values":["comparative studies","oxygen mass transfer","design","development","single-use fermentor","Biomedical Engineering and Bioengineering","Chemical Engineering"]}]},{"id":"identifiers","label":"Identifiers","entries":[{"key":"dc:identifier","label":"Identifier","values":["https://digitalcommons.usu.edu/etd/738"]},{"key":"dc:identifier.doi","label":"DOI","values":["https://doi.org/10.26076/0d17-f7fa"]}]},{"id":"additional","label":"Additional Metadata","entries":[{"key":"dc:description.abstract","label":"Abstract","values":["Accurate experimental oxygen mass transfer coefficient, a measure of how quickly oxygen travels from a gas bubble to the bulk liquid, is important for comparing performance and for evaluating the oxygen transfer capability of a fermentor. Delays in probe response and changing gas volumes upon start-up of gassing affect the accuracy of oxygen transfer measurements. To mitigate these inaccuracies, a standard correction procedure for oxygen mass transfer data was established for highly oxygenated, well-mixed fermentation systems. Probe response time correction was generated by applying a second-order response model to dissolved oxygen probes and shown to be effective within 4%. By using a derived model for transient volume rise, the effect of changing gas volume at start-up was shown to cause very minimal error (1-2%) in kLa. The unsteady-state method of kLa determination was used to compare design aspects of a hypothetical fermentor, including gas sparging devices and locations, baffle geometries and quantities, and impeller configurations. It was shown that locating the sparging device in the center of the tank, directly below the drive shaft and bottom impeller, is optimal for oxygen mass transfer. Sparger type was shown to have little effect on oxygen mass transfer values, although an open-pipe sparger was shown to provide slightly more oxygen mass transfer than a ring sparger. The use of rounded baffles in place of traditional rectangular baffles resulted in a 67-80% decrease in oxygen mass transfer coefficient. A comparison of three and four traditional baffles showed that three baffles produced a higher oxygen mass transfer than four. Correlation of baffle ratio and oxygen mass transfer coefficient indicated that the optimum baffle ratio is approximately one. Radial impellers were observed to provide better mixing, and thus higher oxygen mass transfer coefficients than axial impellers. In seven of ten comparisons, an impeller quantity ratio of 1.33 instead of 1.00 provided significant improvement in kLa. Additionally, only two of ten comparisons showed a difference between traditional Rushton turbine impellers and Smith turbine impellers, indicating that the difference in oxygen mass transfer capability of the two is negligible."]},{"key":"dc:description.note","label":"Dc Description Note","values":["<p>This work made publicly available electronically on August 30, 2010.</p>"]},{"key":"dc:title","label":"Title","values":["Comparative Studies on Oxygen Mass Transfer for the Design and Development of a Single-Use Fermentor"]}]}],"canonical_facts":{"dc:contributor":["Timothy Taylor","Ronald Sims","Heng Ban"],"dc:creator":["Sorenson, Kristan L."],"dc:date.available":["2010-08-30T07:00:00Z"],"dc:date.created":["2010-05-01T07:00:00Z"],"dc:description.abstract":["Accurate experimental oxygen mass transfer coefficient, a measure of how quickly oxygen travels from a gas bubble to the bulk liquid, is important for comparing performance and for evaluating the oxygen transfer capability of a fermentor. Delays in probe response and changing gas volumes upon start-up of gassing affect the accuracy of oxygen transfer measurements. To mitigate these inaccuracies, a standard correction procedure for oxygen mass transfer data was established for highly oxygenated, well-mixed fermentation systems. Probe response time correction was generated by applying a second-order response model to dissolved oxygen probes and shown to be effective within 4%. By using a derived model for transient volume rise, the effect of changing gas volume at start-up was shown to cause very minimal error (1-2%) in kLa. The unsteady-state method of kLa determination was used to compare design aspects of a hypothetical fermentor, including gas sparging devices and locations, baffle geometries and quantities, and impeller configurations. It was shown that locating the sparging device in the center of the tank, directly below the drive shaft and bottom impeller, is optimal for oxygen mass transfer. Sparger type was shown to have little effect on oxygen mass transfer values, although an open-pipe sparger was shown to provide slightly more oxygen mass transfer than a ring sparger. The use of rounded baffles in place of traditional rectangular baffles resulted in a 67-80% decrease in oxygen mass transfer coefficient. A comparison of three and four traditional baffles showed that three baffles produced a higher oxygen mass transfer than four. Correlation of baffle ratio and oxygen mass transfer coefficient indicated that the optimum baffle ratio is approximately one. Radial impellers were observed to provide better mixing, and thus higher oxygen mass transfer coefficients than axial impellers. In seven of ten comparisons, an impeller quantity ratio of 1.33 instead of 1.00 provided significant improvement in kLa. Additionally, only two of ten comparisons showed a difference between traditional Rushton turbine impellers and Smith turbine impellers, indicating that the difference in oxygen mass transfer capability of the two is negligible."],"dc:description.note":["<p>This work made publicly available electronically on August 30, 2010.</p>"],"dc:identifier":["https://digitalcommons.usu.edu/etd/738"],"dc:identifier.doi":["https://doi.org/10.26076/0d17-f7fa"],"dc:publisher":["Hosted by Utah State University Libraries"],"dc:subject":["comparative studies","oxygen mass transfer","design","development","single-use fermentor","Biomedical Engineering and Bioengineering","Chemical Engineering"],"dc:title":["Comparative Studies on Oxygen Mass Transfer for the Design and Development of a Single-Use Fermentor"],"thesis:degree_discipline":["Biological Engineering"],"thesis:degree_level":["Thesis"],"thesis:degree_name":["Master of Science (MS)"]},"updated_at":"2026-11-19T08:46:30Z"}