Spelling suggestions: "subject:"[een] HERSCHEL-BULKLEY"" "subject:"[enn] HERSCHEL-BULKLEY""
41 |
Hydrodynamické tlumiče na principu magnetické kapaliny / Hydrodynamic dampers on the principle of magnetic fluidPřikryl, Matěj January 2017 (has links)
This diploma thesis covers the topic of magnetic fluids and their utilisation in hydrodynamic dampers. The first part of the work consists of research on the current state of technology in hydraulic dampers with the focus on dampers using magnetorhelogical fluid. This chapter is followed by research on magnetic fluids with regard to their physical properties and mathematical description, which is used for CFD simulation of flow. The second part deals with the computational simulation of the flow of MR liquid in real MR damper in order to determine the damping characteristic and it's comparison with the experimental data.
|
42 |
Optimisation of methane production from anaerobically digested cow slurry using mixing regime and hydraulic retention timeHughes, Kevin Lewis William January 2015 (has links)
AD is regarded as a sustainable technology that could assist the UK Government meet internationally agreed GHG emission targets by 2050. However, the mature status of the technology is based on expensive systems that rely on high energy feedstock to be profitable. Meanwhile, the natural biodegradation of cow slurry is a recognised contributor to climate change despite having a relatively low CH4 potential because of the large volumes produced. Economic mixing is essential to the cost-effectiveness of farm AD but techniques applied are not always appropriate as slurry is a shear thinning thixotropic Herschel-Bulkley fluid and therefore challenging to mix. The apparent viscosity of slurry and the shear stress induced was most influenced by solids content (exponential change) followed by temperature (linear). Most shear thinning occurred before a rising shear rate of 20s-1 was achieved with the fluid acting near-Newtonian above. Thixotropic recovery occurred within 1 hour of resting. Rheological values were also much higher than previously reported. Highest CH4 production occurred in the first 10 days of the batch process using a range of mixing regimes with different shear rates and rest periods. During fed-batch operations, changing shear rate had a minimal effect on CH4 production using a 30-day HRT whereas shorter rest periods increased production. Specific CH4 production rate was highest when feeding and mixing coincided. However, when HRT was reduced (OLR increased) the CH4 produced by all mixed regimes significantly increased with highest values being achieved using high intensity mixing rested for short periods. Lower HRTs also requires smaller digesters. Parasitic mixing energy invariably had the most influence on net energy production. Signs of instability were evident after 20 days using the low HRT. Significant microbial adaptation was also observed as the experiments progressed. The research outcomes demonstrate that mixing regime and HRT can be managed to maximise net energy production whilst reducing capital expenditure.
|
Page generated in 0.0348 seconds