In recent years, space-time block co'des (STBC) for multi-antenna wireless systems have emerged as attractive encoding schemes for wireless communications. These codes provide full diversity gain and achieve good performance with simple receiver structures without the additional increase in bandwidth or power requirements. When implemented over broadband channels, STBCs can be combined with orthogonal frequency division multiplexing (OFDM) or single carrier frequency domain (SC-FD) transmission schemes to achieve multi-path diversity and to decouple the broadband frequency selective channel into independent flat fading channels. This dissertation focuses on the SC-FD transmission schemes that exploit the STBC structure to provide computationally cost efficient receivers in terms of equalization and channel estimation. The main contributions in this dissertation are as follows: • The original SC-FD STBC receiver that bench marks STBC in a frequency selective channel is limited to coherent detection where the knowledge of the channel state information (CSI) is assumed at the receiver. We extend this receiver to a multiple access system. Through analysis and simulations we prove that the extended system does not incur any performance penalty. This key result implies that the SC-FD STBC scheme is suitable for multiple-user systems where higher data rates are possible. • The problem of channel estimation is considered in a time and frequency selective environment. The existing receiver is based on a recursive least squares (RLS) adaptive algorithm and provides joint equalization and interference suppression. We utilize a system with perfect channel state information (CSI) to show from simulations how various design parameters for the RLS algorithm can be selected in order to get near perfect CSI performance. • The RLS receiver has two modes of operation viz. training mode and direct decision mode. In training mode, a block of known symbols is used to make the initial estimate. To ensure convergence of the algorithm a re-training interval must be predefined. This results in an increase in the system overhead. A linear predictor that utilizes the knowled~e of the autocorrelation function for a Rayleigh fading channel is developed. The predictor is combined with. the adaptive receiver to provide a bandwidth efficient receiver by decreasing the training block size.· The simulation results show that the performance penalty for the new system is negligible. • Finally, a new Q-R based receiver is developed to provide a more robust solution to the RLS adaptive receiver. The simulation results clearly show that the new receiver outperforms the RLS based receiver at higher Doppler frequencies, where rapid channel variations result in numerical instability of the RLS algorithm. The linear predictor is also added to the new receiver which results in a more robust and bandwidth efficient receiver. / Thesis (M.Sc.Eng.)-University of KwaZulu-Natal, Durban, 2005.

Multi-input multi-output (MIMO) control system design is much more difficult than single-input single output (SISO) design due to the combination of cross-coupling and uncertainty. An investigation is undertaken into both the classical Quantitative Feedback Theory (QFT) and modern H-infinity frequency domain design methods. These design tools are applied to a bank-to-turn (BTT) missile plant at multiple operating points for a gain scheduled implementation. A new method is presented that exploits both QFT and H-infinity design methods. It is shown that this method gives insight into the H-infinity design and provides a classical approach to tuning the final H-infinity controller. The use of “true” inversionfree design equations, unlike the theory that appears in current literature, is shown to provide less conservative bounds at frequencies near and beyond the gain cross-over frequency. All of the techniques investigated and presented are applied to the BTT missile to show their application to a practical problem. It was found that the H-infinity design method was able to produce satisfactory controllers at high angles of attack where there were no QFT solutions found. Although an H-infinity controller was produced for all operating points except the last, the controllers were found to be of very high-order, contain very poorly damped second order terms and generally more conservative, as opposed to the QFT designs. An investigation into simultaneous stabilization of multiple plants using Hinfinity is also presented. Although a solution to this was not found, a strongly justified case to entice further investigation is presented. / Thesis (M.Sc.Eng.)-University of KwaZulu-Natal, Durban, 2011.

Recent research has shown that multiple-input multiple-output (MIMO) systems provide high spectral efficiencies and error performance gains. However, the use of multiple antennas in mobile terminals may not be very practical. Certainly there is limited space and other implementation issues which make this a challenging problem. Therefore, to harness the diversity gains afforded by MIMO transmitter diversity techniques, while maintaining a minimal number of antennas on each handset, cooperative diversity techniques have been proposed. In addition, attention has also been given to combining wireless relaying systems with MIMO techniques to improve capacity, coverage, and obtain better diversity at the expense of increased node complexity. This thesis considers the design and analysis of cooperative diversity systems and MIMO amplify-and-forward relaying systems. In particular, we investigate adaptive time- and frequency-domain equalization techniques for cooperative diversity systems using space-time block codes (STBC). For MIMO relaying systems, we analyze the ergodic capacity of various systems and compare different amplify-and-forward methods in terms of system capacity performance. We propose a new block time-domain adaptive equalization structure for time reversal-space time block coding (TR-STBC) systems, which eliminates the separate decoder and also the need for explicit channel state information (CSI) estimation at the receiver. Our simulation results show that the time-domain adaptive block equalizer performs better than the frequency-domain counterpart but at the cost of increased complexity. Then, we extend this time-domain adaptive equalization scheme to distributed TR-STBC systems. We also develop a frequency-domain counterpart for the distributed systems. Our simulation results show that the adaptive algorithms work well for Protocols I and III proposed by Nabar et al. The time-domain adaptive algorithms perform better than the frequency-domain algorithms, and overall the Protocol I receivers outperform the Protocol III receivers. We also show that, if only the Protocol III receiver is used, it can be susceptible to noise amplification due to a weaker source-to-relay link compared to the relay-to-destination link. This problem can be mitigated by using the Protocol I receivers with some extra complexity but much superior diversity performance. We also present an ergodic capacity analysis of an amplify-and-forward (AF) MIMO two-hop system including the direct link and validate the analysis with simulations. We show that having the direct link improves the capacity due to diversity and quantify this improvement. We also present an ergodic capacity analysis of an AF MIMO two-hop, two relay system. Our results verify the capacity gain of relaying systems with two relays due to the extra diversity compared to a single relaying system. However, the results also show that when one of the source-to-relay links has a markedly higher SNR compared to the other, a single relay system has better capacity than a two relay system. Finally, we compare three types of relay amplification methods: a) average amplification, b) instantaneous channel amplification, and c) instantaneous power amplification. The instantaneous power amplification method has a higher mean capacity but with a higher variance. Also, it requires additional information at the destination and would create enormous overheads compared to the other methods. We also find that the instantaneous channel amplification method has almost no advantage in terms of the mean capacity but its capacity is less variable than the average amplification method. On the other hand, the average amplification method is simpler to implement as it does not require channel estimation at the relaying terminal.

Doctor of Philosophy / The next generation mobile networks are expected to provide multimedia applications with a high quality of service. On the other hand, interference among multiple base stations (BS) that co-exist in the same location limits the capacity of wireless networks. In conventional wireless networks, the base stations do not cooperate with each other. The BSs transmit individually to their respective mobile stations (MS) and treat the transmission from other BSs as interference. An alternative to this structure is a network cooperation structure. Here, BSs cooperate with other BSs to simultaneously transmit to their respective MSs using the same frequency band at a given time slot. By doing this, we significantly increase the capacity of the networks. This thesis presents novel research results on a noncooperative transmission scheme and a cooperative transmission scheme for multi-user multiple-input-multiple-output orthogonal frequency division multiplexing (MIMO-OFDM). We first consider the performance limit of a noncooperative transmission scheme. Here, we propose a method to reduce the interference and increase the throughput of orthogonal frequency division multiplexing (OFDM) systems in co-working wireless local area networks (WLANs) by using joint adaptive multiple antennas(AMA) and adaptive modulation (AM) with acknowledgement (ACK) Eigen-steering. The calculation of AMA and AM are performed at the receiver. The AMA is used to suppress interference and to maximize the signal-to-interference-plus-noise ratio (SINR). The AM scheme is used to allocate OFDM sub-carriers, power, and modulation mode subject to the constraints of power, discrete modulation, and the bit error rate (BER). The transmit weights, the allocation of power, and the allocation of sub-carriers are obtained at the transmitter using ACK Eigen-steering. The derivations of AMA, AM, and ACK Eigen-steering are shown. The performance of joint AMA and AM for various AMA configurations is evaluated through the simulations of BER and spectral efficiency (SE) against SIR. To improve the performance of the system further, we propose a practical cooperative transmission scheme to mitigate against the interference in co-working WLANs. Here, we consider a network coordination among BSs. We employ Tomlinson Harashima precoding (THP), joint transmit-receive beamforming based on SINR (signal-to-interference-plus-noise-ratio) maximization, and an adaptive precoding order to eliminate co-working interference and achieve bit error rate (BER) fairness among different users. We also consider the design of the system when partial channel state information (CSI) (where each user only knows its own CSI) and full CSI (where each user knows CSI of all users) are available at the receiver respectively. We prove analytically and by simulation that the performance of our proposed scheme will not be degraded under partial CSI. The simulation results show that the proposed scheme considerably outperforms both the existing noncooperative and cooperative transmission schemes. A method to design a spectrally efficient cooperative downlink transmission scheme employing precoding and beamforming is also proposed. The algorithm eliminates the interference and achieves symbol error rate (SER) fairness among different users. To eliminate the interference, Tomlinson Harashima precoding (THP) is used to cancel part of the interference while the transmit-receive antenna weights cancel the remaining one. A new novel iterative method is applied to generate the transmit-receive antenna weights. To achieve SER fairness among different users and further improve the performance of MIMO systems, we develop algorithms that provide equal SINR across all users and order the users so that the minimum SINR for each user is maximized. The simulation results show that the proposed scheme considerably outperforms existing cooperative transmission schemes in terms of the SER performance and complexity and approaches an interference free performance under the same configuration. We could improve the performance of the proposed interference cancellation further. This is because the proposed interference cancellation does not consider receiver noise when calculating the transmit-receive weight antennas. In addition, the proposed scheme mentioned above is designed specifically for a single-stream multi-user transmission. Here, we employ THP precoding and an iterative method based on the uplink-downlink duality principle to generate the transmit-receive antenna weights. The algorithm provides an equal SINR across all users. A simpler method is then proposed by trading off the complexity with a slight performance degradation. The proposed methods are extended to also work when the receiver does not have complete Channel State Informations (CSIs). A new method of setting the user precoding order, which has a much lower complexity than the VBLAST type ordering scheme but with almost the same performance, is also proposed. The simulation results show that the proposed schemes considerably outperform existing cooperative transmission schemes in terms of SER performance and approach an interference free performance. In all the cooperative transmission schemes proposed above, we use THP to cancel part of the interference. In this thesis, we also consider an alternative approach that bypasses the use of THP. The task of cancelling the interference from other users now lies solely within the transmit-receive antenna weights. We consider multiuser Gaussian broadcast channels with multiple antennas at both transmitter and receivers. An iterative multiple beamforming (IMB) algorithm is proposed, which is flexible in the antenna configuration and performs well in low to moderate data rates. Its capacity and bit error rate performance are compared with the ones achieved by the traditional zero-forcing method.

Diss. Uppsala : Univ., 2002.

Thesis (Ph.D.)--University of Wollongong, 2005. / Typescript. Includes bibliographical references: leaf 147-153.

Thesis (Ph. D.)--University of Texas at Austin, 2008. / Vita. Includes bibliographical references.

Thesis (Ph. D.)--University of Canterbury, 2008. / Typescript (photocopy). "March 2008." Includes bibliographical references (p. [161]-173). Also available via the World Wide Web.

Thesis (M.S.)--Brigham Young University. Dept. of Electrical and Computer Engineering, 2004. / Includes bibliographical references (p. 81-82).

Thesis (Ph. D.)--Ohio State University, 2003. / Title from first page of PDF file. Document formatted into pages; contains ix, 99 p.; also includes graphics Includes bibliographical references (p. 94-99). Available online via OhioLINK's ETD Center