[pt] O método GPR Ground Penetrating Radar foi empregado nesta pesquisa visando estimar suas potencialidades como uma metodologia viável para os estudos geológicos, geotécnicos e ambientais em condições brasileiras.Para o alcance deste objetivo foram realizados ensaios em campo procurando avaliar a capacidade deste método na detecção das alterações provenientes da ação intempérica na formação do solo residual, ou seja, estimar a profundidade e espessura dos horizontes pedológicos, e o topo rochoso em um perfil geotécnio. Foram também realizados ensaios em laboratório onde fez-se o monitoramento do efeito da contaminação por hidrocarbonetos em blocos indeformados de solo residual, tanto em condições não saturadas, quanto na zona de saturação, procurando avaliar a aplicabilidade do método GPR na detecção deste tipo de contaminante.Os resultados obtidos permitiram imagear com boa resolução os contrastes bruscos, como o topo da rocha sã e blocos inclusos no solo, mas não a detecção nítida dos horizontes no perfil; e pela análise do monitoramento da contaminação, ainda é recente afirmar que o método GPR possa ser empregado com grande eficiência na detecção de contaminantes orgânicos em solo residual. / [en] The GPR method Ground Penetration Radar was used in this work, aiming at estimating its potentialities as a viable methodology to geological, geotechnical and environmental studies of Brazilian soil-rock conditions.In order to reach this objective, in situ tests have been carried out to evaluate the capability of the method in the detection of characteristics of weathering profiles in residual soils. In this case, the aim was to estimate the depth and width of pedological horizons and the bedrock in a geotechnical profile. Laboratory tests were also carried out in blocks of undisturbed residual soil of gnaissic origin. In these blocks, the effects of contamination by petroleum hydrocarbons were monitored. Both the unsaturated and the vadose zones have been monitored. The main objective in relation to the GPR was to evaluate the applicability of the method in the detection of such contaminants.The results obtained allowed to image gross contacts with good resolution such as soil-intact bedrock contacts and blocks inside soils. However, the clear detection of profile horizons were not well imaged. Regarding the contamination monitoring, it is early to affirm that the GPR method might be employed efficiently in the detection of organic contaminants in residual soils.

With large populations living in tropical regions of the world with volcanic substrates, understanding basalt weathering processes is vital. The Hawaiian Islands are an excellent natural analogue to study chemical weathering rates due to a uniform bedrock (basalt), large variations in rainfall, and varying ages across the islands. Laterite weathering profiles (LWP) develop over time through chemical weathering, where LWP thickness is influenced by many factors, including precipitation and time. Using the rapid, non-invasive horizontal-to-vertical spectral ratio (HVSR) method, LWP thicknesses can be estimated to constrain chemical weathering rates. Studying the laterite weathering profiles developed from basaltic bedrock of varying ages on Oahu (~2 Ma), Molokai (~1 Ma) and Kohala, Hawaii (~0.3 Ma) reveals three profiles in varying developmental stages. Over 200 HVSR soundings were collected on Oahu, Molokai, and Kohala. Shear wave velocity values of LWPs were determined by MASW (multichannel analysis of surface waves), and LWP thicknesses verified from geologic logs and outcrop. Oahu has thick LWPs compared to the other islands and shows a trend of increasing thickness with increasing precipitation across the island. The Molokai LWP follows a trend similar to Oahu, with a noticeable difference of thicknesses (20-40 m) at similar precipitation thresholds. Molokai presented a unique case, where the shear-wave velocity (Vs) boundaries between laterite and basalt were gradational for ~43% of HVSR datapoints, resulting in featureless frequency spectra that could not reliably model laterite-basalt boundary depths. The gradational nature of the LWP of Molokai is attributed to the young age of the island, and primary permeability properties of the thick, post-shield alkalic lavas. Molokai has an aerially average weathering rate of 0.02 to 0.04 m/ka. Kohala HVSR data show a newly developed LWP with varying LWP thickness within the same precipitation isohyet. LWPs on Kohala show a unique trend where LWP is thickest along the coast and is wedge shaped thinning out towards higher elevations. Each island differs in age and has its own unique LWP trends, with older islands tending to have deeper, more developed LWPs at similar precipitation ranges.

Comparer de manière approfondie la réponse des différents outils isotopiques choisis (Li, B et U) durant l’altération chimique dans un profil déjà connu (e.g. le profil du Sommet sur le Bassin versant du Strengbach ; Ackerer, 2017) afin de dégager les mécanismes moteurs des fractionnements isotopiques de chacun de ces éléments pour faire le lien entre la réponse de ces outils lors de l’altération chimique et remonter ainsi au régime d’altération des roches. Développer les observations réalisées sur le profil du Sommet et les appliquer sur cinq autres profils d’altération répartis sur l’ensemble du bassin versant en se concentrant sur la fraction <2µm. Cela permettra de voir si les observations faites dans le premier profil se retrouvent dans les autres profils et si nous sommes capables de remonter au régime d’altération. Étudier de manière préliminaire comment évolue le signal isotopique de l’altération chimique acquis dans les profils d’altération au cours du transport sédimentaire et s’il est possible de déterminer le régime d’altération d’un bassin versant à partir des sédiments de ce même bassin. / In-depth comparison of the response of various selected isotopic tools (Li, B and U) during chemical weathering in an already known profile (eg the Summit profile in the Strengbach watershed, Ackerer, 2017) to identify the driving mechanisms of isotopic fractionations of these elements to link the response of these tools compared to the chemical alteration to go back to the alteration regime. Develop the observations made on the Summit profile and apply them to five other weathering profiles distributed over the entire watershed focusing on the <2μm fraction. This will make it possible to see if the observations made in the first profile are found in the other profiles and if we are able to go back to the alteration regime. Preliminarily investigate how the isotopic signal of chemical alteration acquired in alteration profiles evolves during the sediment transportation and if it is possible to determine the alteration regime of a watershed from it sediments.