211 |
Barkhausen and magneto-acoustic emission from ferromagnetic materialsButtle, D. J. January 1986 (has links)
Barkhausen emission (B.E.) and Magneto-acoustic emission (M.A.E.) can be detected from specimens in a magnetic field varying at a few millihertz. Comparison of the two signals can indicate the nature of the domain walls responsible for the activity at any particular field. In order to characterize a specimen the strength of the emissions around the hysteresis loop are measured together with the distribution of Barkhausen event sizes. This technique has been used to measure the effects of: (A) Microstructure. Both B.E. and M.A.E. are sensitive to dislocations, and the effects of cold-working and its removal by isochronal annealing has been studied in alpha-iron. A simple model of domain wall pinning is presented which enables the dislocation density to be estimated. M.A.E. and B.E. are also sensitive to the growth of precipitates in Incoloy 904 alloy and, for a certain regime of sizes, can potentially be used to monitor the precipitate diameter. B.E. is sensitive to smaller precipitates (-100 nm) than M.A.E. but, unlike M.A.E., its dependence on precipitate size is not monotonic. An understanding of the signal dependence is obtained from Lorentz microscopy. (B) Radiation damage. The sensitivity of B.E. and M.A.E. to radiation damage is quite small by virtue of the small size of defects present. Nevertheless measurements on neutron irradiated alpha-iron specimens in several microstructural states indicate: (a) an accelerated recovery from the cold-worked condition on isochronal annealing and (b) dissolution of nitrides and carbides which formed in preparatory heat treatments. Measurements on a neutron irradiated iron-copper alloy which was subsequently isochronally annealed indicated effects which were consistent with: (a) removal of dislocation loops formed during irradiation at 550°C and (b) growth of precipitates (probably copper) at 600°C which presumably formed during the irradiation, (i.e. the effect was smaller in unirradiated control specimens). These results suggest that B.E. and M.A.E. might be useful tools for the characterization of radiation effects. (C) Tensile stress. Both B.E. and M.A.E. are sensitive to applied tensile stress and measurements on a number of different materials indicate that the dependence of M.A.E. is monotonic (except in nickel) whereas that of B.E. is generally quite complex. Since the microstructural and stress dependences are often interrelated it would be difficult to use the technique to measure say residual stress in a practical material unless the exact condition of the microstructure could be determined. Consequently B.E. and M.A.E. were measured from mild steel specimens (4360 steel) which had recieved a number of different heat treatments. The effects of applied tensile stress on the amplitude and shape of the B.E. and M.A.E. profiles were investigated with a view to be able to use the M.A.E. to measure stresses without prior knowledge of the microstructure. It was found that certain parameters in the signal profile were much more strongly dependent upon the stress than on the microstructure for many of the material conditions. Therefore M.A.E. is potentially useful for residual stress measurements.
|
212 |
SENECA PHONETICS: AN ARTICULATORY AND ACOUSTIC INVESTIGATION (CANADA, NEW YORK).DEAN-JOHN, HAZEL VIRGINIA JIMERSON. January 1983 (has links)
This dissertation is a report on the articulatory and acoustic investigation of Seneca speech as compiled by a native speaker of the Seneca language. The body of the dissertation consists of four chapters. In Chapter 1, earlier analyses of the sound patterns of Seneca are introduced and discussed. Several problematic aspects of Seneca are highlighted and these are discussed in later chapters. Chapter 2 is a subjective analysis of Seneca articulation. The author has discovered that the Seneca language is articulated from a different articulatory base (referred to as the "Seneca neutral position"), than is found in other languages. Of special interest are the vowel combinations as well as the sequences of consonants in syllable initial position such as /kn/ and /kd/ which are produced with a unique order of articulatory gestures. Chapter 3 displays the results of an acoustic study of Seneca speech. The primary instruments employed in this study were a sound spectrograph and a pair of pneumotachometers which were coupled to a specially modified surgical mask so that the air flow in the nasal and oral cavities could be measured independently. Many of the proposals made in the subjective analysis are substantiated by the results of the instrumental analysis. Chapter 4 presents a discussion of the theoretical consequences of this study. In particular, the facts of Seneca articulation suggest the inapplicability of the Chomsky & Halle distinctive features as presented in the book The Sound Pattern of English (1968). The author proposes supplementing the tongue body features high, low, and back with two additional features which specify a degree of mouth opening due to the tongue blade/mandible position. These additional features, [± open], [± close] are necessary to account for the articulation of Seneca.
|
213 |
An experimental investigation of nonlinear behaviour of beams and plates excited to high levels of dynamic responseWolfe, Howard F. January 1995 (has links)
No description available.
|
214 |
Acoustical identification of the characteristics of ocean frontsRadcliffe, Stewart Alexander January 1997 (has links)
No description available.
|
215 |
Digital recording and analysis of noise with particular reference to jet noiseSmith, D. J. January 1986 (has links)
No description available.
|
216 |
Characterisation of bubbles in liquids using acoustic techniquesRamble, David Gary January 1997 (has links)
No description available.
|
217 |
Domain-inverted transducers for acousto-optic devicesLawrow, Alexander January 1998 (has links)
No description available.
|
218 |
Unsteady flow over a rectangular cavityForristal, Richard Michael January 2000 (has links)
No description available.
|
219 |
Modelling of ultrasonic transduction and measurement using finite elementsForsyth, Simon Andrew January 2000 (has links)
No description available.
|
220 |
Geoacoustic characterization of a range-dependent environmentFallat, Mark Ryan. 10 April 2008 (has links)
No description available.
|
Page generated in 0.0596 seconds