Multistage hydraulic fracturing of horizontal wells continues to be a major technological tool in the oil and gas industry. Creation of multiple transverse fractures in shale gas has enabled production from very low permeability. The strategy entails the development of a Stimulated Reservoir Volume (SRV), defined as the volume of reservoir, which is effectively stimulated to increase the well performance. An ideal model for a shale gas SRV is a rectangle of length equal to horizontal well length and width equal to twice the half length of the created hydraulic fractures. This project focused on using the Multistage Transverse Fractured Horizontal Wells (MTFHW) for two novel applications. The first application considers using the SRV of a shale gas well, after the gas production rate drops below the economic limit, for low grade geothermal heat extraction. Cold water is pumped into the fracture network through one horizontal well drilled at the fracture tips. Heat is transferred to the water through the fracture surface. The hot water is then recovered through a second horizontal well drilled at the other end of the fracture network. The basis of this concept is to use the already created stimulated reservoir volume for heat transfer purposes. This technique was applied to the SRV of Haynesville Shale and the results were discussed in light of the economics of the project. For the second application, we considered the use of a similarly created SRV for producing hydrocarbon products from oil shale. Thermal decomposition of kerogen to oil and gas requires heating the oil shale to 700 degrees F. High quality saturated steam generated using a small scale nuclear plant was used for heating the formation to the necessary temperature. Analytical and numerical models are developed for modeling heat transfer in a single fracture unit of MTFHW. These models suggest that successful reuse of Haynesville Shale gas production wells for low grade geothermal heat extraction and the project appears feasible both technically and economically. The economics of the project is greatly aided by eliminating well drilling and completion costs. The models also demonstrate the success of using MTFHW array for heating oil shale using SMR technology.

The demand for high power density keeps driving the development of electromagnetic integration technologies in the field of power electronics. Based on planar homogeneous integrated structures, the mechanism of the electromagnetic integration of passives has been investigated with distributed-parameter models. High order modeling of integrated passives has been developed to investigate the electromagnetic performance. The design algorithm combining electromagnetic design and loss models has been developed to optimize and evaluate the spiral winding structure. High power density of 480 W/in3 has been obtained on the prototype. Due to the structural limitation, the currently applied planar spiral winding structure does not sufficiently utilize the space, and the structure is mechanically vulnerable. The improvement on structures is necessary for further application of integrated passives. The goal of this research is to investigate and evaluate alternative structures for high-power-density integrated passives. The research covers electromagnetic modeling, constructional study, design algorithm, loss modeling, thermal management and implementation technology The symmetric single layer structure and the stacked structure are proposed to overcome the disadvantages of the currently applied planar spiral winding structure. Because of the potential of high power density and low power loss, the stacked structure is selected for further research. The structural characteristics and the processing technologies are addressed. By taking an integrated LLCT module as the study case, the general design algorithm is developed to find out a set of feasible designs. The obtained design maps are used to evaluate the constraints from spatial, materials and processing technologies for the stacked structure. Based on the assumption of one-dimensional magnetic filed on the cross-section and linear current distribution along the longitudinal direction of the stacked structure, the electromagnetic field distribution is analyzed and the loss modeling is made. The experimental method is proposed to measure the loss and to verify the calculation. The power loss in the module leads to thermal issues, which limit the processed power of power electronics modules and thus limit the power density. To further improve the power handling ability of the module, the thermal management is made based on loss estimation. The heat extraction technology is developed to improve the heat removal ability and further improve the power density of integrated passives. The experimental results verify the power density improvement from the proposed stacked structure and the applied heat extraction technology. The power density of 1147 W/in3 (70 W/cm3) is achieved in the implemented LLCT module with the efficiency of 97.8% at output power of 1008W. / Ph. D.