abstract: Water reuse and nutrient recovery are long-standing strategies employed in agricultural systems. This is especially true in dry climates where water is scarce, and soils do not commonly contain the nutrients or organic matter to sustain natural crop growth. Agriculture accounts for approximately 70% of all freshwater withdrawals globally. This essential sector of society therefore plays an important role in ensuring water sources are maintained and that the food system can remain resilient to dwindling water resources. The purpose of this research is to quantify the benefits of organic residuals and reclaimed water use in agriculture in arid environments through the development of a systematic review and case study. Data from the systematic review was extracted to be applied to a case study identifying the viability and benefits of organic residuals on arid agriculture. Results show that the organic residuals investigated do have quantitative benefits to agriculture such as improving soil health, reducing the need for conventional fertilizers, and reducing irrigation needs from freshwater sources. Some studies found reclaimed water sources to be of better quality than local freshwater sources due to environmental factors. Biosolids and manure are the most concentrated of the organic residuals, providing nutrient inputs and enhancing long-term soil health. A conceptual model is presented to demonstrate the quantitative benefits of using a reclaimed water source in Pinal County, Arizona on a hypothetical crop of cotton. A goal of the model is to take implied nutrient inputs from reclaimed water sources and quantify them against standard practice of using irrigated groundwater and conventional fertilizers on agricultural operations. Pinal County is an important case study area where farmers are facing cuts to their water resources amid a prolonged drought in the Colorado River Basin. The model shows that a reclaimed water source would be able to offset all freshwater and conventional fertilizer use, but salinity in reclaimed water sources would force a need for additional irrigation in the form of a large leaching fraction. This review combined with the case study demonstrate the potential for nutrient and water reuse, while highlighting potential barriers to address. / Dissertation/Thesis / Masters Thesis Engineering 2020

abstract: Overall, biofuels play a significant role in future energy sourcing and deserve thorough researching and examining for their best use in achieving sustainable goals. National and state policies are supporting biofuel production as a sustainable option without a holistic view of total impacts. The analysis from this research connects to policies based on life cycle sustainability to identify other environmental impacts beyond those specified in the policy as well as ethical issues that are a concern. A Life cycle assessment (LCA) of switchgrass agriculture indicates it will be challenging to meet U.S. Renewable Fuel Standards with only switchgrass cellulosic ethanol, yet may be used for California's Low Carbon Fuel Standard. Ethical dilemmas in food supply, land conservation, and water use can be connected to biofuel production and will require evaluation as policies are created. The discussions around these ethical dilemmas should be had throughout the process of biofuel production and policy making. Earth system engineering management principles can help start the discussions and allow anthropocentric and biocentric viewpoints to be heard. / Dissertation/Thesis / Masters Thesis Civil and Environmental Engineering 2014

Master of Science / Department of Grain Science and Industry / Dirk E. Maier / Fumigation of stored grain is a common way to kill stored-grain insect pests. However, fumigating in unsealed structures is the leading cause of control failures and subsequent development of insect resistance. Sealing the storage structure is the only practical way to ensure a complete kill of all insects at all life stages. The cost, effort, and feasibility of sealing a U.S. corrugated steel silo during construction was evaluated and compared against an Australian sealed silo designed for fumigation. Gas monitoring and thermosiphon recirculation equipment was installed on both silos. Fumigation efficacy was evaluated using pressure half-life decay times, fumigant concentrations, insect bioassays, and grain quality data. Three fumigations with phosphine (PH₃) pellets or tablets and two with VAPORPH₃OS® cylinderized PH₃ and ProFume® cylinderized sulfuryl fluoride (SF) were performed in each silo for a total of ten experimental treatments. The Australian silo required 266 man-hours to construct and cost $180 for additional sealing, compared to 359 man-hours and $3,284 for constructing and sealing the U.S. silo. The Australian silo had a maximum pressure half-life decay time of 163 s versus 50 s for the U.S. silo. At application rates of 1.5 g/mᶟ of PH₃ both silos maintained an average concentration of approximately 0.28 g/mᶟ for 14 days. With thermosiphon recirculation the average minimum-to-maximum PH₃ concentration ratio in the U.S. silo was 0.52, compared to a ratio of 0.17 when fumigating without thermosiphon recirculation. Greater than 99% adult mortality was observed in all insect bioassays which included PH₃ resistant strains of R. dominica and T. castaneum. The average emergence from fumigated bioassays was 7 adult insects, compared to an average of 383 adults for the non-fumigated controls. Grain stored for 10 months in the sealed silos increased from approximately 11.5% to 17% m.c. in the top 0.3 m of grain, and decreased in test weight from approximately 77 to 65 kg/hL. Although the Australian silo retained higher fumigant concentrations than the U.S. silo, fumigations were successful in both. Long-term storage in sealed silos is a concern because grain quality can deteriorate due to condensation and mold in the top grain layer.

abstract: Microscopic algae have been investigated extensively by researchers for decades for their ability to bioremediate wastewater and flue gas while producing valuable biomass for use as feed, fuel, fertilizer, nutraceutical, and other specialty products. Reports of the exciting commercial potential of this diverse group of organisms started appearing in the literature as early as the 1940’s. However, nearly 80 years later, relatively few successful commercial microalgae installations exist and algae have not yet reached agricultural commodity status. This dissertation examines three major bottlenecks to commercial microalgae production including lack of an efficient and economical cultivation strategy, poor management of volatile waste nutrients, and costly harvesting and post processing strategies. A chapter is devoted to each of these three areas to gain a better understanding of each bottleneck as well as strategies for overcoming them. The first chapter demonstrates the capability of two strains of Scenedesmus acutus to grow in ultra-high-density (>10 g L-1 dry weight biomass) cultures in flat panel photobioreactors for year-round production in the desert Southwest with record volumetric biomass productivity. The advantages and efficiency of high-density cultivation are discussed. The second chapter focuses on uptake and utilization of the volatile components of wastewater: ammonia and carbon dioxide. Scenedesmus acutus was cultured on wastewater from both municipal and agricultural origin and was shown to perform significantly better on flue gas as compared to commercial grade CO2 and just as well on waste nutrients as the commonly used BG-11 laboratory culture media, all while producing up to 50% lipids of the dry weight biomass suitable for use in biodiesel. The third chapter evaluates the feasibility of using gravity sedimentation for the harvesting of the difficult-to-separate Scenedesmus acutus green algae biomass followed by microfluidization to disrupt the cells. Lipid-extracted biomass was then studied as a fertilizer for plants and shown to have similar performance to a commercially available 4-6-6 fertilizer. Based on the work from these three chapters, a summary of modifications are suggested to help current and future microalgae companies be more competitive in the marketplace with traditional agricultural commodities. / Dissertation/Thesis / Doctoral Dissertation Molecular and Cellular Biology 2019

abstract: Breeding seeds to include desirable traits (increased yield, drought/temperature resistance, etc.) is a growing and important method of establishing food security. However, besides breeder intuition, few decision-making tools exist that can provide the breeders with credible evidence to make decisions on which seeds to progress to further stages of development. This thesis attempts to create a chance-constrained knapsack optimization model, which the breeder can use to make better decisions about seed progression and help reduce the levels of risk in their selections. The model’s objective is to select seed varieties out of a larger pool of varieties and maximize the average yield of the “knapsack” based on meeting some risk criteria. Two models are created for different cases. First is the risk reduction model which seeks to reduce the risk of getting a bad yield but still maximize the total yield. The second model considers the possibility of adverse environmental effects and seeks to mitigate the negative effects it could have on the total yield. In practice, breeders can use these models to better quantify uncertainty in selecting seed varieties / Dissertation/Thesis / Masters Thesis Industrial Engineering 2019