Metal matrix composites have seen a rise in demand within the last decade. Aluminum alloy reinforced with silicon carbide particles is a type of particle metal matrix composite that has seen applications in the aerospace, ground transportation, and electronics industry. However, the abrasive SiC particles have made this material difficult to machine through conventional machining strategies. This research will focus on using computer aided manufacturing with trochoidal tool paths to maximize machining productivity and extend the tool life of CVD diamond coated end mills. The focus of this research will be on AlSiCp with a high volume fraction of reinforcement (30%) to expand the potential applications of this pMMC. The cutting experiments are divided into three parts: cutting test, confirmation test, and endurance test. Taguchi method will be used to perform an analysis of variance and signal-to-noise ratio to optimize a combination of material removal rate, average cutting forces, and surface roughness. The optimal cutting conditions were found to be 254 mm/min, 30°, and 9500 r/min for MRR+AvgFxy+Ra, 1524 mm/min, 30°, and 9500 r/min for MRR+AvgFxy, and 1524 mm/min, 90°, and 9500 r/min. The cutting conditions for MRR+AvgFx+Ra was not considered for the endurance tests as the machining productivity was too low to be considered a feasible option in the industry. It was concluded that trochoidal milling under wet cutting conditions produced nearly half the tool wear as previous research with conventional milling strategies. However, the longer the CVD diamond coated end mills were engaged in the AlSiCp workpiece, the more dominant the abrasive wear mechanisms appear and cause tool damage. It was concluded that square end mills may not be suitable for machining AlSiCp and that future research should focus on varying the tool geometry or utilizing ball end mills.

Particle-reinforced MMCs (pMMC) such as aluminum alloys reinforced with ceramic silicon carbide particles (AlSiC) require special cutting tools due to the high hardness and abrasive properties of the ceramic particles. Diamond coated cutting tools are ideal for machining this type of pMMC. Previous research studies focus on the machinability of pMMCs with low ceramic content. The aim of this research is to determine the optimal cutting parameters for machining AlSiC material containing high silicon carbide particle reinforcement (>25%). The optimal cutting parameters are determined by investigating the relationship between cutting forces, tool wear, burr formation, surface roughness, and material removal rate (MRR). Experimental milling tests are conducted using CVD diamond coated end mills and non-diamond tungsten carbide end mills. It was found that low tool rotation speeds, feed rates and depths of cut are necessary to achieve smoother surface finishes of R a < 1 μm. A high MRR to low tool wear and surface roughness ratio was obtainable at a tool rotation speed of 6500 r/min, feed rate of 762 mm/min and depth of cut of 3 mm. Results showed that a smooth surface roughness of the workpiece material was achieved with non-diamond tungsten carbide end mills, however, this was at the expense of extreme tool wear and high burr formation. The use of coolant caused a 50% increase in tool wear compared to the dry-cutting experiments which had lower cutting tool forces.