Thesis (Ph. D.)--Ohio State University, 2003 / Title from first page of pdf. Document formatted into pages; contains xvii, 116 p.; also contains graphics (some col.). Includes bibliographical references (p. 11-3116). Available online via OhioLINK's ETD Center.

Thesis (doctoral)--Königliche Technische zu Berlin, 1905. / eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references (p. [103]-104).

Thesis (Ph. D.)--University of Hong Kong, 1990.

No description available.

No description available.

No description available.

International Telemetering Conference Proceedings / October 28-31, 1996 / Town and Country Hotel and Convention Center, San Diego, California / The monitoring of multi phase 400 Hz aircraft power includes monitoring the phase voltages, currents, real powers, and frequency. This paper describes the design of a multi channel card that uses digital signal processing (DSP) to measure these parameters on a cycle by cycle basis. The card measures the average, peak, minimum cycle, and maximum cycle values of these parameters.

This research focused on chlorine-free disinfection of wastewater by complying with today's regulations. The equipment used was a continuous flow electrochemical reactor connected to an alternating current (AC) power supply. The electrodes used were made out of titanium coated with iridium oxide. To determine the inactivation of Escherichia Coli, a bacterial count method based on the USEPA method 1603 was used. After several experiments it was determined that electrochemical disinfection using AC was not efficient and economic enough to be classified as a viable alternative to chlorine disinfection. It was demonstrated that chlorine can be produced by electrolysis using AC and that no hydrogen could be noticed as a byproduct of the electrolysis of wastewater. When the results from this investigation were compared to the ones obtained using DC in Acosta (2014), it was determined that the belief that AC and DC are equally efficient at disinfecting wastewater is wrong.

"October 2002" / Bibliography: p. 219-228. / xi, 229 p. : ill. (some col.), plates (col.) ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / Proposes a robust indirect position sensing technique implemented in real time using a DSP based motor controller. This is based on a rotor position estimation using the measured phase voltages and currents of the motor. An incremental algorithm is used to estimate the flux linkage increments, which eliminates the integration involved in the flux linkage estimation. This feature provides a wider operating speed range and robustness. / Thesis (Ph.D.)--University of Adelaide, Dept. of Electrical and Electronic Engineering, 2002

The Motor Systems Resource Facility (MSRF) at Oregon State University presently conducts a variety of steady state tests on Motors and Generators, with ratings of upto 300Hp.(225kW), using a dynamometer. The dynamometer consists of an induction motor fed by a power electronic converter. A control computer uses a serial link, to send the desired steady state values of speed or torque to the converter. The objective of the work of this thesis was the conversion of the existing control interface, to one that could support programmable dynamic operation. Some of the capabilities that the resulting system has acquired, include the ability to simulate a general, predefined torque or speed profile, from a generalised polynomial function, a sine wave of torque or speed added to a constant offset, and a general purpose mode which allows the user to specify an atypical profile. The conversion to dynamic operation, permits the study and laboratory simulation of dynamic effects like the Sub-Synchronous Resonance phenomenon observed in turbine- generator sets attached to the power grid, the effect of "tower shadow" on wind power generation, time-varying load profiles, testing of machines under real world operating situations etc. Several tests were performed to ensure that the actual speed/torque profiles obtained from the machine, corresponded to the reference profiles specified in each case. Measured performance of specific examples is given. / Graduation date: 1999