Spelling suggestions: "subject:"aluminum oxide."" "subject:"fluminum oxide.""
1 |
Grain bridging in alumina : room and high temperature /Kokaly, Matthew T. January 2001 (has links)
Thesis (Ph. D.)--University of Washington, 2001. / Vita. Includes bibliographical references (leaves 107-118).
|
2 |
Dehydrations over various aluminasWatkins, Spencer Hunt, January 1950 (has links)
Thesis (Ph. D.)--University of Wisconsin--Madison, 1950. / Typescript. Vita. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references (leaves 53-54).
|
3 |
Some properties of aluminum oxide in electrolytic solutionsUrquhart, Helen Mary Ann January 1949 (has links)
By anodic oxidation, an aluminum plate can be covered with an amorphous or crystalline oxide layer, depending on the electrolyte used. The amorphous layer, obtained in a solution of oxalic or sulphuric acid, has a porous structure. However, the pores do not go right down to the aluminum as has been shown by many investigators, but end in a solic insulating layer, the thickness of which may be determined by capacity measurements.
Corresponding to a given temperature and solic concentration of the electrolytic solution and a given formation current density, there is only one final capacity obtainable. Increasing the concentration, or temperature, or decreasing the current density, increases the final capacity obtainable. / Science, Faculty of / Physics and Astronomy, Department of / Graduate
|
4 |
Carbothermic reduction of alumina into a metallic solvent phaseCaizergues, Derek January 1998 (has links)
A dissertation submitted to the Faculty of Engineering, University of the
Witwatersrand, Johannesburg, in fulfillment of the requirements for the degree of
Master of Science in Engineering. Johannesburg, 1998. / Experiments have been conducted at around 17000C to determine the whether
carbothermic reduction of alumina is possible at these temperatures. Total pressure
of the system was reduced to around 30 kPa and various metallic solvents such as
copper, nickel, iron and tin were used to dissolve the metallic aluminium
produced. The use of a solvent (and hence decreasing the activity of metallic
aluminium) and a lower pressure are thermodynamic requirements to increase the
extent of reduction under a given set of conditions. This enables the use of lower
temperatures than are required under atmospheric conditions.
The highest recovery of aluminium was achieved with the nickel solvent
decreasing in order from iron, copper and tin. This ranking was also in accord with
the extent of deviation from ideality in the respective binary solutions of these
solvents with aluminiur, The nickel-aluminium system displays the largest
negative deviation from ideality whereas the till, aluminium system showed a
positive deviation.
The rate and extent of the reduction was found to be highly dependent on
temperature and pressure. The pseudo first order reaction rate was found to be the
primary order for the reduction of aluminium in all the solvents used. It is also
suggested that the reduction rate was controlled primarily by chemical reaction
rate father than by transport processes. This is due to the extreme sensitivity of the
rate and extent of the reaction to temperature. / AC2017
|
5 |
Microstructure evolution and densification of alumina in liquid phase sintering /Dong, Weimin, January 2000 (has links)
Thesis (Ph. D.)--Lehigh University, 2000. / Includes vita. Includes bibliographical references (leaves 158-168).
|
6 |
Hertzian contact behavior of alumina based trilayer composites /Ha, Hyoung-Chan, January 2000 (has links)
Thesis (Ph. D.)--Lehigh University, 2000. / Includes vita. Includes bibliographical references (leaves 155-166).
|
7 |
The volumetric determination of alumina in clays and related materialsBoltz, David F. January 1940 (has links) (PDF)
Thesis (M.S.)--University of Missouri, School of Mines and Metallurgy, 1940. / The entire thesis text is included in file. Typescript. Title from title screen of thesis/dissertation PDF file (viewed March 17, 2010) Includes bibliographical references (p. 32-33) and index (leaf 34).
|
8 |
A STUDY OF THE ELECTRICAL CONDUCTIVITY OF ALUMINA AT HIGH TEMPERATURES AND IN A RADIATION FIELDHaidler, William Bernard, 1926- January 1964 (has links)
No description available.
|
9 |
Helium diffusion rate, permeation rate, and activation energy for polycrystalline aluminaHurst, James Joseph January 1961 (has links)
No description available.
|
10 |
Monolithic structures formed from alumina hollow microspheresMunné, Vicente January 1988 (has links)
No description available.
|
Page generated in 0.0525 seconds