Thesis (M. Hous. M.)--University of Hong Kong, 1997. / Includes bibliographical references.

Thesis (M.Arch.) - Carleton University, 2007. / Includes bibliographical references (p. 80-81). Also available in electronic format on the Internet.

Thesis (M.Hous.M.)--University of Hong Kong, 1997. / Includes bibliographical references. Also available in print.

Thesis (M.L.A.)--University of Hong Kong, 1997. / Includes special study report entitled : Towards the exploration of spatial MAXIMUM from the minimum. Includes bibliographical references. Also available in print.

Kung Yick Ho, Alvin. / "Architecture Department, Chinese University of Hong Kong, Master of Architecture Programme 2009-2010, design report." / "May 2010." / Includes bibliographical references.

No description available.

No description available.

by David Luke Cronin. / Thesis (M.Phil.)--Chinese University of Hong Kong, 1996. / Includes bibliographical references (leaves 148-156). / Investigation into The Dynamics of Waste Air Dispersal from High-Rise Residences --- p.i / Acknowledgements --- p.ii / Abstract --- p.iii / Contents --- p.iv / List of Illustrations --- p.viii / Preface / Chapter 1. --- INTRODUCTION --- p.1 / Chapter 1.1. --- The Development of Building Technology in Response to the Forces of Wind and Water --- p.2 / Chapter 1.1.1. --- Roman concrete --- p.3 / Chapter 1.1.2. --- Requirement for a stronger mortar --- p.5 / Chapter 1.1.3. --- Discovery of an improved mortar --- p.5 / Chapter 1.2. --- Development of Wind Engineering --- p.7 / Chapter 1.3. --- Computational Wind Engineering --- p.10 / Chapter 1.4. --- Development of Building Regulations concerning Ventilation and Light in Hong Kong --- p.14 / Chapter 1.4.1. --- First building regulations --- p.15 / Chapter 1.4.2. --- Chadwick's enquiry --- p.17 / Chapter 1.4.3. --- First requirement for windows in rooms --- p.18 / Chapter 1.4.4. --- Public Health Ordinance --- p.19 / Chapter 1.4.5. --- Building Ordinance --- p.20 / Chapter 1.4.6. --- Plot ratio regulations and natural ventilation --- p.22 / Chapter 1.5. --- Plot Ratio and Site Coverage --- p.23 / Chapter 1.5.1. --- Gross Floor Area (GFA) --- p.24 / Chapter 1.5.2. --- Cruciform tower --- p.27 / Chapter 1.5.3. --- Re-entrant --- p.30 / Chapter 1.6. --- Summary --- p.35 / Chapter 2. --- VENTILATION OF RESIDENTIAL DWELLINGS AND THE REMOVAL OF AIRBORNE WASTES --- p.37 / Chapter 2.1. --- High-rise Buildings in Hong Kong and Ventilation --- p.37 / Chapter 2.2. --- "Climatic Conditions in Hong Kong, and the Requirement for Air-conditioning" --- p.38 / Chapter 2.3. --- Typical Practice in Hong Kong High-rises --- p.40 / Chapter 2.4. --- Source Ventilation --- p.42 / Chapter 2.5. --- Traditional Recommendations for a Tropical Climate --- p.42 / Chapter 2.6. --- Building Regulations Concerning Ventilation of Residences --- p.43 / Chapter 2.6.1. --- Hong Kong Government building regulations --- p.43 / Chapter 2.6.2. --- UK building regulations --- p.44 / Chapter 2.6.3. --- US building regulations --- p.46 / Chapter 2.7. --- Summary --- p.47 / Chapter 3. --- MODELLING OF WIND FLOW AROUND BUILDINGS --- p.48 / Chapter 3.1. --- Summary of CFD Methods for Air Flow around Buildings --- p.48 / Chapter 3.1.1. --- Validation of the k-ε model for wind pressures on buildings --- p.50 / Chapter 3.2. --- Atmospheric Boundary Layer --- p.50 / Chapter 3.3. --- Use of Wind Tunnels to Predict Wind Effects on Tall Buildings --- p.52 / Chapter 3.3.1. --- Local wind climate --- p.53 / Chapter 3.3.2. --- Pressure study --- p.53 / Chapter 3.3.3. --- Aeroelastic study --- p.54 / Chapter 3.3.4. --- Wind environment study --- p.54 / Chapter 3.4. --- Architectural Aerodynamics --- p.54 / Chapter 3.4.1. --- Reynolds number --- p.55 / Chapter 3.4.2. --- Pressure coefficient --- p.56 / Chapter 4. --- PREDICTION OF OUTDOOR POLLUTION AND AIR QUALITY --- p.57 / Chapter 4.1. --- Computer Modelling of Pollution Dispersion --- p.57 / Chapter 4.2. --- Exhaust Dispersion from Buildings - Distance Dilution Model --- p.59 / Chapter 4.2.1. --- Wall exhaust discharges in residential ventilation --- p.59 / Chapter 4.2.2. --- Acceptable levels of kitchen exhaust in the outside air --- p.62 / Chapter 4.2.3. --- Distance dilution model with corrections for building size --- p.62 / Chapter 4.3. --- Gaussian Plume Model --- p.63 / Chapter 4.4. --- Wind Tunnel Models of Pollution Dispersion in a Built-up Area --- p.65 / Chapter 5. --- INDOOR AIR QUALITY - COOKING FUMES --- p.67 / Chapter 5.1. --- Local Exhaust Ventilation and Efficiency of Pollutant Capture --- p.67 / Chapter 5.2. --- Indoor Pollution due to Cooking Stove Smoke --- p.68 / Chapter 5.3. --- Cooking Oil Detected in Hong Kong Air --- p.69 / Chapter 6. --- THEORETICAL BACKGROUND: RELEVANT ASPECTS OF CFD USED IN THIS STUDY --- p.71 / Chapter 6.1. --- Mathematical Model --- p.71 / Chapter 6.2. --- Reynolds Averaged Navier Stokes Equations --- p.71 / Chapter 6.3. --- SIMPLE method --- p.74 / Chapter 6.4. --- Wall Shear Stress Calculations --- p.75 / Chapter 6.5. --- Wall Boundary Conditions for k and ε --- p.77 / Chapter 6.6. --- Species Calculations --- p.77 / Chapter 6.7. --- Thermal Transfer --- p.78 / Chapter 6.8. --- Grid System and Boundary Conditions --- p.81 / Chapter 6.8.1. --- Geometry and grid --- p.81 / Chapter 6.8.2. --- Boundary conditions --- p.85 / Chapter 6.9. --- Natural Convection Flows --- p.85 / Chapter 7. --- MODELLING PROCEDURE --- p.87 / Chapter 7.1. --- Dispersal of Exhaust Air from Kitchens --- p.87 / Chapter 7.1.1. --- Kitchen range hood exhaust rates --- p.87 / Chapter 7.1.2. --- Exhaust air release rates modelled --- p.88 / Chapter 7.1.3. --- Initial approximation of dilution in the re-entrant --- p.89 / Chapter 7.2. --- Modelling of Waste Heat Dispersal from Air-conditioning Units --- p.90 / Chapter 7.2.1. --- Typical air-conditioner energy figures --- p.90 / Chapter 7.2.2. --- Representation of condenser heat in a CFD model --- p.92 / Chapter 7.2.3. --- Approximation of temperature increase --- p.94 / Chapter 7.3. --- Representation of the High-rise Tower --- p.94 / Chapter 7.4. --- Power-law Profile: Increasing Wind Speed with Height --- p.95 / Chapter 7.5. --- Wind Tunnel Verification --- p.97 / Chapter 7.5.1. --- Wind velocities and pressures --- p.97 / Chapter 7.5.2. --- Wind tunnel prediction of contaminant dilution --- p.98 / Chapter 7.6. --- Summary of Simulations --- p.99 / Chapter 7.6.1. --- Kitchen exhaust air dispersal --- p.100 / Chapter 7.6.2. --- Air-conditioner waste heat dispersal --- p.100 / Chapter 8. --- DISCUSSION OF RESULTS --- p.102 / Chapter 8.1. --- Wind Patterns in the Re-entrant --- p.103 / Chapter 8.1.1. --- Wind into re-entrant --- p.104 / Chapter 8.1.2. --- Wind at 90° to the re-entrant --- p.104 / Chapter 8.1.3. --- Re-entrant on the leeward side of the building --- p.105 / Chapter 8.2. --- Exhaust Air Concentration --- p.112 / Chapter 8.2.1. --- Wind into re-entrant --- p.113 / Chapter 8.2.2. --- Wind at 90° to the re-entrant --- p.113 / Chapter 8.2.3. --- Re-entrant on the leeward side --- p.114 / Chapter 8.3. --- Temperature Increase in the Re-entrant --- p.121 / Chapter 8.3.1. --- Wind into the re-entrant --- p.122 / Chapter 8.3.2. --- Wind at 90° to the re-entrant --- p.123 / Chapter 8.3.3. --- Re-entrant on leeward side --- p.123 / Chapter 8.4. --- Summary of Findings --- p.130 / Chapter 9. --- NATURAL CONVECTION MODELLING --- p.132 / Chapter 10. --- CONCLUSIONS --- p.136 / Chapter 10.1. --- Waste Air --- p.136 / Chapter 10.2. --- Waste Heat --- p.138 / Chapter 10.3. --- Implications --- p.139 / Chapter 10.4. --- Suggestions --- p.140 / APPENDIX A: SIMULATION CASE DEFINITIONS / Chapter A.1 --- Definitions used for all simulations --- p.142 / Chapter A.1.1 --- Boundary Conditions used in all simulations --- p.145 / Chapter A. 1.2 --- Equations used in all simulations --- p.145 / Chapter A.2 --- Simulation of Wind Flow around the Building --- p.145 / Chapter A.3 --- Air-conditioner Waste Heat Dispersal Simulations --- p.146 / Chapter A.1.1 --- Additional boundary conditions used to represent air-conditioners --- p.146 / Chapter A. 1.2 --- Additional equations used --- p.146 / Chapter A.4 --- Exhaust Air Dispersal from Kitchens --- p.147 / Chapter A.1.1 --- Additional boundary conditions used to represent air-conditioners --- p.147 / Chapter A. 1.2 --- Additional equations used --- p.147 / BIBLIOGRAPHY --- p.149 / Books --- p.148 / Papers --- p.149 / Other Sources --- p.152 / Notes --- p.153

This thesis aims to investigate the relationship between the provision of spatial order and perceived sense of community in high-rise housing developments in Korea from a socio-spatial and architectural perspective. It also considers relationships between the perception of neighbourhood, provision of facilities, design aspects, and socio-economic characteristics and sense of community. The study uses a questionnaire survey as the main research instrument conducted across four case studies in Bundang new town, in metropolitan Seoul, Korea. Two of the cases were selected as having a high provision of spatial order and the other two low provision according to the concepts of Altman (1975) and Newman (1972, 1975). Quantitative analysis is carried out using the Kruskal-Wallis/Mann-Whitney test and Spearman???s rank correlation to identify differences and correlations between cases. The results indicate that there is no clear evidence that a sense of community has a direct relationship with the provision of spatial order in the selected cases. However, in the high provision cases outdoor common spaces appear to have a role in contributing to social interaction. Among Buckner???s (1988) three sub-variables of his concept of neighbourhood cohesion, ???neighbouring??? appears to be more associated with the provision of spatial order rather than ???attraction-to-neighbourhood??? or ???psychological sense of community.??? A greater number of opportunities for social interactions occur in an intermediate space located between private dwelling units and public open space in cases with a high provision of spatial order. However, this is likely to be due to the location of shared facilities and their frequency of use. In terms of the relationship between design and a sense of community, ???landscaping??? was found to be the most important variable, followed by the ???design of streets/footpath??? and ???facilities for children???, ???parking???, and ???recreational activities???. Despite the lack of a clear relationship between design and a sense of community, a strong demand was found for improved outdoor amenity and greater provision of facilities. Socio-economic status appears not to be a significant factor directly influencing the sense of community however, age and the existence of children are associated with the perception of neighbourhood.

Thesis (M. Phil.)--University of Hong Kong, 2009. / Includes bibliographical references (leaves 118-122). Also available in print.