Active docking in modular robotic systems has received a lot of interest recently as it allows small versatile robotic systems to coalesce and achieve the structural benefits of larger robotic systems. This feature enables reconfigurable modular robotic systems to bridge the gap between small agile systems and larger robotic systems. The proposed self-reconfigurable mobile robot design exhibits dual mobility using a tracked drive for longitudinal locomotion and wheeled drive for lateral locomotion. The two degrees of freedom (DOF) docking interface referred to as GHEFT (Genderless, High strength, Efficient, Fail-Safe, high misalignment Tolerant) allows for an efficient docking while tolerating misalignments in 6-DOF. In addition, motion along the vertical axis is also achieved via an additional translational DOF, allowing for toggling between tracked and wheeled locomotion modes by lowering and raising the wheeled assembly. This thesis also presents a visual-based onboard Hybrid Target Tracking algorithm to detect and follow a target robot leading to autonomous docking between the modules. As a result of this proposed approach, the tracked features are then used to bring the robots in sufficient proximity for the docking procedure using Image Based Visual Servoing (IBVS) control. Experimental results to validate the robustness of the proposed tracking method, as well as the reliability of the autonomous docking procedure, are also presented in this thesis. / Master of Science / Active docking in modular robotic systems has received a lot of interest recently as it allows small versatile robotic systems to coalesce and achieve the structural benefits of larger robotic systems. This feature enables reconfigurable modular robotic systems to bridge the gap between small agile systems and larger robotic systems. Such robots can prove useful in environments that are either too dangerous or inaccessible to humans. Therefore, in this research, several specific hardware and software development aspects related to self-reconfigurable mobile robots are proposed. In terms of hardware development, a robotic module was designed that is symmetrically invertible and exhibits dual mobility using a tracked drive for longitudinal locomotion and wheeled drive for lateral locomotion. Such interchangeable mobility is important when the robot operates in a constrained workspace. The mobile robot also has integrated two degrees of freedom (DOF) docking mechanisms referred to as GHEFT (Genderless, High strength, Efficient, Fail-Safe, high misalignment Tolerant). The docking interface allows for an efficient docking while tolerating misalignments in 6-DOF. In addition, motion along the vertical axis is also performed via an additional translational DOF, allowing for lowering and raising the wheeled assembly. The robot is equipped with sensors to provide positional feedback of the joints relative to the target robot. In terms of software development, a visual-based onboard Hybrid Target Tracking algorithm for high-speed consistent tracking iv of colored targets is also presented in this work. The proposed technique is used to detect and follow a colored target attached to the target robot leading to autonomous docking between the modules using Image Based Visual Servoing (IBVS). Experimental results to validate the robustness of the proposed tracking approach, as well as the reliability of the autonomous docking procedure, are also presented in the thesis. The thesis is concluded with discussions about future research in both structured and unstructured terrains.

The aim of this diploma thesis is design of docking station for an autonomous mobile robot Breach. The task of docking station is to connect this robotic device to power supply without human intervention in order to charge its batteries. The theoretical part of diploma thesis contains research study about autonomous charging of robots. After that it is assessed suitability of using different types of docking stations and it was chosen optimal solution. The practice part of diploma thesis contains design of docking mechanism, which takes account of inaccurate navigation of robot with deviation of several centimeters. One part of this design deals with connector system, which is dimensioned for long-term transmission of electric current with minimal value of 20 A. At the end of diploma thesis there was created 3D model of the complete docking station including connectors for charging in program called SolidWorks.