Utilization of woody biomass for energy is expected to increase rapidly and logging residues are a likely feedstock to meet increased demands. Potentials for increased biomass utilization have created concerns regarding possible impacts of using logging residues for energy. The overall goals of this project were to characterize biomass harvesting operations and to evaluate potential impacts on soil erosion and implementation of Best Management Practices (BMPs) for water quality on biomass harvesting sites. Results indicate that biomass harvesting was integrated into a wide range of logging businesses. Existing biomass harvesting businesses reported total production levels ranging from 6 to 250 loads per week. The majority (98%) of biomass harvesting operations utilized integrated harvesting techniques where roundwood and fuel chips were produced concurrently. Potential erosion rates and BMP implementation scores were evaluated on ten biomass and ten conventional harvest sites in the Piedmont of Virginia. This study of 20 sites found no significant differences in overall estimated erosion rates between biomass harvests (0.7 tons ac-1 yr-1) and conventional harvests (0.8 tons ac-1 yr-1) (p=0.8282). Additionally, there were no significant differences observed in overall BMP implementation scores for biomass (85.2%) and conventional (81.3%) harvests (p=0.5930). A separate, but related study evaluated BMP implementation over a three year period on 88 biomass and 284 conventional harvests in the Piedmont of Virginia. Within the seven logging related BMP categories, only the Streamside Management Zones (SMZs) category had significant differences between biomass (83.1%) and conventional harvests (91.4%) (p=0.0010). Implementation score differences were not caused by insufficient residues for stabilization of bare soil but were apparently the result of operational decisions which resulted in lower implementation of BMPs related to SMZs. Overall, these findings indicate that existing BMPs appear adequate to protect water quality on biomass harvesting operations in the Virginia Piedmont when appropriately implemented. / Ph. D.

The passage of the Federal Water Pollution Control Act of 1972 required states to develop forestry BMPs to help reduce potential nonpoint source pollution from forest operations. Properly applied forestry best management practices (BMPs) have since been proven to protect water quality from forest operations. This research project reviewed BMP effectiveness studies in the U.S., assessed current state developed and implemented of forestry BMPs, and developed a simple method to estimate potential erosion from forest operations for the Piedmont physiographic region based on previous studies. Eighty-one BMP effectiveness studies were reviewed. The review of past effectiveness studies indicates that water quality protection is increased when BMPs are implemented correctly. These effectiveness studies provide states with valuable information on how their BMP guidelines are achieving the goals defined by the Federal Water Pollution Control Act. Every U.S. state has forestry BMP guidelines. These guidelines may be non-regulatory, quasi-regulatory, or regulatory depending on the state. Twenty states reported implementing non-regulatory BMP guidelines, 19 quasi-regulatory BMP guidelines, and 11 regulatory BMP guidelines. State forestry agencies were reported as being the lead agency responsible for BMP monitoring in 35 states. The national forestry BMP implementation rate was 91% (32 states). However, states did report deficiencies for specific BMP guideline categories. Supplementary to the reviewed BMP effectiveness studies, forest erosion studies in the southeastern U.S. that quantified erosion rates from forest operations were also reviewed. Erosion rates obtained from the literature were reviewed by operation categories (timber harvesting, forest roads, skid trails, log landings, stream crossings, and streamside management zones) and physiographic region (Mountains, Piedmont, Gulf Coastal Plain, and Atlantic Coastal Plain). There were numerous research gaps regarding erosion rates from forest operations for all the regions except the Piedmont region. The Piedmont region was selected for developing a method to estimate potential erosion from forest operations. This erosion estimation method is a quick and potentially useful tool for estimating potential erosion; however, it is based on limited data from the Piedmont region only. The basic method approach might be considered for the other physiographic regions, but further research is needed to fill current knowledge gaps. / Ph. D.

Forestry Best Management Practices (BMPs) include guidelines, recommendations, and protocols utilized to protect forest water quality from nonpoint source pollutants (NPSP). Sediment is the most common NPSP associated with forest operations, and BMPs are implemented primarily to reduce erosion and potential sediment delivery to streams. Skid trails, stream crossings, forest roads, decks, and harvest areas are major forest operational features that have the potential to erode and deliver sediment to streams. These five features are also common BMP categories evaluated by states across the southeastern U.S. Although BMPs are designed to minimize erosion and sediment delivery, the exact relationship between BMP implementation rates, erosion rates, and potential sediment delivery is largely unexamined. Specifically, the inherently intuitive but unverified concept that increasing levels of BMP implementation decreases erosion and sediment delivery associated with forest harvesting. This hypothesis was tested in this project at five operational features located within three physiographic regions, including the Mountains, Piedmont, and Coastal Plain, across clearcut harvest sites in the southeastern U.S. First, BMP implementation rates, audit questionnaires, and state guidelines were compared across 13 states in the southeastern region at 116 clearcut harvest sites. Overall, BMPs were implemented at an average rate of 90.1% in the southeastern United States, thus demonstrating that BMPs are currently being implemented consistently at high levels throughout the region. Across all regions, average BMP implementation rates were highest at harvest areas (95.6%), followed by decks (92.7%), haul roads (91.9%), stream crossings (88.2%), and skid trails (82.9%). Average BMP implementation rates for Mountain stream crossings (83.9%) and skid trails (76.1%) were significantly lower than rates calculated in the Piedmont and Coastal Plain, and had the lowest implementation rate for any feature in any region. These findings indicate that skid trails and stream crossings, especially in the Mountains, may benefit the most from enhanced BMP implementation and resources. In the second manuscript, the relationship between BMP implementation, estimated erosion, and potential sediment delivery were examined in three regions of Virginia and North Carolina. This study is one of the only forestry studies that have presented sediment delivery ratios by operational feature and physiographic region. BMP implementation rates and sediment delivery ratios were poorly correlated, however, a significant inverse relationship existed between BMP implementation and the total sediment mass delivered to streams (Spearman ρ = -0.2206, p-value = 0.0027). Generally, as BMP implementation increased, erosion rates and the amount of sediment delivered to streams also decreased. Additionally, this study demonstrated that most of the erosion generated by clearcutting operations in the southeast is trapped in either the harvest area or in Streamside Management Zones (SMZs) prior to reaching the stream. In the third manuscript, BMP implementation rates and erosion estimates were categorized into three BMP levels (BMP−, BMP-standard, BMP+) which represent low, moderate, and high levels of BMP implementation, respectively. Skid trails and haul roads generally had the highest erosion estimates, regardless of BMP level and physiographic region. Non-parametric correlation analyses indicated that significant inverse relationships existed between BMP implementation rates and erosion estimates at skid trails (Spearman ρ = -0.589, p-value < 0.0001), haul roads (Spearman ρ = -0.388, p-value < 0.0001), and harvest areas (Spearman ρ = -0.2305, p-value = 0.0169), while decks and stream crossings were more poorly correlated with erosion estimates. This reinforces the need for BMP audit questions that specifically address ground cover and bare soil, water control structures, gradients, and stabilization to better address potential erosion and sedimentation. Clearcut areas, erosion and sediment estimates, and sediment removal efficiencies were presented for the Mountains, Middle/Lower Coastal Plain, and Piedmont/Upper Coastal Plain for the fourth, fifth, and sixth manuscripts, respectively. Regardless of BMP level and physiographic region, a combination of harvest areas, skid trails, and haul roads were responsible for over 95% of potential sediment delivery. Increasing site-wide BMP implementation from BMP− to BMP+ could reduce sediment delivery by 70% in all physiographic regions. High levels of BMP implementation were most effective at reducing potential erosion and sediment delivery from skid trails and haul roads throughout the southeast. Findings from these studies demonstrate that current BMPs are highly effective at mitigating sediment. In the southeastern U.S., increasing levels of BMP implementation effectively reduce both potential erosion and sedimentation associated with forest harvesting. Generally, both estimated erosion and sedimentation associated with clearcutting in the region is much lower than rates associated with other land uses such as development or agriculture, especially when BMPs are implemented at standard or high levels. However, several opportunities exist to improve the effectiveness of BMPs in the southeastern U.S. Skid trails, haul roads, and stream crossings consistently had the lowest BMP implementation rates and highest estimated erosion rates and sediment delivery ratios. While these features only represent a small proportion of total clearcut area in the southeast, they are responsible for a disproportionate amount of sediment delivery and should receive more attention and resources during the pre-harvest planning and closure processes. Conclusively, this project addresses several knowledge gaps pertaining to water quality impacts resulting from harvesting operations in the southeastern U.S. For instance, this is only the third project that has presented sediment delivery ratios associated with forest operations in the southeastern U.S., and the first to do so for the Mountains and Coastal Plain regions. On average, SMZs and harvest areas trap 66-96% of sediment on-site before it can be deposited into streams. Additionally, this project provides one of the first and most comprehensive regional comparisons of state BMP manuals, audits, and programs in-field using a third-party approach. Several significant differences existed among state BMP programs and protocol, and states may need to design specific BMP guidelines and audit protocol for major physiographic regions to address the challenges and variation of on-site conditions inherent of each region. Additionally, this project presents one of the only regional-scale estimates of sediment and efficiencies of increased levels of BMP implementation at mitigating sediment associated with forest operations in the southeastern U.S. Conclusively, this project provides forest managers, state and federal agencies, and policymakers with a robust assessment on the effectiveness of forestry BMPs in the southeast. / Doctor of Philosophy / Forestry Best Management Practices (BMPs) are used throughout the southeastern U.S. to minimize the impacts that harvesting has on soil and water resources. Eroded soil that is eventually deposited into streams as sediment is the most important pollutant that BMPs address in forestry. Common BMP guidelines utilized to minimize sediment include leaving riparian buffers along streams, providing ground cover, minimizing slopes on roads, and using water control structures to divert runoff from road systems. The exact relationship between forestry BMPs, erosion, and sediment delivery is largely unexamined. Objectively, this study was designed to provide a better understanding of this relationship, and to present estimates of erosion and sediment delivery resulting from clearcut harvesting on over 100 harvest sites across 13 states with diverse conditions and topography in the southeastern U.S. Forestry BMPs are being implemented at an average rate of 90.1% across the southeast. BMPs are implemented at higher rates in the Coastal Plain, followed by the Piedmont and Mountains. Generally, harvest areas had the highest BMP implementation rates, followed by decks, haul roads, stream crossings, and skid trails, respectively. This relationship was consistent across most regions and states. Logging decks, which are areas where wood was transported for processing and loading onto logging trucks, were generally located distantly from streams and followed most state-approved BMPs. Whereas skid trails, which are low-standard temporary roads trafficked during primary transport and require water diversion structures such as waterbars, occupied a much larger area and were generally located on much steeper slopes. Mountain skid trails leading to stream crossings are concerning because of their low BMP implementation rates and high erosion potential. These features would greatly benefit from increased ground cover and water control structures. Forestry BMPs reduce both erosion and sedimentation associated with clearcutting. The highest level of BMP implementation reduces potential sediment by over 70% in all regions, and the highest BMP level is most effective at reducing sediment from skid trails and forest roads. Average sedimentation rates, especially at the highest BMP level, calculated for Mountains, Piedmont, and Coastal Plain clearcuts are considerably lower than sedimentation rates associated with agricultural and developmental land uses. Clearcut forestland, which is generally the most erodible time period during a forest's cycle, only makes up 1-2% of total forestland in the southeast annually. Both erosion and sedimentation rates should decrease further in the years following harvesting as the site revegetates and trees begin to reestablish. This study verifies that BMPs are highly effective at reducing erosion and sediment while subsequently providing estimates of erosion and sediment delivery based on ranges of BMP implementation that state forestry agencies can use to better quantify the effectiveness of their BMPs.